Check a VIN

Subaru Ascent cvt failure problems

52 of the 1,048 owner complaints about the Subaru Ascent describe cVT failure, most of them for the 2019 model year.

owner complaints
52
worst model year
2019
typical repair cost reported
$9,400
typical mileage
27,319
Is there a fix? There are 4 recalls for this area of the car. See below

By model year

Often reported together

Slipping 18Transmission failure 16Hesitation 12Jerking 10Shudder 8Loss of power 6Warning lights 3Stalling 3

Trouble codes mentioned

P2723 1P2096 1P1867 1P0867 1P0841 1P0700 1P0137 1

What owners say

Filed Oct 7, 2026 · Transmission · VA

Cvt is slipping and failing internally, CVT assembly requires replacement.

Filed Aug 28, 2026 · Transmission · WY

My local Subaru dealership / service provider has told me my car needs a new transmission at 66k miles, due to an issue within the CVT solenoid causing slipping and lag that will eventually lead to catastrophic failure of the transmission - per the Subaru of America service tree. This issue began on July 23, 2026, when a slew of warning lights illuminated on the dash and my car went into limp mode, not accelerating properly. It eventually began driving normally and all dash warning lights dissipated. Dealership couldn't see the car at that time, then I was out of town for about a week. Came back, experienced the same issues within 2 days of driving the car. I was able to get it into the dealership for service on 8/6 where it was diagnosed, according to the Subaru Service Tree, as needing a new transmission. Subaru technicians cleared the codes, and I took the car home on 8/7/26 with the warning from my dealership that it was only a matter of time before the transmission failed. The lights / limp mode driving came on again on 8/9 and I have not driven it since that date. I have opened a case with SoA and am waiting on a "resolution". I do not feel safe driving my vehicle so it has been sitting in the driveway since 8/9 while I wait on a resolution from Subaru of America.

Filed Aug 27, 2026 · Transmission · 145,000 miles · SC

The contact owns a 2020 Subaru Ascent. The contact stated that while driving at an undisclosed speed, the vehicle was skipping. The failure was recurrent. The contact associated the failure with the federal safety agency Campaign Number: 21V955000 (Power Train); however, the dealer informed the contact that the recall repair was completed on July 15, 2025. The contact was the vehicle owner on that date and stated that the vehicle was never taken to the dealer for the recall repair. The dealer diagnosed the vehicle with CVT failure and advised that the vehicle was outside warranty coverage. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was approximately 145,000.

Filed Aug 3, 2026 · Transmission · TX

My 2019 Subaru Ascent Limited had a safety recall that was related to a CVT transmission issue. That safety recall was addressed by Sewell Subaru (Dallas, TX) in January of 2025. This past Wednesday, July 29, I was driving on a state highway on my way to work from my residence. Not even two miles away from my residence, I felt a jerk and a loud "thud". That was followed by loss of power in that the vehicle just was rolling, but no power from the gas. I was able to safely maneuver onto a the shoulder and stop the vehicle. Within minutes, I noticed a puddling of a large amount of fluid that I could easily recognize was not oil. The vehicle was towed back to Sewell Subaru this past Saturday and I was notified today that the CVT belt snapped and it caused a hold in the transmission case, which caused the fluid to leak. The service advisor also mentioned that Subaru is not wanting to cover the replacement and that they are citing that the reason is that Subaru records are showing irregular servicing done by a Subaru service center. This issue has nothing to do with routine maintenance, or where I get those, and has everything to do with the catastrophic failure of the very same component that was at the heart of their known safety recall issue.

Filed Aug 1, 2026 · Driver assistance, Electrical · TX

the federal safety agency Vehicle Safety Complaint Vehicle: 2019 Subaru Ascent VIN: [XXX] Mileage: 72,093 miles I am submitting this complaint because my 2019 Subaru Ascent experienced a serious transmission-related electrical failure that may represent a broader safety defect. Sewell Subaru of Dallas diagnosed an internal failure of a transmission pressure sensor. According to the dealership’s written report, the failed pressure sensor allowed transmission fluid to leak into the electrical wiring harness. The transmission fluid then migrated through the wiring and into the bulkhead harness. The dealership advised that the fluid contamination had affected multiple parts of the vehicle’s electrical system and recommended replacement of the transmission wiring harness, engine wiring harness, bulkhead harness, Engine Control Module (ECM), Transmission Control Module (TCM), and related components. Because the wiring harnesses are routed throughout the engine compartment and vehicle, the repair also requires extensive disassembly of the vehicle, including disconnecting and removing numerous engine compartment components to access and replace the contaminated harnesses. The estimated repair cost was approximately $12,000. I also have video documentation of the dealership technician performing the inspection and explaining the transmission fluid contamination and migration through the wiring system. I am willing to provide the video, the dealership's written diagnosis, repair estimate, photographs, and any additional supporting documentation upon request. My vehicle falls within the published VIN range associated with Subaru recall WUV-07, which involved the CVT hydraulic pressure sensor harness and transmission hydraulic pressure system. That recall was later superseded by WRK-21. I understand that the published recall addresses electrical resistance and transmission hydraulic pressure readings rather than transmission fluid leakage. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Jul 24, 2026 · Transmission · 101,541 miles · ID

The contact owns a 2021 Subaru Ascent. The contact stated that while driving at an undisclosed speed, the vehicle started to stall, and the transmission failed to properly operate. The vehicle was pulled over to a nearby shop and was advised to take the vehicle back to the facility that performed the oil changes. Several days later, the contact's husband test drove the vehicle and was able to duplicate the failure. The vehicle was towed to a dealer to be diagnosed, and metal shavings were found in the oil. The dealer determined that the CVT transmission needed to be replaced. The vehicle was being repaired. The manufacturer was notified of the failure. The failure mileage was 101,541.

Filed Jul 11, 2026 · Engine · IA

Oil leaking from upper and lower oil pan. Oil seeping from head gasket and CVT chain pump cover. RTV sealant failure. $4800 to repair. Subaru needs to solve these oil leak issues. Leaking oil is bad for the environment and engine failure could cause accidents and injury.

Filed Apr 13, 2026 · Transmission · CO

I had catastrophic transmission failure. The car was completely inoperable. Thankfully this only happened in a parking lot. If this were yo happen while merging into traffic it could have been very dangerous. This was the second cvt in this vehicle. The 1st transmission was replaced around 52kmiles. The second transmission lasted not even 13 months sndless than 15k miles. Subaru replaced the transmission for a 3rd time at a cost of 1k to me. I no longer have the car.

Filed Mar 10, 2026 · Transmission · NV

Vehicle: 2020 Subaru Ascent (Build Date: March 2020) Component: Power Train – Automatic Transmission – Hydraulic Pressure Sensor / Wiring Harness The vehicle developed a flashing "Transmission Service" warning and check engine light. It was inspected by a certified technician at Lithia Reno Subaru. Diagnostic scan identified multiple transmission-related codes including P0137, P0700, P2096, P1867, P0867, P2723, and P0841. The technician documented the root cause as: "Found pressure sensor leaking oil through all harnesses." According to the dealership diagnosis, the transmission hydraulic pressure sensor failed and allowed transmission fluid to migrate into the vehicle's electrical wiring harness system. Fluid traveled through the transmission harness and continued into the bulkhead and engine harnesses, contaminating multiple electrical systems. Due to the extent of contamination, the dealership determined that all three harnesses must be replaced. The repair estimate is approximately $8,933. Transmission fluid entering the wiring harness can disrupt communication between the transmission control system and other powertrain components. This electrical contamination can cause erratic transmission operation or sudden loss of propulsion while the vehicle is in motion, increasing crash risk. Subaru has issued recalls and service bulletins involving CVT transmission and hydraulic pressure sensor failures in earlier Ascent vehicles using the same drivetrain. My March 2020 vehicle appears to have experienced the same failure pattern. Despite the documented component failure and extensive wiring contamination, the manufacturer declined to fully cover the repair. I request that the federal safety agency review this failure mode to determine whether hydraulic pressure sensor seal failures allowing transmission fluid to migrate into wiring harness systems represent a broader defect affecting Subaru Ascent vehicles.

Filed Mar 5, 2026 · Transmission · CO

We have been dealing with issues with this vehicle since 2024. We had 3 open recalls which we took into the closest dealership to us and things were okay for a few months and then started having issues again. We live in a small town and it is hard to get to the dealership so we had a few local mechanics take a look and one had found that the exhuast recall was not installed properly and so he addressed that issue. Things were then okay for a little bit after that and then we started having bigger issues the car would not exceed 30 MPH in the middle of us driving and then the car would jerk back and forth. After advice from Subaru of America we got it checked out at a dealership who put a part into the vehicle and then we got it back and less than a week later the car was doing the same things. We took it back and they kept the car for 2 weeks but told us they could not duplicate the problem so we got the car back and right away had the same issues when taking it home. The CVT is for sure messing up we believe and now the car does not drive at all. After some back and forth we found out that the 1st owners took it in for the CVT recall so I reached out to the dealership who did that and was told that they did look at it but at the time the CVT was not an issue but the mileage was fairly low at that time. Personally I am not in a place to afford to get it replaced on my own but I do not believe that the recall should have been closed out knowing that the part would eventually go out since it is a known issue on that car I have tried to go back and forth to get this resolved but I am not getting anywhere and I am not sure what to do at this point to try and get the problems address and made right.

Related recalls

Power train: driveline: driveshaftReported September 21, 2023 · 4,311 vehicles affected
What is wrong
Subaru of America, Inc. (Subaru) is recalling certain 2023 Outback, Legacy, Ascent, and Impreza vehicles. The center support bolts for the driveshaft may loosen, resulting in the disconnection of the front end of the driveshaft.
Risk
Separation of the front end of the driveshaft increases the risk of a crash.
Remedy
Dealers will clean the bolt mounting surfaces of the center support brace and install new bolts, free of charge. Owner notification letters were mailed November 20, 2023. Owners may contact Subaru's customer service at 1‑844‑373‑6614. Subaru's number for this recall is WRN-23.

Recall number 23V647000 · Recall details

Power train: automatic transmission: control module (TCM/PCM/tecm)Reported December 9, 2021 · 198,255 vehicles affected
What is wrong
Subaru of America, Inc. (Subaru) is recalling certain 2019-2020 Ascent, 2020 Legacy and Outback vehicles. A programming error in the Transmission Control Unit (TCU) may allow the clutch to engage before the drive chain is completely clamped.
Risk
An improperly secured drive chain may slip and break, causing a loss of drive power and increasing the risk of a crash.
Remedy
Dealers will reprogram the TCU, inspect TCU data for chain slip, and visually inspect the chain guide. If evidence of chain slippage or damage is found, the transmission will be replaced. Repairs will be performed free of charge. Owner notification letters were mailed August 19, 2022. This recall includes all vehicles previously recalled under 19V‑855. Vehicles previously recalled under 19V‑855 will need to have the new remedy performed for this recall once available. Owners may contact Subaru customer service at 1‑844‑373‑6614. Subaru's number for this recall is WRK-21.

Recall number 21V955000 · Recall details

Power train: automatic transmission: control module (TCM/PCM/tecm)Reported December 2, 2019 · 76,842 vehicles affected
What is wrong
Subaru of America, Inc. (Subaru) is recalling certain 2019 Ascent vehicles. The transmission hydraulic sensor may inaccurately measure the hydraulic fluid pressure.
Risk
If the fluid pressure is measured higher than its actual value, the hydraulic pressure will be reduced. If this occurs, the transmission drive chain may not have the proper tension, resulting in a loss of drive power and an increased risk of a crash.
Remedy
Subaru will notify owners, and dealers will reprogram the transmission control unit. The hydraulic sensor harness will be replaced on vehicles with certain stored diagnostic trouble codes. In addition, any vehicle confirmed to have experienced low drive chain tension will have the transmission assembly will be replaced. All repairs will be free of charge. The recall began January 31, 2020. Owners may contact Subaru customer service at 1‑844‑373‑6614. Subaru's number for this recall is WUV-07.

Recall number 19V855000 · Recall details

Power train: driveline: driveshaftReported July 10, 2019 · 166 vehicles affected
What is wrong
Subaru of America, Inc. (Subaru) is recalling certain 2019 Ascent vehicles. The center support bolts for the driveshaft may loosen, possibly resulting in the front portion of the driveshaft disconnecting.
Risk
If the front end of the driveshaft separates, it can increase the risk of a crash.
Remedy
Subaru will notify owners, and dealers will replace the driveshaft assembly, including the center support brace, free of charge. The recall began July 26, 2019. Owners may contact Subaru customer service at 1‑844‑373‑6614. Subaru's number for this recall is WUI-94.

Recall number 19V519000 · Recall details

Questions about the Subaru Ascent cvt failure

Which Subaru Ascent years have cVT failure problems?

The model years with the most reports are 2019 (22 complaints), 2020 (15 complaints) and 2021 (12 complaints).

How much does it cost to fix CVT failure on the Subaru Ascent?

Owners who mentioned a price put the repair at about $9,400 (median of 5 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.

VIN decoder

See the problems and recalls for an exact car

Buying a used Subaru Ascent?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history