2025 GMC Yukon: check engine light

Filed Mar 16, 2026 · Airbags, Driver assistance · NC

Purchased new August 29, 2025 On 12/3/25- Mileage 4495. Took vehicle in for first maintenance service. Tire rotation and oil change. On 1/7/26- Reported grinding noise we had began noticing when starting vehicle. Engine light Service ESC. Service Traction control. Reported to Ben Mynatt GM. On 1/8/26 Mileage 7120- Took Yukon in for service due to grinding noise. Due for 6 module updates and 3 stand alone updates. On 2/16/26 Noticed ticking noise when heat in on high. Scheduled service for 2/26. On 2/24/26 Smell from car, oil reporting low. Dip stick completely dry. Sent email and photos to Ben Mynatt Service. On 2/26/26 Took vehicle in for service. Service advised to start oil consumption test. Ordered blower motor for the squealing noise. Cyl 3 misfire. Was told by the dealer, possibly needs engine 2/27/26 Took Vehicle in for service Check engine light on. Bearing inside blower motor and blower motor replaced. Replaced coil cyl 3 Tire Rotation 2/28/26 Car shaking, smoking, engine light on. Terrible smell from exhaust. Engine light came on, Service ESC, Service Traction Control, Forward Collision Unavailable, Reduced Acceleration Drive with Care Alert. GMC Alert: Service the engine and transmission system immediately alert, Engine Light on. Vehicle Approx miles. Codes misfires to cylinder 3. Took vehicle right to Service Dept. Codes Cleared. Replaced coil on cyl 3 March 7th - Mileage 11,200 Car shaking vigorously! Engine light flashing. Loud knocking coming from vehicle. GMC alert: Service the engine and transmission system immediately alert. Emission system- service now. Engine and Transmission System Service now. Service antilock braking, Stabilitrack stability control systems and airbag system. Service Air Bag System. Emailed to Service March 9th. Took vehicle in. Cylinder 3 & 8 misfire code cold start rough idle code. Oil consumption using approx1 qt of oil/500 miles. Vehicle unsafe risk of engine seizure, fire risk and loss of acceleration is extreme danger

Filed Feb 3, 2026 · Driver assistance · MS

While driving on a highway, the vehicle intermittently experienced a sudden loss of engine power during acceleration, accompanied by a flashing check engine warning light. The most serious event occurred while merging into traffic, when the vehicle failed to accelerate normally and briefly lost power, creating a risk of being struck by faster-moving vehicles. After pulling over and restarting the vehicle, normal acceleration temporarily returned, but the problem has recurred multiple times. The malfunction appears to be related to an engine misfire or powertrain fault because the check engine light flashes during the events and an OBD scan has shown misfire-related diagnostic codes (random/multiple misfire and a cylinder-specific misfire). The condition is intermittent and typically occurs after the vehicle has been driven for approximately 10–45 minutes. The vehicle remains available for inspection. The vehicle has been presented to authorized service departments multiple times for diagnosis. The dealerships have reported that they were unable to duplicate the issue during road testing and no lasting repair has been completed. The manufacturer has been contacted and the vehicle has been inspected/diagnosed through authorized service channels, but the underlying cause has not been identified. The failure continues to occur intermittently and is a safety hazard because it affects acceleration in traffic. Incident list 10/25/2025 (~12:25 PM; ~3,108 miles) — While accelerating to merge onto a highway, the vehicle lost power and the check engine light flashed. The driver pulled over, shut the vehicle off, restarted, and the condition temporarily resolved, allowing the trip to continue. 10/27/2025–11/04/2025 — The same loss-of-power/misfire behavior recurred intermittently, typically lasting a few minutes before clearing. 11/05/2025 (~8:01 AM; ~3,641 miles) — The check engine light flashed again and symptoms consistent with misfire/loss of power were present. The

Filed Feb 3, 2026 · Engine, Transmission · MS

While driving on a highway, the vehicle intermittently suffers a sudden loss of engine power during acceleration, accompanied by a flashing check engine light. The most serious event occurred while merging into traffic when the vehicle failed to accelerate normally and briefly lost power, creating a risk of being struck by faster-moving vehicles. Pulling over and restarting temporarily restores normal acceleration, but the problem recurs. The malfunction appears consistent with an engine misfire/powertrain fault. An OBD scan has shown misfire-related diagnostic codes (random/multiple misfire and a cylinder-specific misfire). The condition is intermittent and often occurs after approximately 10–45 minutes of driving. The vehicle remains available for inspection. The vehicle has been presented to authorized service departments multiple times. Dealers reported they were unable to duplicate the issue during road testing and no lasting repair has been completed. The manufacturer has been contacted and the vehicle has been evaluated through authorized service channels, but the underlying cause has not been identified. This remains a safety hazard because it reduces acceleration in traffic. Incident list: • 10/25/2025 (~12:25 PM; ~3,108 miles): Loss of power while merging; flashing CEL; restart temporarily resolved. • 10/27/2025–11/04/2025: Intermittent recurrence, usually lasting a few minutes then clearing. • 11/05/2025 (~8:01 AM; ~3,641 miles): Flashing CEL and misfire/loss-of-power symptoms; taken for service. • 11/26/2025 (~10:06 AM): Another episode consistent with the same pattern. • 12/17/2025 (~8:21 AM): Another episode, including during travel to a service visit. • Ongoing: Episodes after ~10–45 minutes; sometimes requires restart to restore drivability. Observed codes: P0300 and P0301. Safety risk: loss of power during acceleration/merging increases risk of rear-end or side-impact collision.

Filed Jan 17, 2026 · Engine · AR

Engine Failure confirmed by dealership. Engine being replaced. Knocking sound and went in to “limp mode” and check engine light. Dealer stated it had issue with crank shaft causing metal in the oil. 5,117 miles at time of failure. 3.0 L Duramax diesel

Filed Nov 3, 2025 · Electrical, Engine · WI

My vehicle, with only 2,400 miles on the odometer, has been diagnosed as requiring a full engine replacement. While driving on the interstate, a warning message appeared indicating reduced acceleration. I was able to exit the freeway safely, but the vehicle could no longer maintain adequate speed to match traffic flow. Prior to this, the check engine light came on, but no issues were reported in the vehicle’s status system. I contacted OnStar, and they advised me to take the vehicle to a dealership within seven business days. It has since been at the dealership awaiting parts. Upon further research, I discovered that this issue appears to be widespread. General Motors has issued a technical bulletin addressing the problem, which involves complete engine replacement. Additionally, the audio system intermittently emits a loud crashing noise that is startling and potentially dangerous—it has caused me to veer off the road due to its intensity. This issue also seems to affect other 2025–2026 Yukon and Tahoe models.

Filed Aug 19, 2025 · Engine · CA

While driving on the highway, my SUV lost speed and went into what I believe was limp mode and the check engine light came on. I was unable to accelerate quickly which was very dangerous on the highway as I was only able to very slowly go about 45 MPH on a 65 MPH highway. After the dealer inspected it, I was told I needed a new engine, oil cooler, and turbo. They said it had metal in the oil. My SUV only had 2138 miles at the time of incident.

Filed Jun 11, 2025 · Brakes · OH

We purchased a brand new 2025 GMC Yukon on 5/19 and on 5/22, the vehicle would not release the parking brake. Multiple sensors / alerts were displayed, brake assist failure, press hard to brake, speed limited, service ESC, service traction control, check engine light, brake park, service ABS brakes. Vehicle was not drivable. Towed to Marhofer GMC, problem was replicated next day. Was informed that brake booster and master cylinder were bad, however on a national back order. We are now 3 weeks out, without a repair completed or parts. Was also informed by dealer that there is a service bulletin out on this vehicle. Vehicle has 170 miles.