The contact owns a 2003 Nissan Maxima. The contact stated while driving at an undisclosed speed, the check engine warning light remained illuminated. Additionally, while driving approximately 20 MPH, the vehicle stalled. The vehicle was later towed to the residence. The cause of the failure was not yet determined. The local dealer and manufacturer were not contacted regarding the failure. The failure mileage was 225,000.
2003 Nissan Maxima: engine stalls while driving
38 of the 206 complaints about the 2003 Nissan Maxima describe engine stalls while driving.
- owner complaints
- 38
- of this car's complaints
- 18%
- typical mileage
- 115,000
- recalls
- 1
Engine stalls while driving by model year
What owners say
The car has stalled when stopped and while driving. Slip light and tsp warning lights go on along with service engine. I noticed the recall from 2003 was for similar problems. However I put in my VIN # and I'm assuming my car does not apply. Very very dangerous. My young daughter was driving when it died. Would like to know if repairs would be covered under previous recall.
Tl* the contact owns a 2003 nissan maxima. The contact stated that the vehicle stalled while attempting to exceed 3,000 RPM. The contact stated that while idling, the vehicle stalled while stopped at a traffic light. The contact shifted the transmission to neutral and the vehicle remained on. The vehicle was taken to an independent mechanic and the contact was informed that the VIN was subjected to the federal safety agency campaign number: 03v455000 (engine and engine cooling). The vehicle was not repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 143,000.
Car stalls at lights and just stops running while driving down the street. The stalling problem has been going on for years but the car stalling while driving down the road is fairly new. Stalls at ligfhts, stalls while in motion
Tl* the contact owns a 2003 nissan maxima. While driving 35 MPH up a hill, the vehicle stalled and the service engine indicator illuminated. The vehicle was taken to an independent mechanic who diagnosed that the cam sensor shaft needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and did not assist. The failure mileage was approximately 120,000.
Tl* the contact owns a 2003 nissan maxima. The contact stated that while driving at an unknown speed and stopped at a traffic light, the vehicle stalled. The vehicle was taken to dealer to be diagnosed. The contact was informed that the crankshaft position sensor needed to be replaced. The vehicle was not repaired. The vehicle was not included in the federal safety agency campaign number: 03v455000 (engine and engine cooling). The manufacturer was notified of the failure. The approximate failure mileage was 97,000.
I recently purchased a 2003 nissan maxima that was maryland state inspected. I drove it for about a week when I was driving along on a busy road and the car stalled in the middle of the roadway. Luckily, nobody was injured or hit the stalled car. The car had to be towed to the nissan repair shop. It was diagnosed with two defective camshaft sensors. I found out that this part was recalled under nissan's recall program, so I called them to see if they would replace the part. They refused to cover the cost of the replacement of the part even though they replaced these parts before under your recall.
Tl* the contact owns a 2003 nissan maxima. While driving 45 MPH, the vehicle stalled without warning. On some occasions, the check engine light would illuminate after the vehicle stalled. The failure recurred on several occasions. The vehicle was not included in the federal safety agency campaign number: 03v455000 (engine and engine cooling). The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was not available. Updated 09/08/16*lj updated 09/29/16.8jb
Vehicle stalls at random, rough/no start, loss of power, engine light/code shaft sensor. Same symptoms as recall for this year our VIN wasn't included in the list of recalled vehicles.
Tl* the contact owns a 2003 nissan maxima. While driving approximately 25 MPH, the vehicle stalled and the check engine warning light illuminated. The vehicle was restarted; however, the failure recurred. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The VIN was not included in the federal safety agency campaign number: 03v455000 (engine and engine cooling). The failure mileage was 147,000.
Tl* the contact owns a 2003 nissan maxima. While driving at various speeds, the engine stalled without warning. The vehicle was taken to the dealer where it was diagnosed that the vehicle's title was re-worked; therefore, the dealer was not obligated to perform any recall or warranty work on the vehicle. The vehicle was not repaired. The VIN was not included in the federal safety agency campaign number: 03v455000 (engine and engine cooling). The manufacturer was made aware of the failure. The failure mileage was unknown.
The vehicle stalled when it was driven at speed of 20 to 35 MPH. The warning light on and the car can start again after the gear changed to neutral. It has been happened two times in a month and then mileages is 114000 miles. The nissan workshop can't figure out it dues to camshaft sensor problem.
Service bulletins that may apply
- Free Oil Change Specific Vehicles Subject to the Takata Recall Detailed Information To help accelerate...
- MIL on with DTC U1000 or U1010 stored in engine control unit. tt
- Engine oil cooler gasket available. tt
- Malfunction indicator lamp on with diagnostic trouble code U1000 or U1010 stored in engine control unit. ak
- Engine will not start. nissan vehicle immobilizer system / nissan anti-theft system (nvis/nats)...
- Engine will not crank (no start) with outside temperature below 0 degrees f. tt
- Engine cover logo replacement. tt
- Hesitation on acceleration with manual transmission. tt
Related recalls
Engine and engine cooling
- What is wrong
- On certain passenger vehicles, the circuit board for the crank position sensor or cam position sensor may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process.
- Risk
- This could cause the "service engine soon" warning light to come on, create a no start condition, cause reduced engine power, or cause the engine to stop running without warning during vehicle operation, which could result in a crash.
- Remedy
- Dealers will replace the crank position sensors. Camshaft position sensor(s), and in some cases, the variable timing control sensor(s). Vehicles involved in a previous recall campaign, 01v357, are also included in this new campaign. The replacement sensors used in that campaign are also affected. Owner notification began on december 22, 2003. Owners should contact nissan at 1‑800‑647‑7261 or infiniti at 1‑800‑662‑6200.
Recall number 03V455000 · Recall details
Questions about the 2003 Nissan Maxima stalling
Is engine stalls while driving a common problem on the 2003 Nissan Maxima?
38 of 206 owner complaints about the 2003 Nissan Maxima (18%) mention engine stalls while driving. The model year with the most reports is 2004.
Is there a recall or service bulletin for this on the 2003 Nissan Maxima?
There is 1 recall and 9 service bulletins for the same area of the car. Check them below with your VIN.
Other symptoms on the 2003 Nissan Maxima
Check engine light 34Headlights 25Won't start 10No deployment 7Loss of power 6Airbag light 5
VIN decoder
See the problems and recalls for an exact car
Buying a used 2003 Nissan Maxima?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history