Check a VIN

2001 Kenworth T300 problems

The most common problem on the 2001 Kenworth T300 is suspension. Its complaint count is close to a typical T300 model year.

Typical yearClose to a typical year
Owner complaints
2
Recalls
5
Service bulletins
6
Worst area
Suspension

The worst 2001 Kenworth T300 problems

Ranked by number of owner complaints. Mileage and cost come from what owners wrote.

  • Suspension
    2

Problems by type

Tap a problem to see which part fails, at what mileage and in which other years.

  • Suspension
    2

Recalls 5

Trailer hitches: fifth wheel assemblyReported May 5, 2003 · 483 vehicles affected
What is wrong
On certain trucks equipped with jost international jsk 37u series fifth wheels, a fatigue crack can develop in the bracket pin weld under certain loading conditions.
Risk
If left undetected or corrected it could lead to the separation of the fifth wheel top plate from its mounting structure, possibly resulting in a crash.
Remedy
Dealers will replace the bracket pins and repair instructions free of charge. Peterbilt's owner notification began june 20, 2003. Kenworth's owner notification began june 12, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact peterbilt at 940‑591‑4201 or kenworth 425‑828‑5440.

Recall number 03V168000 · Recall details

Service brakes, air: supply: check valveReported January 15, 2002 · 2,302 vehicles affected
What is wrong
On certain heavy duty trucks equipped with meritor wabco pneumatic anitlock brake system (ABS) valve packages, the assembly bolts on these valve packages were not tightened correctly.
Risk
Bolts torqued below specification will not reliably prevent air leakage at the affected ABS valve package interface joints once the component begins normal vehicle operation. If air leaks develop at any of the ABS valve package interface joints, brake system pressure reductions could occur during braking or normal operation with units equipped with the traction control option, potentially extending stopping distances, possibly resulting in a vehicle crash.
Remedy
Dealers will tighten the fasteners to the proper specification. Owner notification began february 15, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1‑425‑828‑5440 or peterbilt at 1‑940‑591‑4201.

Recall number 02V018001 · Recall details

Visibility: defroster/defogger/HVAC systemReported September 26, 2001 · 2,670 vehicles affected
What is wrong
Vehicle description: certain heavy duty trucks fail to comply with the requirements of fmvss no. 103, "windshield defrosting and defogging systems." the mode door in an HVAC system can become inoperable. The mode door cam and actuator could bind, causing the cam retaining tabs to shear off.
Risk
This failure may inhibit the ability to direct air blowing from the HVAC system to the windshield, potentially reducing the driver's visibility.
Remedy
Dealers will inspect the mode door operation and replace the HVAC cab mode housing assembly if necessary. Owner notification began november 7, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1‑425‑828‑5000.

Recall number 01V305000 · Recall details

Service brakes, hydraulic: foundation components: drum: shoes/liningsReported August 23, 2001 · 3,000 vehicles affected
What is wrong
Vehicle description: heavy duty trucks equipped with 10,000 or 12,000 pound dana front axles. A condition called brake "sprag", which is characterized by a noise at the end of an applied stop, can develop in the brake system. This noise is the result of a pulsation of the brake lining with the brake drum during brake application. These noise vibrations occur at the resonant frequency of the front axle cross-tube assembly and cause unusually high strain forces in the threaded portion of the tie rod ends that are connected to the cross-tube.
Risk
Failure of the tie rod end can cause loss of steering control and possibly result in a vehicle crash.
Remedy
Dealers will replace the brake lining on the front axle of each vehicle with a lining made of a different composition. In addition, the tie rod ends will be replaced free of charge. Owner notification began october 12, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1‑425‑828‑5000.

Recall number 01V268000 · Recall details

Service brakes, air: supply: reservoir/tankReported June 12, 2001 · 23 vehicles affected
What is wrong
Vehicle description: certain vehicles having an intended service code of "fire service" and either type 24 or larger front brake chambers or type 36 rear brake chambers fail to comply with requirements of fmvss no. 121, "air brake systems." these vehicles were built with a combined air reservoir volume less than 12 times the combined volume of all service chambers.
Risk
Unusually frequent applications of the air brakes could deplete the available air supply more quickly than expected.
Remedy
Dealers will install an additional air tank on chassis with a single rear axle. On tandem rear axle chassis, dealer will replace an existing air tank with a larger air tank. Owner notification began july 16, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1‑425‑828‑5000.

Recall number 01V188000 · Recall details

See all 5 recalls for the 2001 Kenworth T300

Technical service bulletins for the 2001 Kenworth T300 6

Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.

What 2001 Kenworth T300 owners say

Most recent owner complaints, unedited.

Filed Nov 19, 2001 · Suspension · IN

Front end shimmies at 45 MPH. Vehicle has been taken to dealer 10 times. Dealer has not been able to correct the problem. *ak consumer feels the dealer is ignoring the problem.

Filed Nov 19, 2001 · Suspension · IN

Front end shimmies at 45 MPH. Vehicle has been taken to dealer 10 times. Dealer has not been able to correct the problem. Manufacturer has been contacted.*ak

Compare the 2001 Kenworth T300

Other model years

2001200420052007

Questions about the 2001 Kenworth T300

Is the 2001 Kenworth T300 reliable?

Owners have filed 2 complaints about the 2001 Kenworth T300, close to a typical T300 model year.

What is the most common problem with the 2001 Kenworth T300?

Suspension, with 2 complaints.

How many recalls does the 2001 Kenworth T300 have?

5 recalls, covering trailer hitches, service brakes, air and visibility.

Share your experience with the 2001 Kenworth T300

Tell other buyers what went wrong and what it cost. We review every report before it appears, and we never publish names, emails or VINs.

No names, contact details or links. Reports about a dealer or a person are not published.

VIN decoder

See the problems and recalls for an exact car

Buying a used 2001 Kenworth T300?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history
Is this car on a recall?Check VIN