Check a VIN

1996 Mitsubishi Spyder problems

The most common problem on the 1996 Mitsubishi Spyder is body and structure. It has fewer complaints than a typical Spyder model year.

Typical yearClose to a typical year
Owner complaints
2
Recalls
2
Service bulletins
9
Worst area
Body

The worst 1996 Mitsubishi Spyder problems

Ranked by number of owner complaints. Mileage and cost come from what owners wrote.

  • Body
    2

Problems by type

Tap a problem to see which part fails, at what mileage and in which other years.

  • Body
    2

Recalls 2

Suspension: front: control arm: lower ball jointReported December 18, 2000 · 567,432 vehicles affected
What is wrong
Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water can intrude. Also, mmc has added the potential of leaking moisture, which can cause the ball stud to corrode.
Risk
This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash. This campaign supercedes mmc's previous safety recall campaign, see 99v‑066.
Remedy
Dealers will inspect the lower lateral arm ball joint for wear. Ball joints that exhibit wear beyond the established tolerance will be replaced with newly designed lateral arm ball joints. Ball joints that are within the established tolerance will be cleaned and a special sealant will be applied to prevent intrusion of moisture.

Recall number 00V421001 · Recall details

Suspension: front: control arm: lower ball jointReported April 5, 1999 · 307,000 vehicles affected
What is wrong
Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water can intrude.
Risk
This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash.
Remedy
Dealers will inspect the rubber boots, and if the boot is damaged, they will replace the lower lateral arm and ball joint on the affected vehicles.

Recall number 99V066001 · Recall details

See all 2 recalls for the 1996 Mitsubishi Spyder

Technical service bulletins for the 1996 Mitsubishi Spyder 9

Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.

See all 9 bulletins for the 1996 Mitsubishi Spyder

What 1996 Mitsubishi Spyder owners say

Most recent owner complaints, unedited.

Filed Apr 1, 2001 · Body · GA

Convertible top frame warped not allowing the top to fully open without locking up. First incident was within one month of purchase and dealer adviced, in writing, to bring vehicle in due to defect problems with top of that model. After supposed repair top continued with same warping problem and manufacturer refused to repair at no cost.

Filed Mar 14, 2000 · Body · PA

My convertible top the side braces where the top folds back bend.

Compare the 1996 Mitsubishi Spyder

Other model years

19961998200120022003

Questions about the 1996 Mitsubishi Spyder

Is the 1996 Mitsubishi Spyder reliable?

Owners have filed 2 complaints about the 1996 Mitsubishi Spyder, fewer than a typical Spyder model year.

What is the most common problem with the 1996 Mitsubishi Spyder?

Body and structure, with 2 complaints.

How many recalls does the 1996 Mitsubishi Spyder have?

2 recalls, covering suspension.

Share your experience with the 1996 Mitsubishi Spyder

Tell other buyers what went wrong and what it cost. We review every report before it appears, and we never publish names, emails or VINs.

No names, contact details or links. Reports about a dealer or a person are not published.

VIN decoder

See the problems and recalls for an exact car

Buying a used 1996 Mitsubishi Spyder?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history
Is this car on a recall?Check VIN