2018 Peterbilt 220 problems

What is wrong

Mickey Truck Bodies, Inc. (Mickey Truck) is recalling certain 2017 Freightliner M2, M2-106, International 4300, and 2018 Peterbilt 220 vehicles equipped with certain model lift gates that contain a license plate kit with part number 298872-01. The light kit does not properly illuminate the license plate, shining rearward, instead of downward as intended.

Risk

The improper lighting may confuse other drivers on the road, increasing the risk of a crash.

Remedy

Dealers will provide a replacement license plate kit, free of charge. Owner notification letters were mailed on July 10, 2021. Owners may contact Mickey Truck customer service at 1‑336‑888‑2291.

Recall number 21V484000 · Recall details

What is wrong

PACCAR Incorporated (PACCAR) is recalling certain 2009-2010 Peterbilt 210 and 220 trucks; 2012-2018 Peterbilt 210 and 220 trucks; and 2010-2018 Kenworth K270 and K370 trucks. These LFNA trucks have a front axle sway bar link that may come loose on the frame rail end and fall into the path of the drag link, possibly binding the steering system.

Risk

If the sway bar link detaches and falls into the drag link, it may impact the ability of the vehicle to steer properly, increasing the risk of a crash.

Remedy

PACCAR will notify owners, and dealers will inspect the upper sway bar link attachment for a hardened washer installed between the bushing and the nut, installing a washer if it is missing, free of charge. The recall began on October 2730, 2017. Owners may contact Kenworth customer service at 1‑425‑828‑5000 or Peterbilt customer service at 1‑940‑591‑4220. PACCAR's numbers for this recall are 817-D and 17KWE.

Recall number 17V554000 · Recall details

The Office of Defects Investigation (ODI) opened this Preliminary Evaluation (PE21-015) based on one Vehicle Owner Questionnaire (VOQ) and supporting fleet reports. The reports indicated that the subject quarter fenders were prone to cracking and/or separation.After a comprehensive review of the data related to the quarter fender failures on the subject vehicles, ODI did not identify the existence of a safety-related defect trend. Quarter fender failures resulted in a warranty claim rate less than one percent (<1%) of the total vehicle population. All separations, including those due to tread separations, road hazards, etc., accounted for less than point one percent (<0.1%) of the total vehicle population.ODI discovered that the minimum recommended gap between the top of the quarter fender and the bottom of the trailer was not known or being followed. The optional quarter fenders were supplied by Fontaine Spray Systems (FSS), who recommended a two inch (2) gap. ODI analyzed the claim data using a calculated gap. A calculated gap using the top of the quarter fender flap and assuming the trailer is level with the top of the fifth wheel hitch was necessary, as PACCAR doesn't know specifically what trailer a purchaser will couple to the tractor. It is safe to assume no trailers on the market extend below the upper fifth wheel plate, but many do provide additional clearance over the wheels where the quarter fenders are located. ODI determined that 94 percent of warranty claims and 84 percent of separations violated FSS' recommendation.ODI confirmed that the VOQ vehicle and the fleet report vehicles also violated FSS' recommended gap. In one fleet the gap was negative point three inches (-0.3).PACCAR has updated its vehicle specification process and issued a customer advisory notice to existing owners. In light of the low rate of reported failures and separations, further use of agency resources does not appear to be warranted. The closing of this investigation does not constitute a finding by the federal safety agency that no safety-related defect exists. The agency reserves the right to take further action if warranted by the circumstances.

PE20015