2013 Mercedes-Benz E207 technical service bulletins
107 technical service bulletins and manufacturer communications cover the 2013 Mercedes-Benz E207.
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Various fault codes present in TPM Control Unit, vehicles with code 475 and code B03
- Seat cushion fore/aft adjuster seat cushion cover becomes detached
- Seat belt extender toothed rack sluggish or makes noises
- Info-Call/S24H-Call/MB Contact: Change of language setting at customer request
- Display of suspension setting in head unit implausible
- Liftgate intermittently does not open fully
- Noise in area of steering column after conducting service measure 1709P46C60 "Check mechanical steering...
- Message "SOS
- Garage door opener cannot be programmed
- Garage door opener range too short
- Garage door opener loses programming
- Comand
- Comand
- Garmin MAP PILOT: Traffic information service and possibly voice control inoperative after navigation...
- Message in instrument cluster "Collision Prevention Assist Inoperative"
- Replace Driver-Side and (if applicable) Front Passenger Air Bag
- Red display message in instrument cluster "Power Steering Malfunction
- Quiescent current in seat control unit
- Head restraint adjustment faulty
- Garmin MAP PILOT: General information in the event of complaints
- Rattling noises in area of 2-stage turbocharger, OM651
- Garmin MAP PILOT: Notes on voice input
- Vehicle wanders to the left or right.
- Check Right A-Pillar Seam Seal, Rework if Necessary
- Audio 20: Music does not continue automatically after a call
- Sloshing noises from area of rocker panels/ longitudinal members
- Headlamps fogged
- Facebook app cannot be opened
- Engine noises after engine start
- Becker MAP PILOT: Navigation display freezes briefly in the case of physical shocks
- Check Engine Light (CEL) on, DTC fault code(s) concerning throttle valve actuator
- Engine diagnosis warning lamp lights up in instrument cluster, fault code U145400: "Implausible data were...
- Front window drops down after closing
- IPhone mobile phone: Various complaints after software update to iOS8
- Drive Kit Plus: Digital DriveStyle app does not launch automatically
- The pneumatic 4-way lumbar support fails
- Pneumatic comfort systems with insufficient performance, entirely inoperative or leaky.
- Selector lever blocks in position "P" (brake applied)
- Creaking noise when adjusting electrical steering column
- Engine noises (rattling) after engine start
- Complaints about poor wiping effect of winshield wiper
- SENTEX gate operator with Clik Card Remote not compatible with Homelink
- Seat belt adjustment intermittently inoperative and causes noises.
- Procedure in case of slight oil traces on TRANSMISSION 722.9
- Active Blind Spot Assist intermittenly inoperative
- M276 MY2013 and MY2014
- Engine diagnosis warning lamp active
- Warning message in instrument cluster
- Collision Prevention Assist warns without obvious
- Audio/COMAND display: Sporadic failures of central display
- AIRCAP functions excessively
- Flashing or SCN coding of airbag control units
- Friction power of torque converter lockup clutch is too high (FC 2783) or actuation of torque converter...
- Procedure in case of slight oil traces on TRANSMISSION 722.9 with CODE B03
- Fault code P045600 or P044200 without complaints about engine running characteristics
- Check Seam Seal at Trunk
- Sloshing noises from area of rocker panels/ longitudinal members on left and right.
- Air conditioning intermittently does not cool.
- Apple products (iPhone or iPod) are not charged via the serial USB interface of the COMAND Online control...
- The vehicle cannot be started The vehicle may start by itself shortly after the startup attempt with a...
- Single throttle lift-off clunking noise from the side shaft when moving off (audible at the outboard end)
- Creaking noise when making vertical or longitudinal adjustment to electrical steering column
- Battery discharged, vehicle does not start.
- The 360° camera cannot be calibrated.
- Collision Prevention Assist (CPA) may warn for no obvious reason (optical and acoustic warning message).
- Surface damage on steering wheel trim
- Fault code U41600 logged in 'ES' (electric steering) control unit after software update or steering gear...
- Engine diagnosis warning lamp active
- This Customer 1 Action has been initiated because certain mbrace subscribers were recently contacted by...
- The key is not recognized in the electronic ignition switch, the vehicle cannot be started and/or the...
- Engine diagnosis warning lamp lights up
- Message in instrument cluster "DISTRONIC PLUSCurrently Unavailable
- This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz...
- Creaking/squeaking noises from the front axle when steering
- Shift quality complaints and/or automatic transmission in limp-home mode in combination with fault codes...
- The Parktronic system switches to malfunction
- Comand online: mute function no longer active after a restart
- Comand online: intermittently no audio output after engine start.
- FC 2783 (Friction power of torque converter lockup clutch is too high) or FC 0741 (Actuation of torque...
- Shift quality complaints and/or automatic transmission in limp-home mode in combination with one or more...
- The side air vents in the instrument panel may be reflected in the side windows in sunlight
- Single, throttle lift-off, clunking noise from the side shaft when starting off (audible at the wheel)
- Customer experiences low battery conditions, resulting in jump starts, and eventually requiring battery...
- Engine diagnosis warning lamp activated
- 1. Noises when operating electric seat fore/aft adjustment 2. Electric fore/aft adjustment nonfunctional...
- Switch for seat belt extender inoperative.
- Glove box squeaks/rattles at top left mounting.
- The COMAND unit does not start or the COMAND display remains dark
- If it is necessary to replace an HV battery, the return will only be accepted with the filled-out...
- Engine does not start, or various fault messages in instrument cluster immediately after engine start and...
- Harsh 4-3 and/or 4-5 shifts may be experienced, usually more noticeable with light throttle drivers
- Engine makes intermittent knocking noise, ticking/crackling
- Front seat backrest trim protrudes
- Sound: Poor audio quality after software update of sound amplifier
- Malfunctions of various control units and/or on-board power supply problems caused by water in the control...
- Mobile phone in general: The driver is sometimes poorly understood by the receiver, background noise is...
- Comand
- Garage door opener cannot be programmed or the range is too short
- Audio 20: No navigation, language set to English, Media Interface inoperative
- Blue smoke from exhaust after engine start
VIN decoder
See the problems and recalls for an exact car
Buying a used 2013 Mercedes-Benz E207?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history