2001 Kenworth W900 Problems: 1 Complaint, 9 Recalls

The worst 2001 Kenworth W900 problems

Ranked by number of owner complaints. Mileage and cost come from what owners wrote.

Fuel system
1

Problems by type

Tap a problem to see which part fails, at what mileage and in which other years.

Fuel system
1

Recalls 9

Unknown or otherReported July 1, 2003 · 84 vehicles affected

What is wrong: On certain heavy duty trucks equipped with vertical tail pipes, the frame access grabhandle is mounted too high.
Risk: This condition could cause a person to slip and/or fall and could lead to personal injury.
Remedy: Dealers will inspect the grabhandle location and if determined to be mounted too high, the handle will be relocated to the proper height. Owner notification began july 29, 2003. Owners should contact kenworth at 1‑425‑828‑5440.

Recall number 03V234000 · Recall details

Trailer hitches: fifth wheel assemblyReported May 5, 2003 · 483 vehicles affected

What is wrong: On certain trucks equipped with jost international jsk 37u series fifth wheels, a fatigue crack can develop in the bracket pin weld under certain loading conditions.
Risk: If left undetected or corrected it could lead to the separation of the fifth wheel top plate from its mounting structure, possibly resulting in a crash.
Remedy: Dealers will replace the bracket pins and repair instructions free of charge. Peterbilt's owner notification began june 20, 2003. Kenworth's owner notification began june 12, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact peterbilt at 940‑591‑4201 or kenworth 425‑828‑5440.

Recall number 03V168000 · Recall details

Suspension: front: hubReported April 1, 2003 · 154 vehicles affected

What is wrong: On certain trucks equipped with truck hub units manufactured by skf exclusively for use on arvinmeritor's ff98x series non-drive steer axles, the hub unit bearings can wear prematurely.
Risk: Seizure of the bearings can cause wheel separation or wheel end fire.
Remedy: Dealers will replace all front axle hubs. Notification began july 16, 2003. The manufacturer has advised us that parts will not be available until september 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy with a reasonable time should contact peterbilt at 940‑591‑4201 or kenworth 425‑828‑5440.

Recall number 03V125000 · Recall details

Suspension: rearReported February 27, 2002 · 116 vehicles affected

What is wrong: On certain heavy duty trucks equipped with replacement dana spicer tandem drive axle models ds463 and ds521, installed on vehicles from may 1, 2001 through february 1, 2002, an undersized attachment weld may fracture without warning.
Risk: The loss of this attachment to the vehicle chassis can adversely affect vehicle handling or driver control.
Remedy: Dana is conducting the owner notification and remedy for this campaign. The dealers will remove the suspect bracket, inspect the axle housing, and reweld the bracket to the axle housing. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact dana at 616‑567‑1088 or kenworth at 425‑828‑5440.

Recall number 02V061001 · Recall details

Power train: driveline: universal jointReported October 25, 2001 · 237 vehicles affected

What is wrong: Vehicle description: heavy duty trucks. The driveline u-joint fasteners at the output yoke of the transmission were improperly tightened.
Risk: Under-tightened fasteners can lead to the driveline becoming detached from the vehicle resulting in property damage or personal injury.
Remedy: Dealers will tighten the driveline fasteners to the proper specification. Owner notification began november 26, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1‑425‑828‑5000.

Recall number 01V335000 · Recall details

Visibility: defroster/defogger/HVAC systemReported September 26, 2001 · 2,670 vehicles affected

What is wrong: Vehicle description: certain heavy duty trucks fail to comply with the requirements of fmvss no. 103, "windshield defrosting and defogging systems." the mode door in an HVAC system can become inoperable. The mode door cam and actuator could bind, causing the cam retaining tabs to shear off.
Risk: This failure may inhibit the ability to direct air blowing from the HVAC system to the windshield, potentially reducing the driver's visibility.
Remedy: Dealers will inspect the mode door operation and replace the HVAC cab mode housing assembly if necessary. Owner notification began november 7, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1‑425‑828‑5000.

Recall number 01V305000 · Recall details

Equipment: other: labelsReported April 24, 2001 · 14 vehicles affected

What is wrong: Vehicle description: heavy duty trucks equipped with meritor fg941 steer axles. The gross axle weight rating (gawr) was determined incorrectly and over-stated on the vehicle certification label. With the incorrect gawr listed, these labels do not meet the certification requirements of part 567, "requirements for manufacturers of motor vehicles." vehicles will be remedied either by assigning the proper weight rating or, if possible, by changing the necessary components to meet the currently assigned weight rating.
Risk: These vehicles would not be in compliance with federal regulations.
Remedy: Vehicles will be remedied either by assigning the proper weight rating or, if possible, by changing the necessary components to meet the currently assigned weight rating. Owner notification began june 22, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1‑425‑828‑5000.

Recall number 01V142000 · Recall details

Suspension: front: control arm: lower armReported February 20, 2001 · 209 vehicles affected

What is wrong: Vehicle description: vehicles equipped with 54" rear axle spacing configuration of the airglide 200 suspension with the service application identified as logger, dump truck, or tanker. The rear suspension is regularly subjected to extreme articulation, resulting in flexing of the joint.
Risk: Failure of the lower sway arm attaching bolts could result in loss of vehicle control.
Remedy: Dealers will replace the lower sway arm brackets. Owner notification began march 27, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1‑425‑828‑5000.

Recall number 01V051000 · Recall details

Electrical system: wiring: fuses and circuit breakersReported February 5, 2001 · 1,992 vehicles affected

What is wrong: Vehicle description: heavy duty trucks equipped with an optional firewall-mounted circuit breaker. The main cab power and battery power leads were attached incorrectly. This condition can result in the main cab power being unprotected.
Risk: If a wiring short occurred anywhere along the cab power circuit, the available battery power could arc and cause subsequent damage to the vehicle or a fire.
Remedy: Dealers will inspect and correct the problem, as needed. Owner notification began february 26, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1‑425‑828‑5000.

Recall number 01V021000 · Recall details

See all 9 recalls for the 2001 Kenworth W900

Technical service bulletins for the 2001 Kenworth W900 9

Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.

Feb 10, 2021 Service bulletinInformation Only – Windshield washer pumps have a high No Trouble Found rate
Jun 8, 2020 Service bulletinInformation Only:
Mar 17, 2020 Service bulletinInformation Only: Proper jump-starting voltage will eliminate high voltage related issues and equipment...
Nov 6, 2019 Service bulletinInformation Only:
Feb 27, 2015 Service bulletinKenworth: some trucks failed to meet company standards for air volume lift axle and the company will...
Jul 9, 2012 Service bulletinKenworth: oil collection at cac intake pipe is caused by an imbalance in turbocharger pressures
Dec 15, 2010 Service bulletinPaccar: engineering standards have changed and there are now engines with heat treated bolts
Dec 2, 2010 Service bulletinPaccar: a software update is causing the check engine light to come on
Oct 23, 2008 Service bulletinKenworth trucks: reduced engine power from fuel starvation

What 2001 Kenworth W900 owners say

Most recent owner complaints, unedited.

Filed Jan 30, 2002 · Fuel system · DE

Consumer stated the fuel tank bracket is not strong enough to keep tank from twisting, the straps apparently are too big and loosen from wear, causing fuel tank to twist and leak to fuel, dealer and manufacturer were notified.*ak

Compare the 2001 Kenworth W900

Other model years

1994 1995 1997 1998 1999 200020012002 2003 2004 2005 2006 2007 2008 2021 2022 2024

Questions about the 2001 Kenworth W900

Is the 2001 Kenworth W900 reliable?

Owners have filed 1 complaint about the 2001 Kenworth W900, close to a typical W900 model year.

What is the most common problem with the 2001 Kenworth W900?

Fuel and propulsion system, with 1 complaint.

How many recalls does the 2001 Kenworth W900 have?

9 recalls, covering unknown or other, trailer hitches and suspension.

VIN decoder

See the problems and recalls for an exact car

Buying a used 2001 Kenworth W900?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history

2001 Kenworth W900 problems