Check a VIN

2019 GMC Yukon: check engine light

13 of the 57 complaints about the 2019 GMC Yukon describe check engine light.

owner complaints
13
of this car's complaints
23%
recalls
0
Is there a fix? 163 service bulletins cover this area of the car. See below

Check engine light by model year

What owners say

Filed Nov 2, 2026 · Engine, Fuel system · GA

During normal acceleration on the interstate entrance ramp, the vehicle stuttered and continued on seemingly without issue. Within a few minutes, I noticed the check engine light flashing and fluctuating oil pressure, and I drove cautiously to the closest mechanic shop a few miles away. The code (P0307) indicated a cylinder 7 misfire, and I was referred to the dealership for further diagnostics. The dealership determined the lifters failed resulting in damage to the camshaft, which they reported is a very common problem with the 5.3 L engine. The repairs were quoted in excess of $11,900. This sudden failure at highway speeds poses a safety risk to the motoring public. Furthermore, the consumer should not foot the bill for GM's manufacturing defects. This information is provided in the hopes that a recall is initiated.

Filed Aug 28, 2026 · Engine · WI

Yukon would not idle without turning off on its own. Check engine light came on. Took it to my mechanic. Check engine light was flashing which indicated an active misfire. A running compression test found little to no compression from cylinder 6. Further investigation found that cylinder 5 had been repaired in 2022. Mechanic recommends engine replacement.

Filed Apr 11, 2026 · Engine · FL

Complete engine failure. The dealership kept the engine. This happened at a low rate of speed but it would have been much worse if on the highway. Yes the engine was completely replaced. The check engine light came on and their was a loud ticking noise coming from the engine.

Filed Mar 18, 2026 · Engine, Transmission · TX

2019 GMC Youkon with 94,659 miles. I am the second owner of this vehicle. I purchased it used in February 2025. Check engine light came on in route to work on March 5, 2026. Immediately took vehicle to Auto Zone to scan for codes. Multiple codes were returned. I drove it directly to a repair shop for further diagnostics. Return Results were massive lifter failure and cam shaft damage. Why would the check engine light not come on sooner to prevent TOTAL FAILURE. Vehicle was towed to a GMC certified mechanic where it was confirmed that all Lifters and cam shaft were damaged beyond repair and must all be replaced. Estimated Cost of repairs so far: $8,596.80 Labor: Remove & Replace Left And Right Valve Lifter (Both Sides) Coolant Service Oil Change Labor Parts: Engine Camshaft 1 , Genuine GM Engine Valve Lifter Oil Manifold Gasket 1 , Genuine GM Fuel Pump Gasket 1 Engine Timing Cover Gasket Set 1 Engine Valve Lifter Guide 1 Engine Valve Lifter Guide 1 Coolant/Antifreeze Orange Dex-Cool 1 Gal 3 Engine Push Rod 8 Engine Oil Filter 1 0W-20 Full Syn 8 Engine Cylinder Head Bolt Set 1 Engine Valve Lifter Guide 1 Engine Valve Lifter Guide 1 Stock Engine Valve Lifter 4 Stock Engine Valve Lifter 4 Engine Cylinder Head Gasket Kit 1 Engine Cylinder Head Bolt 10 APPROVED Subtotal $8,422.71 + est. Tax $174.09 $8,596.80 Estimated time for repair: going on three weeks

Filed Feb 6, 2026 · Engine · AR

Check engine light came on. Went off a little later and then came back on. Took it to the dealership where they ran codes. They changed the fuel injector and spark plugs based on the codes listed. They heard a noise coming from under the engine and felt like it was the same failure that it happened in the 2021 to 2024 Yukon models those engines had been recalled. Was quoted $15,000 for a new engine was also charged $1000 for the fuel injector and spark plugs.

Filed Aug 19, 2025 · Engine, Transmission · 111,000 miles · CA

The contact owns a 2019 GMC Yukon. The contact stated that while driving at an undisclosed speed, the vehicle briefly hesitated and jerked before returning to normal functionality. The check engine warning light was illuminated. The vehicle was taken to an independent mechanic, who diagnosed a failure with the transmission. The contact was informed that the transmission needed to be replaced. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the federal safety agency Hotline for assistance. The failure mileage was 111,000.

Filed May 27, 2025 · Engine · TX

Engine lights and all other warning lights came on, and lost total power in engine while driving. Engine knocked bad and had to limp to a repair center to check out engine problem. Service department says total engine failure at 72k miles, no warning. Apparently this 2019 GMC Yukon is not within the recall for engine replacement that appears it needs to be covered as well.

Filed Apr 25, 2025 · Engine · 170,000 miles · KY

The contact owns a 2019 GMC Yukon. The contact stated while driving at an undisclosed speed, there was an abnormal rattling sound coming from the engine compartment, prompting the contact to discontinue driving the vehicle. The check engine warning light was illuminated. The vehicle was taken to the dealer, who diagnosed a failure with the cam shaft. The vehicle was repaired. The manufacturer was notified of the failure, a case was opened, and the contact was referred to the federal safety agency Hotline for assistance. The failure mileage was 170,000. The VIN was not available.

Filed Jan 22, 2025 · Engine · IL

The car was clicking when it was first started up, a short time later it started to shake terribly which forced my [XXX] son who was driving the vehicle at the time to pull over, on a major toll-way in heavy traffic. Engine light started to blink and traction control light came on. I immediately took the car into the dealer and was told I need new lifters ($3800 + Tax) and most likely a new engine (they quoted me $15,865). From what I am reading this issue is common place with the 6.2L engine...frightening and very lucky my son was not injured. I have filed a case with GMC - Case #[XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed May 28, 2024 · Engine, Transmission · 82,000 miles · CA

The contact owns a 2019 GMC Yukon. The contact stated while driving at various speeds and depressing the accelerator pedal, the vehicle hesitated to respond and jolted while responding. There was no warning light illuminated. The vehicle was taken to the dealer and an independent mechanic; however, the failure could not be duplicated. The contact stated while driving 65 MPH, the vehicle decelerated to 25 MPH independently while the RPMS were significantly high. The contact depressed the accelerator pedal, and the engine revved. The vehicle jolted and accelerated to 65 MPH; however, the failure recurred. The contact depressed the accelerator pedal and the vehicle resumed speed, then the vehicle jerked and lost motive power. The contact was able to pull to the side of the road. The contact restarted the vehicle and continued driving; however, the vehicle stalled. The contact pulled over to the emergency lane. The contact parked and restarted the vehicle. The contact was able to drive into a parking lot, where the failure recurred. The vehicle failed to restart with the check engine warning light illuminated. The messages "Transmission Hot - Idle Engine" and "Action Required" were displayed. The vehicle was towed to the residence. The dealer was notified of the failure. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure and referred the contact to the federal safety agency Hotline for assistance. The failure mileage was approximately 82,000.

Filed Apr 8, 2024 · Engine · GA

The engine continues to slip and slows down when driving. The following codes are returned back from the onstar diagnostics, Transmission Control Module Requested Malfunction Indicator Lamp Illumination. The DTC is an informational DTC. The DTC indicates an emission related DTC set in the Transmission Control Module. The vehicle has only 132,000 miles, and I have maitain the vehicle in excellent shape. With maitainance, the transmission should last at least 300,000 miles. The Engine and Transmission System is not performing as expected. An issue has been detected in the Transmission System that transfers power from the engine to the drive wheels.

Filed Jan 10, 2024 · Engine · LA

Engine Lifters failing and vehicle making a squeaking type noise. Check engine light came on briefly 2 weeks ago and went off. Problem confirmed by GMC dealer whom also reports they have multiple vehicles at shop right now with lifters and cam shaft problems

Questions about the 2019 GMC Yukon check engine light

Is check engine light a common problem on the 2019 GMC Yukon?

13 of 57 owner complaints about the 2019 GMC Yukon (23%) mention check engine light. The model year with the most reports is 2021.

Is there a recall or service bulletin for this on the 2019 GMC Yukon?

There are 0 recalls and 163 service bulletins for the same area of the car. Check them below with your VIN.

Other symptoms on the 2019 GMC Yukon

Engine failure 16Knocking 7Loss of power 6

All model years of the GMC Yukon

VIN decoder

See the problems and recalls for an exact car

Buying a used 2019 GMC Yukon?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history