2011 Mercedes-Benz CLS218 technical service bulletins
92 technical service bulletins and manufacturer communications cover the 2011 Mercedes-Benz CLS218.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Various fault codes present in TPM Control Unit, vehicles with code 475 and code B03
- Window lifter inoperative
- Thumping noises from rear axle shock absorber
- Thumping noises from rear axle damper
- Model series 257: In the Edition 1, the Welcome graphic is not displayed in the instrument cluster with...
- Esp, bas, pre-safe
- Battery discharged, vehicle does not start
- Fuel Tank Is Difficult To Fill
- Seat belt extender toothed rack sluggish or makes noises
- Info-Call/S24H-Call/MB Contact: Change of language setting at customer request
- Inductive charging: iPhone is not reliably charged
- Warnings without obvious
- Knocking noise from steering when changing steering direction while stationary or when driving slowly
- Rattling/knocking noise from electric steering when driving on rough terrain or cobblestones
- Trunk lid cannot be closed
- Height adjustment of electric steering column adjustment does not operate
- Garage door opener cannot be programmed
- Garage door opener range too short
- Garage door opener loses programming
- Comand
- Oil in engine wiring harness
- Comand
- Comand
- Garmin MAP PILOT: Traffic information service and possibly voice control inoperative after navigation...
- Message "SOS
- Message in instrument cluster "Collision Prevention Assist Inoperative"
- AMG Performance steering wheel heavily worn/soiled
- Garmin MAP PILOT: General information in the event of complaints
- Rattling noises in area of 2-stage turbocharger, OM651
- Garmin MAP PILOT: Notes on voice input
- Vehicle wanders to the left or right.
- Audio 20: Music does not continue automatically after a call
- Facebook app cannot be opened
- Check/Remove Heat Shield
- Ordering a Programmed Key when no keys are present ? ?The Fallback Process?
- Engine noises after engine start
- Heating element of AdBlue tank has malfunction, fault code 20BE1B and/or 20BD1B logged in BlueTec control unit
- Becker MAP PILOT: Navigation display freezes briefly in the case of physical shocks
- Check Engine Light (CEL) on, DTC fault code(s) concerning throttle valve actuator
- Vehicles with reversible seat belt retractor (RevAS) / active belt buckle (AGS)
- IPhone mobile phone: Various complaints after software update to iOS8
- Drive Kit Plus: Digital DriveStyle app does not launch automatically
- Door seal on front door/rear door loose
- The pneumatic 4-way lumbar support fails
- Pneumatic comfort systems with insufficient performance, entirely inoperative or leaky.
- The controls on the partially electric seat adjustment switch stick or are loose or broken.
- Creaking noise when adjusting electrical steering column
- Fault code P245997, P246397, P245900, P246385 or P246309 stored in engine control unit
- Complaints about poor wiping effect of winshield wiper
- SENTEX gate operator with Clik Card Remote not compatible with Homelink
- Seat belt adjustment intermittently inoperative and causes noises.
- Fault message in instrument cluster on engine start "Power Steering Malfunction, Service Required"
- Procedure in case of slight oil traces on TRANSMISSION 722.9
- Engine diagnosis warning lamp active
- Update Transmission Control Module Software
- Warning message in instrument cluster
- Fault code P045600 or P044200 without complaints about engine running characteristics
- Friction power of torque converter lockup clutch is too high (FC 2783) or actuation of torque converter...
- Procedure in case of slight oil traces on TRANSMISSION 722.9 with CODE B03
- Apple products (iPhone or iPod) are not charged via the serial USB interface of the COMAND Online control...
- The vehicle cannot be started The vehicle may start by itself shortly after the startup attempt with a...
- Creaking noise when making vertical or longitudinal adjustment to electrical steering column
- Engine diagnosis warning lamp active
- Surface damage on steering wheel trim
- This Customer 1 Action has been initiated because certain mbrace subscribers were recently contacted by...
- The key is not recognized in the electronic ignition switch, the vehicle cannot be started and/or the...
- Message in instrument cluster "DISTRONIC PLUSCurrently Unavailable
- This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz...
- Comand online: mute function no longer active after a restart
- Comand online: intermittently no audio output after engine start.
- Shift quality complaints and/or automatic transmission in limp-home mode in combination with one or more...
- Customer experiences low battery conditions, resulting in jump starts, and eventually requiring battery...
- Engine diagnosis warning lamp activated
- Glove box squeaks/rattles at top left mounting.
- The COMAND unit does not start or the COMAND display remains dark
- Combination message: "Clean fuel filter" is displayed
- Comand
- Malfunctions of various control units and/or on-board power supply problems caused by water in the control...
- Message in instrument cluster "ESP Malfunction
- Mobile phone in general: The driver is sometimes poorly understood by the receiver, background noise is...
- Comand
- Battery discharge in vehicles with KEYLESS-GO
- Garage door opener cannot be programmed or the range is too short
- Remove Check Valve for Left and Right Secondary Chain Tensioners
VIN decoder
See the problems and recalls for an exact car
Buying a used 2011 Mercedes-Benz CLS218?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history