Regarding: the federal safety agency recall number 14v‑284, ford recall number 14s05 electric power steering the recall instructions to dealers call for a signal test and either reprogramming a sensor or replacing the torque sensor based on the results. It also calls for replacing the torque sensor upon failure if the failure occurred before the vehicle had the recall sensor performed. The recall instructions to dealers also tells them that a torque sensor that fails after the reprogramming was done is not covered by the recall. The purpose of the sensor reprogramming was to initiate a warning in the driver control center upon imminent sensor failure, but does nothing to fix, repair or replace the defective part. I had the dealer perform the test and software upgrade and was under the mistaken impression that the recall was to actually replace the statistically faulty part , and not just a potential warning. The electric power steering on my vehicle failed on 4-12-2018 and, incidentally, I did not get a warning on the driver information center before the failure; so the reprogramming did nothing for my vehicle. My question is why is ford/mercury not required to replace the failed sensors that are the subject of the recall? I understand ford not being required to replace sensors that might fail but giving drivers notice of imminent failure, but ford should be required to replace sensors that do fail even after the reprogramming because the reprogramming is not intended to fix the problem just warn drivers. The sensor replacement is nearly a $2000 repair that I believe should be covered by the recall. Can the federal safety agency explain the rational for not requiring ford to actually fix the defect that causes a serious hazard?
2011 Mercury Mariner steering complaints
Page 2 of 2: complaints 11 to 20 of 20, newest first, as owners wrote them.
While driving on i90, recently noticed noise in steering column which has gotten progressively worse and steering wheel now shakes. Taken to ford dealer was told it was atorque angle steering sensor. Fix about $500 unless the steering column is broken! Fix then 1530. How does a steering column break? Recall 14s05 for steering problem. Supposedly if this was fixed ford is released from any recall dealing with steering if it has been replaced. Apparently ford omitted this info from the public just wondered if I have any recourse to resolve this. Ford dealer says no recall. Ford company says this is not under recall as I had prior recall taken care of. There are numerous other complaints regarding this vehicle and the same exact problem with the exact same outcome. I have had other problems with ford products resulting in hospitalization and haven't done anythingg I can not allow this one to go unnoticed. Thank you
Ford has not fixed the issue! Vehicle was taken in do you do recall my previous owner and only software was updated pertaining to the power steering recall. It is not a software update issue. The torque sensor must be replaced. Ford will not cover nor reimburse this issue. Many other customers are having this exact same problem. The power steering assist goes out without warning and makes the vehicle very dangerous to drive. I was driving my vehicle this morning and out of nowhere the turning became very difficult.
Tl* the contact owns a 2011 mercury mariner. When the contact attempted to drive the vehicle, the steering wheel failed to turn and the power steering assist warning indicator illuminated. The vehicle was taken to an independent mechanic where it was diagnosed that the torque sensor needed to be replaced. The vehicle was not repaired. The vehicle was not taken to a dealer. In addition, the contact stated that the vehicle was once repaired per the federal safety agency campaign number: 14v284000 (steering); however, the failure recurred. The manufacturer was notified of the failure and informed the contact that the recall was a one time repair. The approximate failure mileage was 140,000.
Power steering assist will go out without warning causing the car to lose it's power steering and may even lock up totally.this has happened repeatedly since june of 2017 and has gotten progressively worse. We had to repair it in december of 2017 at a cost of $1500.00.
Tl* the contact owns a 2012 (na) mercury mariner. While attempting to drive the vehicle, the contact heard a loud abnormal sound and the steering wheel seized. The vehicle was towed to a dealer where it was diagnosed that the bins, gears, and steering column failed and was repaired. The manufacturer was made aware of the failure and informed the contact that there was no recall for this failure. The failure mileage was approximately 147,500.
Tl* the contact owns a 2011 mercury mariner. While driving approximately 35 MPH and attempting to make a turn, the steering ability seized. The vehicle struck a curb and was towed to the dealer where it was diagnosed that the steering column needed to be replaced. The vehicle was being repaired at the owner's expense. The manufacturer was notified of the failure. The contact also stated that the vehicle was repaired last year per an unknown recall for the steering module. The VIN was unknown. The approximate failure mileage was 129,000.
I was driving my vehicle at a low rate of speed on a city street on 10/16/15 and as I turned a corner, about to pull into a driveway, there was a complete loss of power steering ! The vehicle was very difficult to control and it took all my strength in both arms to complete the turn and pull into the driveway safely. The vehicle was towed to crest ford dealership in flat rock, mi and the diagnostic code they detected indicates they need to replace the entire steering column and is supposed to be covered under ford's recall 14s05. Dave in their service department took what he described as "the first step" by sending an email to request that this repair service be performed under the recall. It was denied by ford because a different code, also covered by this recall, was addressed by liberty ford in brunswick oh on 5/11/15 (at which point they updated the power steering control module). I contact ford customer service myself on 10/19/15 and was told that the "program had been closed" on my vehicle because service under the recall has already been performed. It's ridiculous that they aren't now going to service the additional problem that has occurred and is supposed to be covered by this recall!
I went to my mechanic with a steering problem, and it was part of the torque sensor issues that was recalled. My car falls in those dates but there is no recall on my VIN for that part. And I don't get why.
Driving at 40 MPH car stalls, pull over, car starts up engine lite on, (sat) take to dealer on mon (12/15/2014), explain to dealer, they call 3 hours later to say "purge valve needs to be replaced"ok this should be covered right? She says no! The cost to you will be $320.33. I told her this is part of the emissions, it has to be, she said no its not! I purchased this car from this dealer 3 1/2 years ago, (bought is new) still underwarranty.. But this is not covered! The 800 number to fords blew me off! And said what the dealer says goes!>. Why did she suggest I call them then! (not good customer service) I was hoping for explanation! Please help, this should be covered. Look at your on line complaints about this! Shame shame shame. Of course I paid it, I need my car! Please note I was told that there were at 5 or more cars with the same/similar problem.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2011 Mercury Mariner?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history