Tl* the contact owns a 1994 saab 900. The contact stated that the front driver's seat was cracked and had a damaged frame that was deteriorating. The seat was not secured and would move independently. The front passenger seat also exhibited the failure. The SRS sensor and the service engine sensor illuminated for an extended period of time. The vehicle was taken to an authorized dealer but the dealer was unable to reset the codes. The contact referenced the federal safety agency campaign id number: 94v226000 (seats) however, the vehicle was not included in the recall campaign. The vehicle was to be inspected and repaired by an authorized dealer. The manufacturer was notified of the failure. The approximate failure mileage was 22,601 and current mileage was 143,100.
The worst 1994 Saab 900 problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
- Engine14
- Transmission10
- Electrical9
- Acceleration7
- Brakes7
- Suspension4
- Visibility4
- Airbags3
- Fuel system3
- Seats2
- Steering2
- Body1
- Lights1
- Locks1
- Seat belts1
- Tires1
Specific symptoms reported on the 1994 Saab 900
Recalls 8
Exterior lighting: headlights
- What is wrong
- Vehicle description: passenger vehicles. The instructions for properly aiming the headlighting system were omitted. This does not meet the requirements of fmvss no. 108, "lamps, reflective devices, and associated equipment."
- Risk
- If the headlamp assemblies are replaced, customers may not be able to properly aim the headlights.
- Remedy
- Owners will be sent aiming instructions, and directions for affixing these inserts to the owner guides. If an owner so desires, a dealer can affix the inserts in their owner guide for them.
Recall number 98V038000 · Recall details
Vehicle speed control
- What is wrong
- Corrosion around the zinc-coated throttle control lever bushing can cause the throttle lever to bind.
- Risk
- This binding can result in the throttle plate not returning to the closed position when the throttle pedal is released and a subsequent loss of throttle control.
- Remedy
- Dealers will replace the zinc-coated throttle control lever bushing with a nickel-coated bushing and bolt.
Recall number 97V046000 · Recall details
Power train: manual transmission
- What is wrong
- It is possible to move the shift lever into the reverse gear position, remove the ignition key, and still have the transmission in neutral, or, to accidently disengage reverse by striking the gear lever.
- Risk
- If the parking brake is not applied, the car can roll from its original parked position increasing the potential for a vehicle accident.
- Remedy
- Dealers will replace transmission linkage components and complete a specially developed service adjustment procedure that will ensure that when the shift is moved to the reverse position, the reverse gear is actually engaged.
Recall number 95V068000 · Recall details
Seats: front assembly: recliner
- What is wrong
- One or more of the arc welds can be missing on the seat back frame recliner.
- Risk
- This can result in a seat back falling backwards under a load.
- Remedy
- Both front seat backs will be inspected with the use of a hook to pull back the seat back upholstery. For any seat with missing welds, the seat back frame/recliner will be replaced.
Recall number 94V226000 · Recall details
Structure: body: door
- What is wrong
- The two weld points in the rearward attachment bracket for the side impact protection beam in the rear door may be out of position. If the welds are out of position, the vehicles will not meet the requirements of fmvss 214, s5, "side door strength."
- Risk
- Consequence of non-compliance: passengers sitting in the rear seats will be subject to an increased risk of injury in the event of a side collision.
- Remedy
- Dealers will install support brackets at the support weld locations.
Recall number 94V174000 · Recall details
Seats
- What is wrong
- Two trigger springs mounted to the fore/aft adjustment lever do not develop sufficient force to properly lock the seat rails. After the seat is adjusted, this does not allow the seat rail lock to properly engage, which can cause the seat to move in a sudden stop or collision.
- Risk
- This can increase the possibility of injury to a seat occupant in the event of a sudden stop or accident.
- Remedy
- Dealers will remove both front seats and the two springs on each seat will be replaced with new springs with proper tension to ensure proper engagement.
Recall number 94V127000 · Recall details
Seats
- What is wrong
- A weld in the seat rails was not made, increasing the risk of fatigue cracks forming around the attachment bushings on the height adjustment mechanism, causing the possibility of the height adjuster breaking in a rear end collision and allowing the seat to fold backwards.
- Risk
- This can increase the risk of injury to seat occupants.
- Remedy
- Dealers will install new front seat frame rails.
Recall number 94V110000 · Recall details
Service brakes, hydraulic: foundation components: disc
- What is wrong
- The original front brake discs and/or pads shields do not protect the assemblies from being coated with a layer of slush, road salt or water while driving in snow or heavy rain. This can result in a delay in braking action that increases normal stopping distance.
- Risk
- Increased stopping distance could result in an accident.
- Remedy
- Dealers will replace the original front brake shields with a new design. An additional hole will be drilled in the steering king pin housing to attach a larger cover plate. A smaller protection plate will also be attached to the existing two bolts in the hub.
Recall number 94V074000 · Recall details
See all 8 recalls for the 1994 Saab 900
Defect investigations
Defective water pump pulley
a
DP00008
New wheel bolts
saab issued a tsb informing dealers about a new wheel mounting bolt.If the issue is loosening of the lug nut, this could lead to bolt fatigue and the potential for a wheel separation.
SQ98018
Audio system fires
See resume for details.
SQ98006
Technical service bulletins for the 1994 Saab 900 46
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Expanded Availability for Remanufacture and Return (R&R) Electronic Control Modules
- Service information regarding the wiring harness repair kit. tt
- Notification to stop performing procedure outlined in SI-831-1823 to address a complaint of rear doors...
- Addressing concerns with various types of noises heard from the a/c system. tt
- Complaints of vibration from cabin fan motor. tt
- Complaints of noise on deceleration in 1994 and later models with manual transmissions. yc
- SRS (airbag) diagnostic trouble codes missing from workshop information. yc
- Improved bush and gear linkage. yc
- Service information on wiring harness repair kit. yc
- Addressing customer complaints of noisy a/c. yc
1994 Saab 900 fuel economy
Official EPA estimates in miles per gallon (MPGe for electric). Ranges cover trims that share the same engine.
| Engine | Drive | City | Highway | Combined |
|---|---|---|---|---|
| 2.3L 4‑cyl | FWD | 17-18 | 24-26 | 19-21 |
| 2.5L 6‑cyl | FWD | 16-17 | 23 | 19 |
What 1994 Saab 900 owners say
Most recent owner complaints, unedited.
The experience leaking head gasket repeated problem. The engine overheating and brake problems. *bf the brakes squealed when stopping, the windshield wipers, the passenger door was hard to close, the battery light had run bad, the heat operation was inoperative, there was an oil leak, seat cover left lower cracked, fluid leaked under the vehicle/overnight coolant leak, over heating while the vehicle was in motion, the turn signal assembly, leaking distributor seal, broken turn signal, at a certain position the seat would not operate forward, the antenna would not properly retract, left fog light inoperable, driver side window front and rear for proper rubber alignment, leaking crank pulley seal, oil leak from the transmission, found a lack of fuel pressure, smoke was coming out of the tailpipe, the convertible top was wearing on the left and right side, there was a loose hose clamp in the power steering hose, the battery failed, one tail light was inoperative, the alternator belt was wrapped around the chassis, there was a squealing noise after start up, oil leaked through the valve cover, and the tank clutch leaked fluid.
While driving on the dan ryan expressway at 3:00 p.m. On 4/30/04, I heard a pop and I thought a belt snapped, my car, a 1994 saab s, jerked, it was difficult to gain control. I smelled burning rubber. I looked in the rear view mirror and saw a tire role from east to west on the expressway. I thought I ran over it. Further down the road a person on another car told me I didn't have a tire on the passenger side of the car in the rear. When I pulled off the expressay I saw the tire was missing. The middle of the tire had pulled away from the sides. The sides of the tire were left on the wheel.
In july of 2003, saab of santa monica, ca replaced the timing belt on my used 1994 saab 900 (65,000 mile service). The labor was complimentary and covered under a change in scheduled maintenance outlined by saab USA in a letter sent out to saab 900 owners in july 1995. The letter amended information in the warranties and service record booklet and owner's manual and stated that rather than every 95,000 miles, saab was now recommending that the belt for the camshaft drive mechanism be replaced beginning with the 35,000 mile major service and at intervals of 30,000 miles thereafter. At the time of service, in addition to replacing the timing belt, non-routine labor was done on the tensioners. The work receipt notes that old-style tensioners were noted and replace. Less than 1000 miles after saab of santa monica performed their "complimentary work" my car catastrophically failed. On oct. 17, 2003, I left work at and drove about 1/3 of a mile (35 MPH) before I heard a loud clunk and the engine started to putter and clank as the car lost power. The next business day it was towed to a well-respected independent saab mechanic, hung tao (a.r.t. Saab 18440 hart st. Reseda, ca (818) 881-7940 ). Hung tao looked at the car and stated that the timing belt had slipped. The car was towed to the nearest saab dealer (sherman oaks, ca). Saab of sherman oaks first said that the timing belt had slipped, but then changed they're story and said the camshaft had allegedly snapped, causing $5000 worth of damage to the engine. They argued that there was no correlation between the work they'd done on the camshaft drive belt and the failure of the camshaft. They say because the car isn't under warranty they can't help me.
Vehicle stalled in traffic due to engine failure.*mr the gasket surrounding the timing belt cover became tangled with the timing belt which caused the vehicle not to start.*ts
While driving the vehicle lost all power. The vehicle was sent to the dealership who found a bundle of wires held together by a plastic binder wire clip. The bundle became loose and a wire was exposed to and rubbing on metal.
Consumer called complaining about having problems with the timming belt tension on her vehicle. Consumer also stated that she has replaced it once and it was warrantied for 3500 miles and it has happend again this also causes engine failure on the vehicle. Dealer was contacted but refuses to do anything on the vehicle because is no longer under warranty. Ts
Recall 95 v 068 000/transmission manual: vehicle operated in reverse intermittently. Dealer notified, and informed consume rthat vehicle was not cover under recall. Feel free to provide any further information.
Consumer explains that the electronic control module upon investigation was found defective.
When applying brakes on wet pavement there is no reponse for a few seconds, then the brakes will engage. Consumer states there is a recall regarding this problem, however his VIN is not included, consumer feels his vehicle should be included in the recall.
Compare the 1994 Saab 900
Other model years
Questions about the 1994 Saab 900
Is the 1994 Saab 900 reliable?
Owners have filed 44 complaints about the 1994 Saab 900, 2.1 times a typical 900 model year.
What is the most common problem with the 1994 Saab 900?
Engine and cooling, with 14 complaints. Next is transmission (10).
How many recalls does the 1994 Saab 900 have?
8 recalls, covering exterior lighting, vehicle speed control and power train.
What gas mileage does the 1994 Saab 900 get?
Official estimates for the 1994 Saab 900 range from 19 to 21 mpg combined. The most efficient version (2.3L 4-cyl, FWD) gets 17-18 city and 24-26 highway.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1994 Saab 900?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history