2004 Mercedes Benz SL Class problems

What is wrong

Mercedes-benz is recalling my 2006-2008 m-class, r-class, my 2005-2009 slk-class, my 2005-2008 c-class, my 2003-2004 and 2006-2008 clk-class, my 2003-2008 e-class, my 2004 and 2008 cl-class, my 2008 cls-class, my 2004 and 2007-2008 s-class, my 2003 g-class, and my 2003-2004, 2006 and 2009 sl-class vehicles. A software calibration number (scn) coding received on the affected vehicles during a recent workshop visit was incorrect. Depending on the model year and model affected, the results of an incorrect scn coding can affect a number of vehicle safety and emission functions including the following types of functions: (1) the fuel gauge readings may be incorrect; (2) a stuck fuel-level sensor may not be displayed in the instrument cluster; (3) the obd system may cause the check engine light to illuminate incorrectly; and, (4) the speedometer may be out of tolerance.

Risk

In the event of a vehicle crash, the electrical fuel pump may not receive a crash signal that is required for the fuel pump to disconnect and prevent future fuel delivery as designed.

Remedy

Dealers will recode the scn free of charge. The recall began on august 30, 2008. Owners may contact mercedes-benz at 1‑800‑367‑6372.

Recall number 08V303000 · Recall details

What is wrong

On certain vehicles, the sensotronic brake control (sbc) system may prematurely shift to the hydraulic back-up function mode, due to deterioration of the wiring harness connection, or due to premature failure of the hydraulic pump.

Risk

In the hydraulic back-up mode, the driver has braking power sufficient to stop the vehicle, although greater brake pedal pressure is required and the brake pedal travel will be noticeably longer.

Remedy

Dealers will install a bracket and replacement ground wire to the sbc pump unit on all vehicles free of charge. Additionally dealers will inspect and replace the sbc pump unit in sl vehicles produced during a limited production period. The recall began on august 8, 2005. Owners may contact mercedes-benz at 1‑800‑367‑6372.

Recall number 05V133000 · Recall details

What is wrong

On certain vehicles, the electronic monitoring system of the sensotronic brake control (sbc) is designed to monitor the pressure gradient within the high pressure line of the brake system. If an unacceptable pressure gradient is detected, the system will switch, as it is designed to do, into the hydraulic function mode.

Risk

If vehicles are not routinely serviced and have extremely high mileage combined with a high number of brake actuations, or a high brake actuation frequency, the pump motor of the sbc may run out of permissible tolerances, thereby triggering the hydraulic function mode.

Remedy

Dealers will inspect the sbc hydraulic unit, replacing it if necessary. The recall began on october 21m 2004. Owners should contact mercedes-benz at 1‑800‑367‑6372.

Recall number 04V296000 · Recall details

The subject s-class vehicles contain a compressed air suspension system that uses air struts on each of the four wheels in lieu of traditional springs and shock absorbers.these air struts use compressed air to support the weight of the vehicle and control ride height.in the event of the loss of air from the system, an alert will flash on the instrument cluster warning the driver to either drive carefully or to stop the vehicle.the vehicle ride height can be reduced by as much as 105 mm below normal ride height before the full load of the vehicle for that wheel comes to rest on a steel rod, with a rubber stop on the end, located in the shock absorber.this rest-stop condition is designed such that there is no impact on vehicle control.mercedes-benz (mbusa) supplied video showing a vehicle in this condition operating under several different situations including evasive maneuvers demonstrating the ability of the vehicle to be controlled effectively with a ride height reduced to the minimum.only those complaints to odi and mbusa that alleged a steering interference during a reduced ride height condition were counted in this resume failure report.some complaints alleged that with a reduced ride height and a stop now warning message there was a rubbing noise when turning, but the ability to steer the vehicle was not compromised.a sampling of warranty claims submitted by mbusa did not reveal any indicating a loss of control due to an airmatic system failure.there was one crash reported by mbusa to odi but the information available indicated that it related to suspension systems and it was not possible to verify that the incident was related to an airmatic system failure. Further use of agency resources in this matter does not appear to be warranted.the agency will continue to monitor complaints and other information relating to the alleged defect in the subject vehicles and will take further action in the future if warranted.this preliminary evaluation is closed.

PE07042