I was driving home from work when the car started to violently shudder. I took my foot off the accelerator and it stopped, only to happen again when I resumed pressing the gas. This also causes the car to suddenly slow down somewhat dramatically. The tachometer also "bounces". I purchased this vehicle used and drove it for 6 or 7 months with no issues before this happened. I took I to a local mechanic who immediately identified it as the transmission. A check engine light came on and intermittently goes out and back on. This happened after the shuddering started. The problem is easily repeated just by simply driving the car. It has not been inspected by anyone other than the mechanic I took it to.
2016 Mitsubishi Outlander: shudder or vibration when accelerating
7 of the 145 complaints about the 2016 Mitsubishi Outlander describe shudder or vibration when accelerating.
- owner complaints
- 7
- of this car's complaints
- 5%
- recalls
- 1
Shudder or vibration when accelerating by model year
- 20221
- 20171
- 20167
- 20151
- 20081
What owners say
I think the problem it’s on the transmission as the car is presenting hesitation and shuddering when accelerating, also it’s presenting rev fluctuations when driving at a constant speed, fortunately my safety and the safety of others is good until now. Yes the problem has being confirmed, no the vehicle has not being inspected by by the manufacturer, police, insurance representatives, there wasn’t any indication or warnings prior to the failure.
The contact owns a 2016 Mitsubishi Outlander. The contact stated while driving approximately 40 MPH, the vehicle began to shake and the contact felt a shuddering in the steering wheel. The contact began to feel a loss of power and depressed the accelerator pedal however, the vehicle did not respond. The contact stated no warning light was illuminated. The contact drove the vehicle to an independent mechanic where the vehicle was diagnosed and the mechanic retrieved DTC: P084A. The mechanic determined that the transmission needed to be replaced. The vehicle was not repaired. The manufacturer had been informed of the failure. The failure mileage was approximately 86,000.
When driving my 2016 Mitsubishi Outlander SE down the highway last week my car began to make a shudder like feeling when I stepped on the gas. When attempting to accelerate my car my RPMs jumped and then dropped significantly making the car shake and not accelerate and instead the speed declined. I was on the highway driving and feel very fortunate that no one was behind me when my car jerked causing them to possibly rear end me and I am glad that my car did not jolt forward hitting the person in-front of me but it was a very real possibility. My car is around 98,000 miles and has had every oil change and maintenance it has needed on time and I am the second owner of this car. No check engine light or anything came on while my car was practically breaking down on the highway and there was no warning. The next day the check engine light came on for about 10 mins and then cleared itself even though the car was continuing to shake and drop and rev RPMS. I took my car to an automotive place and they told me I would need to have a new transmission put in the car and he thought I had very low miles to be having this issue and because the engine light was no longer on he test drove the car and confirmed and ran the error code in the history. After some research I noticed that there was a recall in 2016 for the transmission of my car 16v563000 stating that there is a delay in the transmission and the consequence could cause a crash and to fix the problem "software needed to be upgraded" I asked North America Mitsubishi for a report of the specific work done to the transmission to provide to my mechanic. They stated they cant do that and I don't need it and can get my transmission done at Mitsubishi where they can see the previous work done for the recall. There is a technical service bulletin for this issue its so common, I am 1 year over the 5 yr warranty and they say I have to pay for a new transmission. I was told theres no recall and nothing they can do.
Vehicle exhibits a shudder/surge condition (engine flare, lack of acceleration, and/or car shake) possibly caused by poor reaction of the hydraulic pressure circuit. The CVT belt slips repeatedly when accelerating, causing a warning light to turn on with DTC P084A. The vehicle exhibits exactly the conditions described in TSB-20-23-001 and is explicitly included in the affected vehicles section the bulletin (2015-2020 Outlander Sport with 2.0L Engine with CVT transmission). The conditions were confirmed using Diagnostic Procedure 2 on TSB-20-23-001 by certified mechanic at Meineke Car Care Center (Lexington, SC). However, VIN was not included in the recall as confirmed by MMNA service representatives. The scope of TSB-20-23-001 does not sufficiently cover all vehicles affected by the recall condition, as Mitsubishi excluded some vehicles for undisclosed reasons. Because Mitsubishi had previously failed to trace and identify all affected vehicles in its initial recall for this unsafe condition in TSB-17-23-002, it is possible or likely that Mitsubishi failed to trace or identify all affected vehicles in TSB-20-23-001. The scope should be expanded to all vehicles with CVT transmissions in the model years listed in the bulletin, without exception.
The contact owns a 2016 Mitsubishi Outlander. The contact stated her daughter was driving 50 mph and became aware that the RPM gauge was fluctuating. The contact stated that the vehicle started shuddering and shaking, then stalled. There was no warning light illuminated. The driver waited a few minutes and then was able to restart the vehicle and continued to drive however, the failure persisted. The vehicle was taken to the local dealer to be diagnosed. The contact was informed that the transmission failed the pressure test and needed to be replaced. The vehicle was not yet repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 96,000.
I have a 2016 mitsubishi outlander with a 2.4l engine and the jatco CVT transmission and only 75,000 miles. The transmission started shifting erratically and shuddering when going certain MPH ranges typically between 45 and 60 MPH. Additionally, the vehicle hesitates to go when the accelerator is pressed. From a stop, it takes 5 seconds for the vehicle to go once it is put in drive. I have a trouble code on my obd of p084a. This has been dangerous to my family on multiple occasions when attempting to pass a car on the road and the vehicle does not accelerate immediately. My wife also got stuck in the middle of an itersection because the vehicle hesitated for around 5 seconds before accelerating. Mitsubishi has a service bulletin for this vehicle, number tsb-17-23-002 that covers exactly what is happening in my vehicle and even has an ecu reprogram that will prevent the problem from happening in the future. The problem is a service bulletin does not cover the costs of affected vehicles out of warranty. This is a dangerous and common defect with this vehicle and transmission and mitsubishi it needs to be a recall before someone gets hurt or killed.
Service bulletins that may apply
- Service Manual Revision
- Service Manual Revision
- Service Manual Revision
- This Technical Service Bulletin provides service manual corrections to the CVT maintenance procedure.
- This TSB provides the addition of Diagnostic Procedure for CVT Belt Check for vehicles equipped with CVT...
- This Technical Service Bulletin was sent to dealers directing them to diagnose and test drive customer...
- This Technical Service Bulletin supersedes TSB-20-23-001, issued April, 2020, to update the Control Valve...
- Shudder or surge condition possibly caused by poor reaction of the hydraulic pressure circuit
Related recalls
Power train: automatic transmission: control module (TCM/PCM/tecm)
- What is wrong
- Mitsubishi Motors North America, Inc. (MMNA) is recalling certain model year 2015-2016 Outlander Sport vehicles and 2016 Outlander and Lancer vehicles. The affected vehicles are equipped with a constant velocity transmission (CVT) that, in certain driving conditions, may cause a delay in the vehicle accelerating.
- Risk
- A hesitation during acceleration can increase the risk of a crash.
- Remedy
- MMNA has notified owners, and dealers will reprogram the CVT control unit with modified software, free of charge. The recall began on August 15, 2016. Owners may contact MMNA customer service at 1‑888‑648‑7820. MMNA's number for this recall is SR-16-006.
Recall number 16V563000 · Recall details
Questions about the 2016 Mitsubishi Outlander shudder
Is shudder or vibration when accelerating a common problem on the 2016 Mitsubishi Outlander?
7 of 145 owner complaints about the 2016 Mitsubishi Outlander (5%) mention shudder or vibration when accelerating. The model year with the most reports is 2016.
Is there a recall or service bulletin for this on the 2016 Mitsubishi Outlander?
There is 1 recall and 16 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2016 Mitsubishi Outlander
Hesitation 20CVT failure 16Transmission failure 13Check engine light 11Headlights 11Jerking 10Stalling 10Slipping 9No deployment 7
VIN decoder
See the problems and recalls for an exact car
Buying a used 2016 Mitsubishi Outlander?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history