The worst 2007 Peterbilt 384 problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
Recalls 2
Fuel system, other: storage: tank assembly
- What is wrong
- Paccar is recalling certain model year 2008-2012 kenworth t2000, t660, t700, t800, and w900, as well as model year 2009-2012 peterbilt 365, 367, 384, 386, 387, 388, 389, and 587 trucks equipped with paccar mx engines. The oil module centrifugal spinner filter cap in the paccar mx engine may become loose, possibly allowing the cap to come off and engine oil to partially discharge from the oil module onto exhaust components.
- Risk
- The discharge of engine oil onto exhaust components which are hot, such as when the engine is under significant load, may cause a fire.
- Remedy
- Dealers will re-torque the oil module filter cap and install a secondary retention device on the secondary centrifugal spinner filter cap. This service will be performed free of charge. The safety recall is expected to begin during march 2011. Owners may contact kenworth at 1‑425‑828‑5440 and peterbilt at 1‑940‑591‑4196.
Recall number 11V127000 · Recall details
Trailer hitches
- What is wrong
- Paccar is recalling 318 my 2007-2009 kenworth t800, w900, and peterbilt 357, 365, 367, 378, 379, 384, 385, 386,388, and 389 trucks equipped with premier trailer hitch assemblies. The pintle hitch assemblies may have been manufactured in a manner resulting in a reduction of fatigue strength of the pivot pins.
- Risk
- This reduction of fatigue strength could cause the pivot pin to crack and eventually break, causing the trailer to detach from the truck while in motion, which could cause a crash that could result in personal injury or death.
- Remedy
- Dealers will replace the potentially defective pivot pin free of charge. The recall began on april 18, 2008. Owners may contact kenworth at 1‑425‑828‑5440 or peterbilt at 1‑940‑591‑4196.
Recall number 08V104000 · Recall details
See all 2 recalls for the 2007 Peterbilt 384
Defect investigations
Driveshaft separates from tractor
SummaryOn July 13, 2010, the Office of Defects Investigations (ODI) opened an investigation on model year (MY) 2007-2009 Peterbilt tractors equipped with the (SPL170XL extended lube inter-axle driveline).ODI opened this investigation based on one Vehicle Owners Questionnaire (VOQ) and certain Peterbilt field reports.During the course of the investigation, ODI reviewed PACCAR's IR (October 22, 2010) response with associated data related to Warranty and complaint information, mined field data, interviewed customers and visited local dealers within the Washington Metropolitan area.PACCARconducted testing regarding torsional loading and identified various causative factors contributed to this safety defect finding.The Defect is a consequence of the bearing surfaces of the SPL170XL extended lube universal joint that attaches the inter-axle driveline to the drive axle becoming prematurely worn due to a breakdown of lubrication and/or excessive heat.Prematurely worn bearing surfaces may result in the u-joint becoming loose and/or binding.This condition may result in universal joint failure, allowing the inter-axle driveline to detach from the axle, which may cause the drive shaft to separate from the vehicle, increasing the risk of personal injury or property damage hazard.ODI learned that the affected population of the alleged defect extended to peer models within PACCAR.In summary, the following vehicles are being recalled: MY 2007 and 2008 Kenworth trucks, models T600, T660, T2000, T800 and W900 and MY 2007/2008 Peterbilt trucks, models357, 378, 379, 385, 386, 387, 388, and 389 allequipped with extended lube inter-axle drivelines manufactured by Dana Corporation.The recall affects vehicles manufactured between February 2, 2006 and April 30, 2007.At this time PACCAR has not yet identified a fix for the inner-axle safety defect and is currently conducting testing with the intent to provide a solution to the failure.ODI will monitor the development of PACCARS testing and ensure a timely repair for the consumer.This investigation is closed.
PE10029
Technical service bulletins for the 2007 Peterbilt 384 14
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- "Kenworth: Dealers should check the chassis list and SIR weekly for VIN changes
- Information Only – Windshield washer pumps have a high No Trouble Found rate
- Fix as Fail: For all conventional models, except 387/587, equipped with Side-of-Cab (“SOC”) exhaust and...
- Information Only: This bulletin provides dealers with a battery warranty quick reference guide to ensure...
- Information only: Hendrickson Softek front axle maintenance intervals and requirements.
- Information Only: Proper jump-starting voltage will eliminate high voltage related issues and equipment...
- Information Only – Vehicles may have the connector seals on the wheel speed sensor incorrectly installed,...
- Information Only: Vehicles may have the connector seal on the wheel speed sensor incorrectly installed,...
- Information Only: This bulletin provides guidance for repairing an air-conditioning system after internal...
- Information Only
Compare the 2007 Peterbilt 384
Other model years
Questions about the 2007 Peterbilt 384
Is the 2007 Peterbilt 384 reliable?
Owners have filed 0 complaints about the 2007 Peterbilt 384.
What is the most common problem with the 2007 Peterbilt 384?
There are not enough complaints to tell.
How many recalls does the 2007 Peterbilt 384 have?
2 recalls, covering fuel system, other and trailer hitches.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2007 Peterbilt 384?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history