I have 2000 isuzu rodeo, and when the brakes are applied the vehicle does not stop!! The brakes have been replaced twice every year since we have owned the vehicle. We bought the vehicle new in october 2000. The brakes are constantly being adjusted almost monthly. The mechanic at "expert tire" on mcniel st, wichita falls tx. Have encountered the same problems with other isuzu rodeos and have directed us to bring the vehicle to the isuzu dealership. I can not believe that this major safety issue has not been addressed. The mechanic at expert tire believes that ABS system has a recall but we have never been notified nor is it listed on the isuzu rodeo recall web site.
2000 Isuzu Rodeo: ABS light or ABS activating
15 of the 274 complaints about the 2000 Isuzu Rodeo describe ABS light or ABS activating.
- owner complaints
- 15
- of this car's complaints
- 5%
- typical mileage
- 35,950
- recalls
- 0
ABS light or ABS activating by model year
What owners say
Dt*: the contact stated when the vehicle would not start the battery was replaced. The battery looked swollen. While driving 45 MPH, the check engine light and the ABS warning light illuminated and the digital displays began flashing on the instrument panel, and the engine power slowed to 30 MPH and below. After reaching the driveway, the vehicle stalled and could not be restarted. After towing the vehicle to the service dealer, an inspection identified the equipment failure to be the alternator and the wiring harness. The manufacturer was notified.
Vehicle accelerated while coasting causing vehicle to fish-tail and spin out. Once vehicle corrected brakes/ABS did not engage (no pulse in brake pedal no squealing tires) resulting in vehicle careening of the road.
While driving 55 MPH ABS braking light appeared on the dashboard and remained on until the vehicle was turned off. Consumer applied the brakes and pedal went to floor. Consumer was able to maintain control of vehicle, and drove it to the dealer for inspection. Mechanic determined that ABS module needed to be replaced.
00 isuzu rodeo ABS issues I find the ABS kicking in when running over smal bump and rocky surfaces. This is my wifes automobile, and I have been driving it for about a month now, and really believe that these brakes are potentially dangerous.
2000 isuzu rodeo braking problems. The rodeo's ABS is deployed randomly. Brakes lock up and car will not stop in an appropriate amount of time. There is a metalic grinding sound. When brakes are inspected at dealership, there is no problem. There are no worn parts.
I also own a 2002 rodeo and my ABS has failed twice now. It has been repaired under warrenty, but it does seem to be a pattern in this model.
I purchased the vehicle used in october of 2002. It has 23000+ miles on it. It currently has 35000+ miles on it and the engine is clicking. The dealership notified me that the engine is no good. Not only did the engine go bad, but we've been putting oil in the engine like mad. I think we've purchased 6 quarts of oil in the 8 month period and there is no leak and isuzu states this is "normal". Also at just over 30000 miles the ABS light came on. The intake gasket had to be replaced 1 month after purchase and that in turn caused one of the valves (egr I think) to need replaced as well.
On 3 separate occasions when brakes applied, the vehicle went through red light, at times feeling as if there were no brakes. Also vehicle is going on anti-lock braking system (ABS) mode when traveling on gravel, mud and at times on pavement when applying brakes at 20/30 MPH. Dealer adjusted the rear brakes and found the brake system to operate as designed and concluded that hitting a bump when braking can also cause the ABS to activate. *jb
Whenever the brakes are applied and one travels over a bumpy road (I.e. Railroad tracks) the ABS kicks in. One can feel the pulsation in the brake pedal then it feels like tthe pedal drops to the floor. As a result, the stopping distance has suddenly increased. I have had a case where I couldn't stop in time and ended up in the middle of the intersection. As a result, whenever this effect happens I compensate by immediately getting my foot off the brake pedal and quickly reapplying the brake pedal after passing over the bumps. I can reproduce this affect consistently at an intersection near my workplace since the road has some small bumps right before an intersection. This only occurs at speeds between ~10-20 MPH. If one goes slow enough over the bumps the ABS will not kick in. So whenever I come to a stop I am always wary of this situation. But I'm concerned when someone else borrows my vehicle.
Vehicle has had this problem since 10/00 . Abs kicks in "at will" usually during stop & go traffic conditions and extends stopping distance greatly. Has already caused front end damage. Manufacturer has denied any problems with this vehicle line.
Brakes did not grab right off it felt like someone put a stick in the spokes of a tire and then the brakes grab all of a sudden. This is the fourth time this has happened and the first time since the ABS module, the master cylinder, and the brake fluid completely flushed.
Service bulletins that may apply
Related recalls
No recalls on record for this model year.
Questions about the 2000 Isuzu Rodeo abs
Is ABS light or ABS activating a common problem on the 2000 Isuzu Rodeo?
15 of 274 owner complaints about the 2000 Isuzu Rodeo (5%) mention ABS light or ABS activating. The model year with the most reports is 1999.
Is there a recall or service bulletin for this on the 2000 Isuzu Rodeo?
There are 0 recalls and 2 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2000 Isuzu Rodeo
Check engine light 24Stalling 24Fuel gauge 21Brake failure 9Grinding brakes 6Jerking 6No deployment 5Fire or smoke 5Pulling 5Won't start 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2000 Isuzu Rodeo?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history