Check a VIN

2020 Mercedes-Benz GLC 300: engine failure

5 of the 70 complaints about the 2020 Mercedes-Benz GLC 300 describe engine failure.

owner complaints
5
of this car's complaints
7%
recalls
1
Is there a fix? There is 1 recall and 14 service bulletins for this area of the car. See below

Engine failure by model year

What owners say

Filed Jun 25, 2026 · Engine, Transmission · CA

My 2020 Mercedes-Benz GLC 300 triggered check engine light with code P06DA (engine oil pressure control) at 40,000 miles. The failed component is an oil pressure control sensor/solenoid worth approximately $200. However, due to Mercedes-Benz's engine design (M264 engine), the entire engine must be removed from the vehicle to access and replace this part. Repair estimate from authorized Mercedes-Benz dealership (Mercedes-Benz of Stevens Creek): $8,391. SAFETY CONCERN: Loss of oil pressure can cause catastrophic engine failure while driving. Engine seizure at highway speeds poses serious risk of loss of vehicle control, potential accident, and harm to occupants and other drivers. This is a known, widespread design defect affecting Mercedes-Benz vehicles equipped with M264/M274 engines across multiple model lines: GLC 300 (2019-2023) C 300 (2019-2023) E 300 (2019-2023) GLC 43 AMG, C 43 AMG GLB 250, A 220, CLA 250 Mercedes-Benz's own authorized dealership confirmed they are "seeing this issue more and more." Despite awareness of this widespread defect, Mercedes-Benz has not issued a recall or Technical Service Bulletin. The design makes repair financially prohibitive ($8,000+), meaning many owners continue driving with compromised oil pressure — creating an ongoing safety hazard on public roads. Mercedes-Benz refused to repair under goodwill, then denied repurchase after 30-day review. They have left consumers with no remedy for a known safety-related design defect. I am requesting the federal safety agency investigate this as a safety defect affecting potentially hundreds of thousands of vehicles.

Filed Dec 8, 2025 · Engine · CT

The engine in my 2020 Mercedes-Benz GLC 300 suddenly malfunctioned while driving on two separate occasions. The vehicle began shaking violently and lost power without warning. I could not accelerate and had to pull over immediately. I turned the vehicle off and restarted it to regain limited driveability. On the second incident, the power loss was so abrupt that it felt as if I had been rear-ended. I feared the vehicle would stall in traffic and cause a crash. Following these events, the check engine light remains constantly on. The dealer inspected the vehicle and confirmed excessive valve leakage into the exhaust system, requiring a complete cylinder-head replacement. They warned the failure will worsen and could result in sudden power loss again. This defect poses a serious safety risk. If the power loss occurs while merging or at highway speeds, it could easily lead to a rear-end collision. The vehicle has relatively low mileage for such a severe internal engine failure, and I have learned that other owners of this same engine have reported similar issues. Sudden stalling or loss of acceleration places occupants and other drivers in danger. There were no warning messages prior to the failure, and the problem has recurred. The vehicle is available for inspection, and the defect has been confirmed by a Mercedes-Benz service center. This appears to be a mechanical defect in the engine design, potentially involving valve seat failure. An investigation is needed to determine if this issue is widespread and whether a recall or manufacturer action is required to prevent accidents or injuries.

Filed Dec 3, 2025 · Engine · GA

My 2020 Mercedes-Benz GLC 300 experienced a complete engine failure at ~51,000 miles, shortly after a major repair for a known defect. Initially, the vehicle showed a misfire on cylinder #3, which was diagnosed at RBM of Alpharetta as low compression due to valve seat damage, matching MB TSB LI01.30-P-072328. The cylinder head was replaced in Aug 2025. About two months later, while driving under normal conditions, the vehicle made a loud cranking/knocking noise and completely stalled in traffic without any check engine light or warning. This sudden stall posed a serious safety risk. The vehicle was towed to the same dealer, who has now diagnosed the engine as fully seized and recommended a complete engine replacement. I had also completed the 50,000-mile scheduled service at the same dealer shortly before this failure. Despite this being clearly linked to a known design defect, Mercedes-Benz USA has declined to provide further assistance or goodwill coverage. I am reporting this to highlight both the mechanical failure and the safety risk—this engine seizure occurred without any prior warning lights and could have resulted in a crash. I believe this reflects a systemic failure with the M264 engine in GLC 300s, affecting vehicle reliability and road safety. MBUSA has not provided a written explanation for their denial. I am concerned this issue may affect other GLC 300 owners and deserves investigation or recall consideration.

Filed Feb 4, 2025 · Engine · CA

The check engine light illuminated, I took the car to the dealer I bought. They said the cylinder head on the engine needs to be replaced, when I check the internet it seems it is a known issue for Mercedes X253 but there is not a recall program. I bought the car from the dealer, and put on 5k miles in a year.

Filed May 2, 2024 · Engine · IL

Engine failure needs cylinder head replaced which is very common amongst this car. Same make and model is covered under warranty but mine has a different engine that isn't covered. These cars were made during covid and have faulty parts.

Service bulletins that may apply

Related recalls

Engine and engine cooling: engine: gasoline: turbo/superchargerReported June 22, 2020 · 90 vehicles affected
What is wrong
Mercedes-Benz USA, LLC. (MBUSA) is recalling certain 2020 C300, E350, and GLC300 vehicles equipped with turbocharged 4-cylinder gasoline engines. The screws that retain the turbocharger oil feed and return lines may not have been properly tightened, possibly resulting in an oil leak.
Risk
An oil leak in the presence of an ignition source such as hot engine or exhaust components can increase the risk of a fire.
Remedy
MBUSA will notify owners, and dealers will inspect the turbocharger oil lines and tighten them as necessary, free of charge. The recall began August 17, 2020. Owners may contact MBUSA customer service at 1‑800‑367‑6372. MBUSA's number for this recall is 2020070017.

Recall number 20V364000 · Recall details

Questions about the 2020 Mercedes-Benz GLC 300 engine failure

Is engine failure a common problem on the 2020 Mercedes-Benz GLC 300?

5 of 70 owner complaints about the 2020 Mercedes-Benz GLC 300 (7%) mention engine failure. The model year with the most reports is 2016.

Is there a recall or service bulletin for this on the 2020 Mercedes-Benz GLC 300?

There is 1 recall and 14 service bulletins for the same area of the car. Check them below with your VIN.

Other symptoms on the 2020 Mercedes-Benz GLC 300

Check engine light 13Headlights 6Misfire 6Stalling 6Loss of power 5

All model years of the Mercedes-Benz GLC 300

VIN decoder

See the problems and recalls for an exact car

Buying a used 2020 Mercedes-Benz GLC 300?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history