The second failure occurrence following manufacturer,s recall, and dealer repaired (system accumulator). Driver again experienced illumination of brake and anti-lock lights, and subsequent total failure of the brake system at slow speed. The brakes pedal felt completely normal to touch, however no hydraulic pressure appeared to reach the actual vehicle brakes for stopping.
1992 Plymouth Voyager brakes complaints
Page 3 of 7: complaints 41 to 70 of 162, newest first, as owners wrote them.
I have had my ABS system replaced 3 times. This time the pedal does not come up properly to shut off the brake lights, and let cruise control to work properly. I feel that this has also caused my front rotors to warp. I contacted the dealer ship and was told that there is a return spring that needs to be added. Service bulletin 05-08-92 rer system of the car if the brake light is on. Is the transmission able to function properly or is this what caused my transmisson to go out.
Abs brakes control unit replaced in september 94/in october, 96, and ABS module changed in july, 94. In addition, serviced transmission due to problems/A/C problems in august 94, and battery problems due to electrical short, replaced battery and repaired electrical system in februry, 95. Power steering problems, repairwork done in march, 95. Engine problems occurred, repairwork done to rocker shaft/push rods and oil filter in march 95. Finally, in may 95 starter burned out and replaced/in july, 95/emergency light became defective and reset/recall jun. 96, liftgate latch replaced/december 97, seat belt repaired/ apr, 97 reset maintenance light and speedometer/ may, 97 belt drive problems and tensioner problems also exit. Dealer aware of the problems and problems go on. Repairwork at owner's expense with extended coverage on some. Provide further information.
Abs sensor light keeps coming on intermittently. Vehicle was taken to dealer for the federal safety agency recall # 96 v 099 000. Dealer informed consumer of a code needed to correct the problem. Consumer would like to know if this is proper procedure.
Abs brake light comes on while driving. Dealer cannot duplicate.
Received recall notice (#96v099000). Notified dealer. Took vehicle in for brake repair on date given. Had no parts. Took to second dealer.
Recall states dealer will repair and not charge for parts. Dealer wants to charge for parts.
When traveling and upon depressing the brake pedal, the pedal traveled to the floorboard, causing extended stopping distance and brake fade away. Consumer has contacted the dealer, dealer has yet to correct the problem.
Brake pads failed.
Transmission failed.
Received recall notice in 1996 for ABS. Did not take vehicle in for repairs because did not get the letter from his wife until 1997.had accident on 6-12-97, was driving approximately 50mph when ABS light came on; lost control of vehicle and ran into an embankment, recall #96v009.
The anti lock brakes failed prior to/after recall repairs. Mr the ABS light was intermittent. The hyd assembly and the brake system was replaced. There was a grinding noise in the engine, transmission, and when braking. The repairs and or replacement parts are as followed: replaced the gasket, repaired the ground wiring of the ABS, replaced the serpentine belt and motor mount . The transmission shift was out of gear. The consumer has requested reimbursement. Scc
Owner has ABS brakes, ABS brakes failed twice and were repaired twice. Owner notes that she has had two accidents in result of brake failure and is very cocerned about the safety of this vehicle.
While driving applied the brakes and the rear wheels locked up. The front brake did not lock up only the back rear wheel.
Antilock brake pump failure.
Brakes failed 15 minutes after warning light came on.
Owner requests refund for ABS repairs.
Applied the ABS brakes and there were no brakes, pedal went to the floor, causing two crashes; first collision occurred before receiving the recall letter and second collision happened after the vehicle was fixed. Please describe .
While making a sudden stop ABS brakes locked up, vehicle slid into vehicle in front, resulting in rearend collision.
Abs brake light comes on periodically and goes off within 5 minutes, replace ABS connector.
Consumer states that the ABS brakes system does not work properly, if one wheel should slide, it releases the brakes on slippery or dry pavement.
While driving the emergency light came on and within minutes ABS brakes were gone, was lucky no accident.
When driving has to use excessive pressure to stop vehicle, has taken vehicle in several times, dealer indicated that there was no problem, even though she is still experiencing the same problems with the brakes. *ak consumer experienced problems prior to recall 96v099, after recall repair, problem still continue.
Abs brakes fail continually.
Abs, brake failure, compelte loss of brakes , pedal went to the floor, in for repair for faulty sensor that connects to the wiring harness.
While driving applied brakes and brake pedal went all the way out. *ak dealer replaced the ABS pump, consumer states she has alway has problems with the brake lights and brake pedal, everytime the vehicle was looked at by a dealer, they always responded that there was no problem.
Roche chrysler plymouth recall 96v099. Dlr., doesn't have the parts. Zone office states parts have been ordered but none have been received at this time.
Abs braking system failed with warning lights on, prior to pedal failure/soft.
Abs: anti lock brake light keeps coming on, remains on, this problem could cause ABS brake failure.
Antilock brakes failed.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1992 Plymouth Voyager?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history