2016 Jeep Wrangler brakes problems

Filed Nov 3, 2026 · Brakes · MD

ABS and break lights on in car. Took to local repair shop and informed that the ABS control module has become defective. Attempted to purchase the required OEM part for repair in July of 2025. Was informed the part is on back order with no intended arrival date. Have continually reached out to local dealership since that time and part continues to remain on back order with no arrival date. Have been informed by the dealership that my automatic breaking system will no longer function, making the car unsafe to drive on a daily basis. This could lead to a catastrophic accident due to no breaking system. Manufacturer has not prioritized increasing supply of the replacement part and has not issued a mandatory recall for this safety issue.

Filed Nov 2, 2026 · Brakes · 70,000 miles · FL

The contact owns a 2016 Jeep Wrangler. The contact stated that while driving 5 MPH, the ABS and check engine warning lights illuminated. The vehicle was taken to the dealer where it was diagnosed with ABS module failure. The dealer was contacted and made aware of the failure. The contact was informed that the ABS module needed to be replaced. The contact was informed that parts were on back order. The manufacturer was contacted and made aware of the failure. The failure mileage was approximately 70,000.

Filed Oct 6, 2026 · Acceleration, Brakes · GA

Vehicle reflects a code of C2200. It is due to a faulty ABS module that controls the antilock brake system, traction w and cruise control. The remedy is to replace the part (part number 68259556AD). This part has been on national back order for several years now with no anticipated date of release. The manufacturer has Indicated it will not be made. This is a safety item that not only affects the performance of the vehicle but limits it resale value. Numerous vehicles from 2011-2017 models have been affected.

Filed Aug 31, 2026 · Brakes, Electrical · CA

ABS Control Module stopped working with several warning lights showing on dash display. After 12 months the dealer is unable to supply a replacment part or a possible date when a new part might be available.

Filed Aug 24, 2026 · Brakes · FL

The ABS module on my jeep has failed. I've been put on a list to get a replacement part but have been on the list for 10 months with no indication of when my parts order will be fulfilled. The failed ABS module caused the BRAKE, ABS and TCS warning lights to be on. I am driving a vehicle under unsafe conditions and the manufacturer does not care.

Filed Aug 20, 2026 · Brakes, Wheels · PA

My 2016 Jeep Wrangler is experiencing an ongoing problem with the ABS/braking system and wheel-speed sensor. The ABS/brake warning light comes on intermittently, particularly when turning right and during hot weather. The vehicle has NOT been repaired for this problem. I am reporting it because I am concerned that there may be a defect involving the wheel-speed sensor, sensor wiring/connection, wheel hub, or ABS system. Because these components are connected to the vehicle’s anti-lock braking and stability/traction-control systems, I am concerned about the safety of continuing to drive the vehicle. I would like this problem investigated as a potential safety defect. I am also requesting that the federal safety agency review whether other 2016 Jeep Wrangler owners have reported similar ABS, brake warning light, or wheel-speed sensor failures and determine whether a safety recall is warranted. There was no accident it just started happening on its own.

Filed Aug 17, 2026 · Brakes · NC

ABS Brake Sensor is on and the ABS Module needs to be replaced, however there are a lot of other people out there with this same issue and nobody can keep up with the parts to fix the problem. This should be a recall for all Jeeps 2009-10018

Filed Aug 10, 2026 · Brakes · 80,000 miles · UT

The contact owns a 2016 Jeep Wrangler. The contact stated that while driving at an undisclosed speed, the vehicle experienced an ABS module failure. The ABS and traction control warning lights were illuminated. The dealer was contacted and diagnosed the vehicle with ABS control module failure; however, the part to repair the vehicle was not available. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time to provide the parts for the repair. The manufacturer was made aware of the failure but was unable to determine when parts for the repair would be available. The failure mileage was approximately 80,000.

Filed Jul 21, 2026 · Acceleration, Brakes · VA

The ABS control module has internal problem which shuts down the module. Results of the module shut down includes: -The stability and traction systems are offline. -A failure in the ABS module or hydraulic unit. -Cruise Control inoperable. -The module no longer modulates brake pressure, which can result in brakes locking. Currently, Mopar has stopped production of this item, so there is no method to replace a failed or non-working module with an original part.

Filed Jul 10, 2026 · Brakes · SC

Code C2200 Multiple visits to shop. Part is on indefinite backorder. Brakes lock up when quick needed, traffic/other driver pull out in front of me Showed up 4 months ago