2006 Jeep Commander: wrong fuel gauge reading

Filed Jan 5, 2017 · Engine, Fuel system · 134,000 miles · OK

On christmas I backed the jeep out of the driveway so I could drive my truck. Bumped the curb slightly while parking and vehicle died. Started right back up so I didn't think much of it. Today my wife took the kids to school in it and ran fine. Parked for two hours and went to start and it will crank but not turn over. Fuel gauge doesn't read correctly. At full it says half a tank and while you are driving it may drop to below empty with a full tank. I have been reading all the reports about the 2006 commander and a lot of people seem to be having this starting problem. I haul my family around in it because we can't all fit in my truck but I don't feel safe in it because you never know when it's gonna cut out and die. My kids range from 1 week to 11 and I don't really want them in it. I'm thinking it a fuel pump or wiring issue. Both issues occurred in my driveway or right in front of my house.

Filed Dec 23, 2014 · Electrical, Engine · 96,500 miles · VA

I have 2006 jeep commander in which I am experiencing issues with the ignition switch on my vehicle. The defective ignition switch causes every light on my dashboard to illuminate and it causes my vehicle to stall, as well as flickering lights with no power to fuel gauges, MPH, and RPM needles. After all the lights illuminate and go away the check engine light stays on, and the defective ignition switch drains my battery causing my vehicle to not start without a jump start by the next day. With a slight tap on the key it will move some or a bump in the road will make the ignition switch start acting up and make some of the previously described symptoms act up. Occasionally there are clicks that come from the ignition switch after the vehicle has started, which signifies that the defective ignition switch is going to fail soon. I received the notification from the chrysler corporation about the recall and that my vehicle is included in it, but haven't received the second notice to this date about when the part would be available. I called in november to check and see what can be done but I was told the same thing that no parts are available. So this leaves me at the end of the road with this vehicle. I check online almost all the time for updates and still the same thing. I have been following this recall since it popped up in the news before I received notification from chrysler, because I have had this problem with my vehicle. I am scared for my life that the key will move into the wrong places disabling my car or when the ignition switch acts up it will make me loose control of my vehicle and it could be dangerous for me or any of my passengers even fatal. Safety should be chryslers number one priority. At this point I hope to get rid of this car and move away from chrysler's products for good especially since fiat is running the show!

Filed Dec 27, 2012 · Electrical, Lights · 155,000 miles · VA

While driving down the road, the entire cluster of instrument warning lights begins to flash intermittently, creating a distraction and safety hazard while driving. In addition, the fuel gauge drops to "e", the speedometer drops to zero and then goes up and down and all gauges go up and down erratically. Also, the heated seats turn off as does the fan for the heater/AC unit. Verified with local mechanic that this is not related to the ignition switch and is most likely an ECM and/or PCM issue. Replaced battery but problem still exists. Engine malfunction indicator light comes on for several cycles, computer reboots itself and then the trouble starts again shortly after. This appears to be an ongoing issue with the 06 commander but my VIN was not included in the ECM/PCM recall (08v203000) because I have the 6-cylinder rather than the 8 cylinder engine. This is a safety hazard while driving and I just feel fortunate that as of yet, my car is not stalling like so many others. However, I feel my issue is related to this same recall and want to have it on file.

Filed Aug 7, 2008 · Electrical · 46,000 miles · MD

My 2006 jeep commander 5.7l sometimes loses all the displays in the front panel dash board. Everything goes out. My A/C will not turn on. No radio, etc. This happens intermittently, like something is loose. It has never happened at night yet, so I am not sure if I also lose my headlights, but anything on the dashboard is off, no gas gauge, no speedometer, no temp gauge, etc. It has happened 5 times already. Is there a recall to 2006 jeep commanders that address this problem?

Filed Aug 15, 2007 · Electrical · 4,280 miles · WI · crash · 1 injury

1) driving on the interstate with the cruise control on; brake was applied to disengage the cruise control. 2) headlights shut off, speedometer and tachometer and fuel gauge shut off; a moment after, the tires locked up and the vehicle spun 180 degrees, then collided with a guard rail and bounced off and returned to the interstate in oncoming traffic facing the wrong way 3) independent inspector was hired by chrysler; the report found no mechanical defect nor did it find any computer codes that would indicate a malfunction; chrysler denies there is a problem and recommended we contact our insurance company for repairs.

Filed Jul 3, 2007 · Electrical, Engine · 14,025 miles · GA

I have a 2006 jeep commander. I was driving my 7 year old son to camp. I was driving about 45 MPH on a 2 lane road. Suddenly and without any warning the engine, as well as all electrical items completely shut off. I also lost all assist functions. When I was applying the brakes I got the noise that usually you hear when the ABS system has taken control. After pulling to the side of the road I restarted the car and the engine warning light came on. After dropping my son off I attempted to restart the car. I had no instrument panel functions (gas gauge, water temp, odometer, etc.). I will be taking the car in to the dealership on 7/5/2007 for analysis.

Filed Oct 11, 2006 · Engine · 25,000 miles · TN

(1) car is off, but air conditioner, or blower, is turned on (2) car starts, engine light, or gas gauge doesn't come on, it starts, you drive a bit, it makes noise(s) then stalls (3) turned car off after it rolls to a stop. When I turn the air conditioner, or blower to the off position I seem to not have as many stalls, if not any. When the dealership looks at it when the engine light is off they cannot see any error codes. When the engine light is on who is near a dealer to see the freaking' error codes?!?!?!