1996 International Harvester 2574 recalls
There are 2 safety recalls on record for the 1996 International Harvester 2574, covering 1,154 vehicles in total across all the models in each campaign. Newest first.
All recalls
Suspension: rear
- What is wrong
- The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is inserted. The length of the keyway slot may not be long enough to accommodate the tab causing the tab to be deformed or damaged during installation.
- Risk
- This locking tab prevents the wheel bearing nut from loosening during vehicle operation. If this tab is deformed, the nut can loosen allowing the wheel to separate from the axle increasing the risk of a vehicle accident.
- Remedy
- Dealers will replace the drive axle housing nuts with a conventional wheel nut hardware system.
Recall number 96V233002 · Recall details
Suspension
- What is wrong
- The equalizing beam shaft of the tandem axle suspension were manufactured from as-rolled sae4140 steel rather than the specified annealed sae4140. These shafts can fracture inside the beam at the toe of the weld.
- Risk
- Vehicles are subject to vehicle tilt and possible rollover in the event that both equalizing beams, on the same side of the vehicle, experience a simultaneous shaft failure. Affected suspensions can also drop and contact the road surface generating sparks which could ignite flammable material.
- Remedy
- Owner notification is being conducted by neway anchorlok. Dealers will inspect and replace all suspension suspension beams with suspension beams containing appropriate shafts.
Recall number 96V124004 · Recall details
Questions about the 1996 International Harvester 2574 recalls
How do I check if my 1996 International Harvester 2574 has an open recall?
Enter your VIN in the VIN decoder on this page to see the recalls for your exact model and year, then confirm with any dealer of the brand or the manufacturer, who can tell you whether the repair was already done on your car.
Do I have to pay for a recall repair?
No. Safety recall repairs are free at any authorized dealer of the brand, even if the car is out of warranty or you are not the first owner.
How many recalls does the 1996 International Harvester 2574 have?
2, covering suspension.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1996 International Harvester 2574?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history