2010 Porsche 911 GT3 problems

What is wrong

Porsche is recalling certain model year 2010 911 GT3 vehicles manufactured May 15, 2009, through February 11, 2010. The rear wheel hubs may be prone to failure under certain driving conditions. Also, the original, suggested maintenance intervals may be insufficient to prevent wheel hub failure.

Risk

If the rear hub fails, there may be a loss of vehicle control, increasing the risk of a crash.

Remedy

Porsche will notify owners, and dealers will replace the wheel hubs on the rear axle free of charge. The service interval specifications will also be revised and provided to owners as part of Porsche's owner notification letter. The recall began on January 22, 2013. Owners may contact Porsche at 1‑800‑767‑7243.

Recall number 12V558000 · Recall details

What is wrong

Porsche is recalling certain model year 2010-2011, 911 turbo; turbo s, 911 gt3, gt3 rs and gt2 rs high performance vehicles, manufactured from may 18, 2009 through september 17, 2010, and equipped with center locking hub and wheel assemblies. Over time the hubs can wear prematurely.

Risk

As the hubs wear, the wheels could loosen, increasing the risk of a crash.

Remedy

Dealers will replace the central locking hubs and wheels with an improved design, free of charge. The safety recall began on june 28, 2011. Owners may contact porsche at 1‑800‑767‑7243.

Recall number 11V285000 · Recall details

On April 26, 2013, the Office of Defects Investigation (ODI) opened PE13-009 to investigate 10 complaints alleging incidents of sudden coolant loss while traveling on public roadways in certain model year (MY) 2001 through 2007 Porsche 911 vehicles.The complaints alleged that pipe ends joined by epoxy to certain cooling system components may fail suddenly and separate, resulting in large volumes of coolant leakage.The investigation was opened to assess evidence of a design or manufacturing defect in the coolant pipe fittings and any related safety consequences. In response to ODI?s Information Request letter, Porsche identified a manufacturing quality issue with the supplier?s application of adhesive to coolant pipe fittings that resulted in elevated failure rates in approximately 6,800 early production 997 generation vehicles (MY 2007 and early MY 2008).ODI?s analysis of field data showed that the age-adjusted failure rate for these vehicles was approximately six times greater than MY 2001 through 2005 996 generation vehicles and MY 2008 through 2011 997 generation vehicles built after a process improvement for adhesive application was implemented by the supplier.Most of the leak complaints reviewed by ODI did not appear to involve complete separation of the fittings and many were detected when the vehicle was parked.There were no crashes or injuries reported to be related to the alleged defect in any of the subject vehicles.ODI identified two allegations that coolant leakage resulted in loss of control incidents, but neither involved vehicles affected by the assembly process quality issue.A third loss of control allegation involving a vehicle built during the period affected by the supplier process concern is not counted since ODI was unable to contact the owner to confirm the incident.See the full closing resume in the document file for PE13-009 for additional information about the subject cooling system and ODI?s analysis of field data related to the alleged defect. A safety-related defect has not been identified at this time and further use of agency resources does not appear to be warranted.Accordingly, this investigation is closed.The closing of this investigation does not constitute a finding by the federal safety agency that a safety-related defect does not exist.The agency will monitor this issue and reserves the right to take further action if warranted by the circumstances.

PE13009