ABS module is bad, shooting codes on dash, disable cruise, worried about issues with braking.
2016 Jeep Wrangler brakes complaints
Page 2 of 6: complaints 11 to 40 of 139, newest first, as owners wrote them.
The ABS Module is non operative and has been on back order for over 3 years from the Dealership.
ABS module failure
The abs module malfunctioned and there’s no replacement. It’s been on back order for a couple years
ABS module failure without cause. New modules no longer being produced. Lack of anti braking system is a huge safety concern. Vehicle was looked at by a mechanic. Brake light, stability control light, and ABS light all came on at the same time at the time of failure. Vehicle was in park and turned on at the time of failure.
The contact owns a 2016 Jeep Wrangler. The contact stated while the vehicle was parked, the antilock brake system warning light was illuminated. The vehicle was taken to an independent mechanic where it was diagnosed that the antilock brake system needed to replaced however, the dealer recommended that the vehicle be taken to a dealer. The vehicle was not repaired. The vehicle was taken to a dealer where it was diagnosed once again that the antilock brake system needed to be replaced however, the parts were not available. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 76,000.
The contact owns a 2016 Jeep Wrangler. The contact stated while driving at an undisclosed speed, the ABS and traction control warning lights illuminated. The vehicle was taken to an independent mechanic where it was diagnosed with a failed ABS module. The contact was informed that the ABS module needed to be replaced. The vehicle was not repaired. In addition, the contact was informed that the parts were in back order indefinitely. The contact was advised that she could drive the vehicle at her own risk. The manufacturer was not made aware of the failure. The failure mileage was approximately 67,108.
The ABS module (68259556AD) on my 2016 JKU is not working (code C2200) and the part is not available anywhere. I tried buying online and reaching out to a dealership, but everyone acknowledges Stellantis doesn’t have the part available. There are posts on Jeep forums from 2023 from people with the same issue which is causing their Jeeps to go into limp mode at highway speeds. I feel unsafe driving my car and there’s no current way to fix this issue.
The ABS module has gone out with replacement parts on backorder and not being manufactured for a lengthy time. This is caused my jeep to go into limp mode since August 2025. There has not been a resolution to solve this problem at this time. Even to have it refurbished or rebuilt has not been an option due to most companies no longer working on this part.
ABS (Anti-lock Braking System) Control Module failed nine months ago. Without working ABS Control Module the braking system and traction control system do not function which is a huge safety concern. New ABS Control Modules have been out of stock at all Jeep Dealers across the country! Thousands of Jeep Wrangjer owners are waiting for new ABS Control Modules and until Chrysler corporation provides new Modules all owners are enduring big safety risks driving their Jeeps! Need immediate help from the federal safety agency forcing Chrysler to immediately provide new ABS Control Modules. A safety recall needs to be issued immediately for failed ABS Control modules for many thousands of Jeep Wranglers Thank you for whatever help the federal safety agency can provide to resolve this big safety issue.
Keep ABS / Traction control module defective with no replacement available.
The ABS module has failed and this is such a widespread issue with Jeep Wranglers that you can't even find a new ABS module part to order. The failure of this part impacts the braking system. Jeep should make a recall and fix this issue.
ABS Module has been on backorder since 2021. Cannot get an ETA on part from the dealership. They advised its been on backorder 3 yrs at the time issue was confirmed. 9 months to date on backorder list. No traction control, ABS, cruise control and emergency brake. The vehicle has lost speed making it not maintain a speed on hills, and highway. Vehicle feels unstable.
ABS Module has gone bad. Has an internal communication error. This is typical on these vehicles. The problem is getting a part from Chrysler. The modules have been on back order for years and there’s no sign of getting a fix. The vehicle is unsafe to drive but we are left with no choice but to continue to drive it. Why hasn’t anything been done to kick them in gear and get replacement parts made?
I own a 2016 Jeep Wrangler with a malfunctioning Anti-lock Braking System (ABS). The ABS is not functioning, creating a serious safety risk, particularly during emergency braking and adverse road conditions. The vehicle has been under an active repair order with Town & Country Jeep Chrysler Dodge Ram since October, but the required part remains on indefinite backorder with no estimated time of arrival. I have escalated this issue to Stellantis Customer Care and have ongoing email correspondence documenting the delay and lack of resolution. Despite these efforts, the vehicle remains unrepaired, forcing me to either drive with a known safety defect or go without transportation. This situation represents a failure to repair a critical safety system within a reasonable timeframe. I am submitting this complaint due to the ongoing safety risk and lack of timely resolution.
Just like many other people have wrote about, the ABS SENSOR is defective. The ABS light comes and the traction light does also. Jeep has been aware of the problem for 18 months to 2 years. There is no fix or replacement sensor in sight.
My girlfriend almost crashed going down a hill toward a stop sign for a busy intersection for a road that is along a cliffside. Jeep cannot get a part for this vehicle after numerous attempts to get one. Needs an ABS module as one of the wheel speed sensor circuits is not communicating. I have reached out to multiple module rebuilders and they are unable to get parts for this module anymore. This is a well-known issue with the wranglers and jeep is not willing to release a recall to make it right. Due to parts shortage, the modules are going online for $1500-$2000, which for a major safety component can be a large issue. We have since parked the vehicle for the past 3 months while I attempt to locate a reasonably priced module or find somebody that has the chips/capacitors to rebuild it. I am a dealership technician with 7 years of experience and we have sent lots of these vehicles to auction for the same concern.
ABS module reported to dealer in February, 2025..They said was safe to drive. Then April 2025 the module went out.-Part has been on backorder since March 2025. It was taken to Key Chrysler Dodge Jeep in Marianna in March 2025. Jeep would not steer properly, the brakes were not normal and all the warning lights on dash were on. I could not drive. .
Pulled into parking space. Applied brakes and came to a complete stop. Could hear engine revving up.. Thought ok, that gas pedal seem to be pressed. Look at my foot wasn’t pressing the pedal. Looked at floor mats. It was laying flat on floor, not manipulating the pedal. I thought what’s happening? And lifted foot off brake ever so slightly and car jumped 6 inch high curb and hit the building.. Pretty hard. Caused structural damage to the wall. I went to the hospital, driven by husband. Swelling of my right leg on the shin. Released and told to stay off leg for few days, no fractures.After doing research, It seems other jeep riders have had this experience. I have no idea how fast the jeep was going.
Anti-Lock Brake System stopped working rendering the car inoperable. The first incident: about 5 years ago the ABS engaged the brakes while driving almost causing a collision. This incident occurred in Guaynabo, PR. After this incident the ABS Module stopped working but the car was still operable. A week ago the PCM lost communication with the ABS module bringing the car into "limp mode" (stuck in 3rd gear until y did not longer engaged the transmission. Also the speedometer stopped working.) This happened while driving on a Sunday on busy road. This has been a common issue with Jeep Wranglers made from 2012 to 2018. The company at this moment is not producing replacement parts (ABS Modules) for these vehicles leaving owners without any way to fix or use their cars. ABS Module DTC's: -C2200 -U0100 -U0141 -U0126 -U0002 While scanning the module comes and goes offline.
My ABS module has been in error for 8 months. Stellantis still cannot fill the order after 8 months and only keeps delaying on weeks at a time .
I have a faulty ABS module, throwing code c2200. The part has been on order for over 2 months with no end in site. We are being told told that this is not a safety issue. How can we get this resolved???
ABS Module Part# 68259556AC has failed. (Replacement part is 68259556AD) Stellantis/Jeep has not provided a replacement part for over three years. This affects all Jeep Wranglers 2014-2018. We have no ABS and no traction control in our Jeeps. We need help.
The ABS control module has failed. Anti-lock brake and stability management systems, in addition to vehicle descent control are malfunctioning. This renders the vehicle extremely unstable and difficult to drive. Stellantis is aware of the problem and reports no replacement parts are available and has not issued a recall. The vehicle has low milage and has never been in an accident.
The contact owns a 2016 Jeep Wrangler. The contact stated that while driving at an undisclosed speed, the vehicle jerked with an abnormal sound coming from the vehicle. The contact stopped the vehicle, and there was an unknown warning light illuminated. The vehicle was turned off and restarted; however, while driving, the failure reoccurred with several unknown warning lights illuminated. The vehicle was towed to a private dealer, where it was diagnosed with ABS control module failure. The dealer informed the contact that the part to do the repair was not available. The vehicle remained with the dealer unrepaired. The contact related the failure to NHTS Campaign number: 22V426000 (SERVICE BRAKES, HYDRAULIC); however, the VIN was not included. The manufacturer was made aware of the failure. The failure mileage was approximately 77,000.
The ABS module for this vehicle has been on national back order for over 2 years. Numerous vehicles are involved. With the malfunction, ABS does not perform as intended and creates a safety hazard. In addition other functions are rendered inoperable such as cruise control, hill start, etc. There is no remedy for the defect and manufacturer seems unable to offer a solution
The ABS module failed 18 months ago. Jeep has been telling me that it's on back order this whole time with no ETA. In the meantime it will not pass inspection and I have no antilock brakes.
Abs system fails periodically causing the jeep to go into limp mode driving in traffic.
The contact owns a 2016 Jeep Wrangler. The contact stated that while driving on wet roads, the vehicle lost traction, failed to accelerate as intended, and caused the tires to spin before accelerating. While depressing the brake pedal, the wheels locked up, and the vehicle failed to come to a gradual stop. The ABS control module displayed DTC: C2200 (Internal ABS Module Failure). The vehicle was taken to the dealer, who confirmed the fault code. The vehicle was not repaired because the Part Number 68259556AD was on back order. The manufacturer was notified of the failure and informed the contact that the part was still under engineering review, and that a remedy had not yet been found. The failure mileage was approximately 150,000.
The ABS Module (Part 68259556AD) on my 2016 Jeep Wrangler began failing about two years ago. When the ABS warning light turns on, both the ABS and traction-control systems stop functioning, creating a serious safety hazard: greatly increased stopping distance, reduced steering control under braking, and higher risk of loss of control on wet or slippery roads. The warnings, once intermittent, are now continuously illuminated, meaning the vehicle has no working ABS or traction control at any time. Performance Jeep of Somerville (Somerville, NJ) inspected the vehicle around September 2023 and confirmed the ABS module had failed. They also confirmed the replacement part was unavailable, with no estimate from Jeep on when it would be supplied, and suggested a possible upcoming national recall—none has been issued. The ABS module has now been on national backorder for roughly two years. Jeep’s parts division states the part is still “supported” but on “heavy backorder.” Jeep/Stellantis corporate opened a case, promised to “fast track” it, and later reported supplier “tooling/manufacturing” issues, offering no timeline for availability despite repeated follow-ups. Please note that Performance Jeep has informed me that they have several aging orders in for the ABS Module (Part 68259556AD) that they're unable to fulfill, so it would appear that on a national basis, there must be many Jeep owners such as myself who are experiencing this problem with no remedy in sight. Because the part cannot be obtained, the vehicle cannot be safely driven or repaired. This is a safety-critical defect with long-term parts unavailability. I am requesting the federal safety agency review and intervention, as the manufacturer has been unable to supply a federally required safety component, leaving the vehicle in an unsafe condition with no remedy.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2016 Jeep Wrangler?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history