Check a VIN

1997 International Harvester 9200 problems

Its complaint count is close to a typical 9200 model year.

Typical yearClose to a typical year
Owner complaints
1
Recalls
5
Service bulletins
1

The worst 1997 International Harvester 9200 problems

Ranked by number of owner complaints. Mileage and cost come from what owners wrote.

Problems by type

Tap a problem to see which part fails, at what mileage and in which other years.

Recalls 5

Equipment: recreational vehicle/trailerReported February 27, 2004 · 83,312 vehicles affected
What is wrong
On certain conventional trucks equipped with pro-sleeper berths, water intrusion can be found in the bunk control panel area and pool in the tops of the dome light, tv/vcr, and or refrigerator power switches.
Risk
The circuit boards in the switches could heat up , possibly produce a flame or fire, and cause property damage, personal injury, or death.
Remedy
Dealers will install a water shield over the back of the entire bunk control panel. Owner notification began on july 16, 2004. Owners should contact international at 1‑800‑448‑7825.

Recall number 04V100000 · Recall details

Service brakes, air: slack adjustersReported February 1, 2001 · 2,855 vehicles affected
What is wrong
Vehicle description: heavy duty trucks equipped with air brake haldex automatic slack adjusters, long stroke brake chambers, and dana brakes. The automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the slack adjusters to function as manual slack adjusters.
Risk
If the support bracket for an automatic slack adjuster fails, the brakes at that wheel end will not automatically adjust. As the brake linings wear, the vehicle will have reduced braking capacity, increasing the risk of a crash.
Remedy
Dealers will install a new bracket on each suspect slack adjuster. Owner notification began february 22, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact international at 1‑800‑448‑7825.

Recall number 01V023000 · Recall details

Vehicle speed controlReported December 12, 1996 · 93 vehicles affected
What is wrong
These vehicles are equipped with a detroit diesel optimized idle system. If the ignition is turned on and the fuse for the electronic control module (ECM) power feed line is removed or burned out, unintentional cranking of the engine will occur..
Risk
If unintentional cranking of the engine occurs, the safety features designed to prevent injury to persons working in the vicinity of the engine will occur and also vehicle movement may occur increasing the risk of a vehicle accident.
Remedy
Detroit diesel distributors will rewire the vehicles using a revised ECM which will eliminate unintentional cranking.

Recall number 96V181002 · Recall details

Suspension: rearReported November 27, 1996 · 233 vehicles affected
What is wrong
Vehicle description: school buses and heavy duty trucks equipped with rear axle assemblies produced by dana spicer. Certain rear axle assemblies were improperly heat treated which could allow pinion breakage at the pinion threads.
Risk
Cracks can initiate and result in separation of the threaded end of the pinion resulting in separation of the yoke and drive line from the rear axle increasing the risk of a vehicle accident.
Remedy
Dealers will replace the rear axle carrier/pinion assembly.

Recall number 96V240000 · Recall details

Suspension: rearReported November 22, 1996 · 1,133 vehicles affected
What is wrong
The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is inserted. The length of the keyway slot may not be long enough to accommodate the tab causing the tab to be deformed or damaged during installation.
Risk
This locking tab prevents the wheel bearing nut from loosening during vehicle operation. If this tab is deformed, the nut can loosen allowing the wheel to separate from the axle increasing the risk of a vehicle accident.
Remedy
Dealers will replace the drive axle housing nuts with a conventional wheel nut hardware system.

Recall number 96V233002 · Recall details

See all 5 recalls for the 1997 International Harvester 9200

Technical service bulletins for the 1997 International Harvester 9200 1

Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.

What 1997 International Harvester 9200 owners say

Most recent owner complaints, unedited.

Filed Jan 28, 2000 · MA · crash

Semi was towing another semi when trailing apparatus failed and vehicle separated and went into ditch. (ohio traffic crash report)

Compare the 1997 International Harvester 9200

Other model years

1996199719981999

Questions about the 1997 International Harvester 9200

Is the 1997 International Harvester 9200 reliable?

Owners have filed 1 complaint about the 1997 International Harvester 9200, close to a typical 9200 model year.

What is the most common problem with the 1997 International Harvester 9200?

There are not enough complaints to tell.

How many recalls does the 1997 International Harvester 9200 have?

5 recalls, covering equipment, service brakes, air and vehicle speed control.

Share your experience with the 1997 International Harvester 9200

Tell other buyers what went wrong and what it cost. We review every report before it appears, and we never publish names, emails or VINs.

No names, contact details or links. Reports about a dealer or a person are not published.

VIN decoder

See the problems and recalls for an exact car

Buying a used 1997 International Harvester 9200?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history
Is this car on a recall?Check VIN