My 2020 Nissan Sentra began experiencing repeated episodes of unexpectedly stalling and shutting off at stoplights and stop signs. The vehicle would also jerk, shake while idling, and experience fluctuating RPMs. An oil-pressure warning light appeared during these incidents. The cause of the malfunction remains unknown. Before taking the vehicle to a Nissan dealership, I had the mass airflow sensor replaced, along with an oil change and throttle-body cleaning. However, the problem continued. On October 29, 2026, I took the vehicle to an authorized Nissan dealership for an 8:00 AM appointment to have the stalling issue diagnosed. The vehicle remained at the dealership until approximately 3:00–4:00 PM. According to the service records, the technician test-drove the vehicle and checked for stored diagnostic codes but could not reproduce the stalling or identify the cause. I was advised to return if the problem worsened or became more frequent. Immediately after leaving the dealership, the vehicle unexpectedly shut off again while I was in traffic. This created a serious safety concern because the vehicle could stall without warning during normal driving conditions. The service paperwork also identified an outstanding tie-rod recall, R23B3, but stated that no recall work was performed. I do not know whether this recall was related to the stalling issue. I was advised to return the vehicle for additional overnight diagnostic testing, but the underlying problem remained unresolved. Due to the repeated unexpected stalling and concerns for my safety and my child's safety, I no longer felt comfortable operating the vehicle. I traded it in on October 31, 2026. The vehicle is no longer in my possession, but the October 29 dealership service records are available. The cause of the stalling was never determined.
Nissan Sentra stalling problems
584 of the 5,834 owner complaints about the Nissan Sentra describe engine stalls while driving, most of them for the 2002 model year.
- owner complaints
- 584
- worst model year
- 2002
- typical repair cost reported
- $1,400
- typical mileage
- 72,000
By model year
Often reported together
Check engine light 105Jerking 55Loss of power 43CVT failure 39Transmission failure 36Hesitation 23Fuel pump 18Shudder 17
Trouble codes mentioned
P0335 4P0101 2P3163 1P2895 1P2589 1P2128 1P17F0 1P1456 1P1229 1P0965 1
What owners say
2020 Nissan Sentra , had been affected, Fuel system and or transmission has been affected , I also communicated this with Nissan Consumers affairs on 9/1, case number(57016532) they didn’t bother to help. I also went to the dealer twice . They also were unbothered and monotone . It’s a safety issue since the car stalls in low speeds. CVT transmission is expensive and they don’t want to fix it . I want to give it back to Nissan or the bank .
The ECU problem is a major issue the vehicle is stalling, not starting, just malfunctioning tremendously while on the road in traffic while driving it stalls in traffic, shuts off in traffic. I was told this was a issue back in July 2017 The same issue has occurred again with safety concerns .
The contact owns a 2025 Nissan Sentra. The contact stated that while driving at various speeds on several occasions, the messages "Engine Stall - Stop Safely", "Service Due in 0 Miles", and "System Malfunction Not Available" were displayed. The contact stated that the vehicle lost power and stalled. The contact stated that the brake warning light, check engine light, oil warning light, and an unknown warning light were illuminated. After approximately 10 minutes, the vehicle was able to be restarted. The vehicle was taken to the dealer on two separate occasions; however, the failure could not be duplicated. On the third visit to the dealer, the dealer diagnosed a burned fuse box and wiring harness. The fuse box and wiring harness were replaced. Approximately one month after the repair, the failure reoccurred. The vehicle was returned to the same dealer, but the failure could not be duplicated. The dealer suggested that the issue might be associated with outside or thermal interference that affected the wiring harness. The manufacturer was notified of the failure. The failure mileage was approximately 9,900.
On Friday, July 3, 2026, at approximately 9:30 PM, while driving on the parkway at an approximate speed of 65 miles per hour and preparing to merge onto the highway, the vehicle unexpectedly stalled completely. I was able to safely maneuver the vehicle to the shoulder of the road. After a few minutes, once the immediate traffic situation on the highway entrance cleared, I attempted to re-engage the vehicle. While the engine started, it immediately began revving excessively high without corresponding forward momentum. The vehicle moved at an extremely slow pace despite the high engine RPMs, indicating a severe loss of power transfer to the wheels. Current Status: The vehicle is presently parked and cannot be driven due to this ongoing issue. It remains inoperable.
The contact owns a 2011 Nissan Sentra. The contact stated that while driving at 70 MPH, the vehicle stalled, and the engine seized. The contact stated that several unknown warning lights were illuminated. The contact stated that while attempting to start the vehicle, the vehicle failed to start. The vehicle was towed to the residence. The contact stated that several days later, while attempting to start the vehicle, the vehicle started as needed. The vehicle was taken to an independent shop where it was diagnosed with ECM failure. The contact was informed that a heavy voltage overload had caused a hole in the ECM. The contact was informed that the ECM needed to be replaced. The vehicle was not repaired. The dealer was made aware of the failure. The contact was informed that an unknown recall with a similar failure was performed in 2012. The contact was advised to contact the federal safety agency Hotline to report the failure. The manufacturer was not made aware of the failure. The failure mileage was approximately 107,000.
My vehicle stalled. I had to get someone to help me move it out if a busy traffic thoroughfare. It was making odd noises then was stuck in reverse only. I took it to my mechanic who informed me the transmission had failed and that I needed a new one. I work from home and do not drive my vehicle consistently.
The contact owns a 2015 Nissan Sentra. The contact stated that while driving 35 MPH, the vehicle unexpectedly stalled while in traffic. There was an abnormal screeching sound coming from the vehicle. The accelerator pedal was depressed, but the vehicle failed to respond as needed. The transmission was shifted into reverse(R), but the vehicle failed to respond as needed. The vehicle was shifted into drive(D), and the vehicle lunged forward and then started moving slowly. No warning lights were illuminated. The vehicle was taken to an independent mechanic who determined that there was a loose bearing inside the transmission. While completing a road test, the mechanic was unable to duplicate the failure. The contact was offered a partial refund and warranty. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 171,000.
The contact owns a 2023 Nissan Sentra. The contact stated that while driving approximately 40 MPH, the vehicle stalled and unintendedly decelerated. The vehicle was driven to the parking lot and came to a complete stop. The vehicle was restarted and driven to the residence. Upon arrival at the residence, the vehicle failed to restart with the check engine warning light illuminated. An independent mechanic arrived at the residence, and the mechanic diagnosed the vehicle and determined that the engine had seized. The local dealer was contacted, and an estimate for the repair was provided. The vehicle was not taken to the dealer and was not repaired. The mechanic stated that the engine was cracked and was a rebuilt engine, not a new engine. The contact purchased a used engine from a salvage yard for replacement. The manufacturer was not notified of the failure. The failure mileage was approximately 100,000.
In December 2025, the vehicle was towed to the dealer after it shut off and would not restart. No warning lights displayed, no low fuel light displayed either. Dealer attributed stall to low fuel (fuel range showed 30 miles remaining), found no diagnostic codes, attributed it to low fuel, added gas, and released the vehicle and charged a DX fee. In February 2026 (approximately two months later), the vehicle lost power again while being driven and was rear-ended while disabled. Post-collision dash photos show approximately half a tank of fuel and malfunction indicators illuminated. The dealership had notice of a shutdown event and failed to properly diagnose or investigate before returning the vehicle as safe in December. My daughter was injured as a result of the rear end accident. The vehicle was a total loss.
Related recalls
Engine and engine cooling
- What is wrong
- On certain passenger vehicles equipped with a 2.5l engine, the crankshaft position sensor can overheat causing a brief interruption in the signal output from the sensor.
- Risk
- If the interruption in the signal from the crankshaft position sensor is so brief that the electronic control module (ECM) logic does not have time to diagnose the condition, the engine may stop running without warning while the vehicle is driven at a low speed increasing the risk of a crash.
- Remedy
- Dealers will reprogram the ECM free of charge. Certain my 2006 altimas which have been previously remedied under recall campaign 06v223 (nissan r0606) are not included in this recall since the reprogramming for 06v223 also included this reprogramming. The recall began on december 31, 2007. Owners may contact nissan at 1‑800‑647‑7261.
Recall number 07V527000 · Recall details
Engine and engine cooling
- What is wrong
- On certain passenger vehicles equipped with a 2.5l engine, the crank angle sensor is affected by temperature variations. Under certain driving conditions, these variations in temperature can be large enough to cause a brief interruption in the signal output from the sensor.
- Risk
- If the interruption in the signal from the sensor is so brief that the electronic control module (ECM) logic does not have time to diagnose the condition, the engine may stop running without warning while the vehicle is driven at a low speed increasing the risk of a crash.
- Remedy
- Dealers will reprogram the ECM free of charge. The recall began on august 21, 2006. Owners may contact nissan at 1‑800‑647‑7261.
Recall number 06V242000 · Recall details
Engine and engine cooling
- What is wrong
- Certain passenger vehicles equipped with 2.5l engines may experience excessive engine oil consumption as a result of improper performance of the piston rings.
- Risk
- If the oil is not maintained at least at the minimum level, engine damage can occur and in extreme cases result in an engine fire.
- Remedy
- Dealers will reprogram the electronic control module (ECM or engine computer). Your vehicle will also be inspected to determine if it has been consuming engine oil at a higher than normal rate. In a small percentage of vehicles, engine replacement will be needed. On june 9, 2006, nissan notified owners of the possibility of excessive oil consumption and the importance of maintaining the oil at a proper level. Follow-up letter to owners advising them of the status of the recall was sent during august 2006. Followup letter to owners was sent on november 15, 2006. Owners may contact nissan at 1‑800‑647‑7261.
Recall number 06V223000 · Recall details
Engine and engine cooling
- What is wrong
- On certain electric vehicles, the front suspension transverse link's ball joint bracket may break from stress concentration at a notch created by surface roughness and the shape of the material cut-line.
- Remedy
- Dealers will replace the bracket on these vehicles. Owner notification began december 15, 2003. Owners should contact nissan at 1‑800‑647‑7261.
Recall number 03V511000 · Recall details
Engine and engine cooling
- What is wrong
- On certain passenger vehicles, the circuit board for the crank position sensor or cam position sensor may have an improper solder joint due to solder deformation caused by heat stress accelerated by the existence of flux residue during the soldering process.
- Risk
- This could cause the "service engine soon" warning light to come on, create a no start condition, cause reduced engine power, or cause the engine to stop running without warning during vehicle operation, which could result in a crash.
- Remedy
- Dealers will replace the crank position sensors. Camshaft position sensor(s), and in some cases, the variable timing control sensor(s). Vehicles involved in a previous recall campaign, 01v357, are also included in this new campaign. The replacement sensors used in that campaign are also affected. Owner notification began on december 22, 2003. Owners should contact nissan at 1‑800‑647‑7261 or infiniti at 1‑800‑662‑6200.
Recall number 03V455000 · Recall details
Engine and engine cooling: exhaust system: manifold/header/muffler/tail pipe
- What is wrong
- On certain vehicles equipped with the 2.5 liter engine, the exhaust pipe hanger pin may catch debris from the road that could be ignited by contact with the main catalyst. Also on 2002 altima and sentra vehicles, certain engine operating conditions may cause the pre-catalyst to overheat and damage the catalyst substrate.
- Risk
- Either of these two conditions could result in a fire.
- Remedy
- Dealers will remove the protruding portion of the exhaust pipe hanger pin. In addition to the corrective action, in order to reduce the risk of fire in the event of poor or improper maintenance that could result in oil spillage, heat shield(s) will be installed on the pre-catalyst and exhaust tube. Owner notification began on july 28, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact nissan at 1‑800‑647‑7261. Nissan recall nos. R3007, r3014, r3015, r3016, r3017. Also on 2002 altima and sentra vehicles, certain engine operating conditions may cause the pre-catalyst to overheat and damage the catalyst substrate. If substrate particles enter the combustion chamber, they could score the cylinder walls, resulting in increased oil consumption. If the engine oil level is not checked on a periodic basis and drops below the low level, and the driver continues to operate the vehicle ignoring noticeable engine noise, engine damage may occur which could result in a fire. The pre-catalyst will be tested to ensure it is working properly and replaced if necessary. If damage is found inside the pre-catalyst, it will be necessary to replace the engine.
Recall number 03V084000 · Recall details
Engine and engine cooling: engine: gasoline
- What is wrong
- Vehicle description: passenger vehicles equipped with a 1.8 liter engine. The engine could stop running while being driven due to a defective crank position sensor. This could also result in the "service engine soon" warning light coming on or reduced engine power.
- Risk
- If the engine stops running while the vehicle is in motion, it could result in a crash.
- Remedy
- Dealers will replace the crank position sensors. Owner notification began december 10, 2001. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact nissan at 1‑800‑647‑7261.
Recall number 01V357000 · Recall details
Questions about the Nissan Sentra stalling
Which Nissan Sentra years have engine stalls while driving problems?
The model years with the most reports are 2002 (74 complaints), 2013 (64 complaints) and 2003 (50 complaints).
How much does it cost to fix engine stalls while driving on the Nissan Sentra?
Owners who mentioned a price put the repair at about $1,400 (median of 37 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.
VIN decoder
See the problems and recalls for an exact car
Buying a used Nissan Sentra?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history