Check a VIN

2012 Honda Accord: ABS light or ABS activating

11 of the 374 complaints about the 2012 Honda Accord describe ABS light or ABS activating.

owner complaints
11
of this car's complaints
3%
typical mileage
47,500
recalls
0
Is there a fix? No recall or service bulletin covers this area of the car yet.

ABS light or ABS activating by model year

What owners say

Filed Aug 16, 2025 · Brakes · NJ

The VSA/ABS module has failed. It is available for inspection. My safety and the safety of others are being put at risk due to the fact that the brakes may lock up or give out with this faulty module. Yes the problem has been confirmed by my local Honda dealer. The vehicle had only been inspected by the Honda dealer. The lights that appeared on the dash are, ABS, brake and traction control. There has already been a recall on this exact issue for my exact trim. I believe my car should be included in the recall due to the fact that I only hadn't 105k miles and hadn't had EVERY service done that was ever recommended. I keep my car in excellent condition. This should not be happening. Thank you

Filed Nov 25, 2024 · Brakes, Electrical · MA

ABS, Traction Control and Brake lights on. Diagnosed by 2 mechanics told ABS module is bad, which affects braking and is hazardous. Also told this should not be happening with so little mileage on vehicle 50K. There needs to be a recall for this issue!!!!

Filed Nov 13, 2024 · Brakes, Steering · MD

ABS,Traction Control, Brake Light steady stay on. Have taken vehicle to numerous mechanics. ISSUES can NEVER BE RESOLVED. Lights will stay on no matter what. I HAVE TO CHANGE THE BRAKES LIKE EVERY 4-6 months. Alignment also has to keep getting done. I don't know if that's because the issue with whatever is causing the braking issues haven't been resolved. Also the oil has to be changed like every 4,000 miles. 🤯. I also was driving down the road one day and heard this LOUD bang almost like a gunshot and out of the blue the trunk torque rods and the clips broke spontaneously.

Filed Oct 21, 2024 · Brakes, Steering · PA

My ABS, TRACTION CONTROL, BRAKE & TPMS LIGHTS have been ON for the past few months. My tire air pressure is fine. The dealer claims I need to replace the VSA MODULE at the cost est @ $1900. After my personal investigation, I have learned Honda has had numerous customer complaints of these same issues on 2012-2013 Honda Accords.

Filed Oct 18, 2024 · Brakes, Electrical · MA

ABS Module has failed and brake, ABS and traction control lights remain on; causing braking issue. This component has failed in many vehicles of this type per mechanic and should be recalled. There is very little mileage on the vehicle around 50K. A safety recall is apparent as if injury occurs Honda is liable, as an elderly person owns the vehicle. Vehicle does not stop as it should and will not receive an inspection sticker. This should not be on the consumer given the amount of low mileage.

Filed Sep 6, 2023 · Brakes, Driver assistance · CA

Problem: When the ABS computer system (ABS) fails, the balance between front and rear brakes becomes abnormal even for a vehicle without ABS, it becomes rear biased. Making it unsafe to stop quickly. (90% of the brake force is to the rear). The cost of this part is too expensive for most people to replace and this means that most will drive the car as is without replacing the ABS module. What I expect: I expect that the balance of brake force, is that of a vehicle without ABS (60-70% front).

Filed Nov 15, 2021 · Brakes · 75,071 miles · CA

The contact owns a 2012 Honda Accord. The contact stated while driving 45 MPH, the ABS warning light illuminated. The contact pulled the vehicle over to the side of the road and called an independent mechanic to describe the warning message on the vehicle. The independent mechanic informed her that she could continue to drive the vehicle to her residence. The following day the contact took the vehicle to the independent mechanic to be diagnosed. The contact was informed that the ABS module needed to be replaced however, the replacement part was on backorder. The contact then took the vehicle to the local dealer who inspected the vehicle and confirmed that the ABS module needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 75,071.

Filed Mar 8, 2020 · Acceleration, Driver assistance · 82,000 miles · CA

Vsa/ tc fail - caused hazard. Problem description: I got stuck on my driveway, on pavement, in a steep section of the road. Tc kept cutting the throttle. Here's what I did: 1) I tried to use the brakes to keep the car from rolling down the hill and to stop the no-traction wheel from spinning. This did not work. Tc kicked in, over and over, causing the car to roll backwards. 2) I tried to use the brakes, during quick foot swap of the pedals (separate application of brake, then gas pedal). This too, did not work. This was the worse case - the car rolled backward, and then made the drivers side wheel spin even more (beside, I now was almost off the road, and into muddy ditch). 3) next, I tried more careful slow acceleration, there was no difference between idle, off-idle and the very slightest of acceleration (needed more granularity). The wheel spun freely. I now was even closer to being, off the road, and into the muddy ditch. Where others have fallen before. 4) finally, I turned the traction control off. This had no effect. It appears this is dummy-button (its fake). Here's what I expected... A) since 3 of the wheels reported 0-MPH, and each application of the throttle resulted in negative MPH, on the same 3 wheels then the tc should allow low MPH of wheel spin, while gas and brakes are applied (I do this all the time in reverse/ backing up hill, and this works good - no tc interference). B) or, since 3 of the wheels reported 0-MPH, and each application of the throttle resulted zero forward progress, then the ABS should apply slight brakes (maybe even hill holding function), to the front wheels, to force traction to the wheel with the most grip. Abs possibly applying, alternating braking, as traction is lost, and gained, to each front wheel, till forward motion is achieved for 100ft (some distance). C) or, at least allow the vsa/ tc, button to work.

Filed May 24, 2017 · Electrical · 47,500 miles · MD

Rodent chewed through soy covered evap vent shut valve wire, ABS and vsa sensor wires. Car was parked in garage and warning lights came on next time car was driven.

Filed Mar 8, 2014 · Brakes · 10,000 miles · MD

The brake has failed four times starting at about 22 month old. When the brake pedal was pressed down, the wheels kept running. First time, I was exiting from highway. The road was slightly slippery. The brake worked fine initially but stopped working in the middle of the curve. The car zigzagged for three times before reaching the straight road. The second time was on december 14, 2012 after snowing for about 20 minutes. As I was switching to the left turn lane, the traffic light turned yellow, the brake worked initially so I was able to slow down. However, as I was approaching the car in front of me, the brake failed again and the car continue to cruise forward even though I was applying the brakes firmly. At the end, I had to turn the car towards curb on my left side and the impact of hitting the curb finally stopped the car. I took my car back to the dealer for repairs on the same day. The dealer checked the bake and didn't find any problem. The problem occurred again twice in the morning of february 26, 2014 when my husband was driving my son to middle school on slippery road. The first time, there was a slight turn to the left and a small downward slope, and applying the brakes could not stop the car even though the car was moving at around 10 MPH. The second time was near an elementary school. When he wanted to stop at a stop sign, on a straight road without an incline, the car pulsated (assuming ABS started) but did not stop and did not even slow down. I took the car back to the dealer again. However, they were not able to identify and fix the problem.

Filed Jun 1, 2012 · Brakes, Electrical · 4,850 miles · NJ

Abs lights on purchase after 5 months. I purchase my car on 12/30/11. On 30/5/12 I saw the lights on, I dropped my car for 1 day at boardwalk honda service. Next day, when I went to take my car the manager told me that rodents had eaten the wiring. The place where I park my car, there were three other cars also parked everyday. They never have such kind of problem. I think because of their car is old and my car is new so rodents like to eat new wires not a old wires. The manger told me that you have to pay for this and it will be more than $1000. I am completely disagree, why should I pay. Still its passed 5 months. I am looking forward to fix this problem by honda with free of charge.

Related recalls

No recalls on record for this model year.

Questions about the 2012 Honda Accord abs

Is ABS light or ABS activating a common problem on the 2012 Honda Accord?

11 of 374 owner complaints about the 2012 Honda Accord (3%) mention ABS light or ABS activating. The model year with the most reports is 2014.

Is there a recall or service bulletin for this on the 2012 Honda Accord?

There is no recall or service bulletin for this area of the car on record.

Other symptoms on the 2012 Honda Accord

No deployment 17Airbag light 12Sudden acceleration 11Check engine light 7Hesitation 6Stalling 6Door locks 5Jerking 5Oil consumption 5

All model years of the Honda Accord

VIN decoder

See the problems and recalls for an exact car

Buying a used 2012 Honda Accord?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history