Front subframe on the driver and passenger side rusts away causing failure. Could result in loss of control of vehicle and could injure passengers. Turning or hitting bumps could cause it to snap due to extra force.
2003 Subaru Forester body problems
19 complaints (10% of all complaints for this car). Typical mileage when it fails: 132,819.
- owner complaints
- 19
- of this car's complaints
- 10%
- typical mileage
- 132,819
- crashes
- 0
- recalls
- 0
Which part fails
- Body10
- Frame and members5
- Frame and members: underbody shields3
At what mileage
Complaints by mileage at the time of the problem.
Subaru Forester body problems in other years
Related recalls
No recalls on record for this model year.
What 2003 Subaru Forester owners say
Most recent owner complaints, unedited.
Tl* the contact owns a 2003 subaru forester. The contact noticed extensive rust, corrosion, and holes around the front frame of the vehicle. An independent mechanic replaced the front frame, and the passenger and driver side control arms. In addition, the rear frame and driver and passenger side control arms were also inspected with the expectation that those parts had also deteriorated and may need to be replaced. The vehicle was not diagnosed by a dealer. The contact was uncertain if the vehicle was included or excluded from the federal safety agency campaign number: 11v464000 (suspension) and was not included in the federal safety agency action number: pe11011 (suspension). The manufacturer was notified of the failure. The VIN and failure mileage were not available.
Tl* the contact owns a 2003 subaru forester. While the vehicle was undergoing a routine oil change, the contact was informed that the subframe was completely rusted. The dealer diagnosed that the subframe needed to be replaced. The vehicle was not repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 119,000.
I was getting new tires placed on my vehicle when my mechanic noticed that my control arms as well as the subframe was rusted out. I contacted subaru who stated there was a recall on the control arms for rusting out but not on the subframe. When the vehicle was brought to subaru dealership to get control arms place on a mechanic from the dealer ship contacted me. He stated that the subframe was in bad shape and that if they were inspecting the vehicle they could not pass the inspection per the level of rust and corrosion of the subframe. They stated that both the front and rear subframe would have to be replaced/fixed. My mechanic has never seen a subframe corrode so badly in such a short period of time. The last thing on a car to go should be the subframe and frame of the vehicle. There is obviously a safety issue with this and I am really surprised there is no recall in ref to this. I am not sure how they don't know this is an issue when they know there was an issue with the control arms.
Today I was at my mechanics to replace a muffler. After raising the car up on the rack he noticed destructive rust that was covering and inundating the k frame and front lower control arms (transverse links). In september of 2012 I was at gary lang subaru (illinois) for an unrelated issue. The safety recall for my vehicle , wvx-34, required an inspection and repairs, and if necessary, replacement or corrosion treatment of the lower control arms (transverse link). According to subaru of america, that recall was "completed". The subaru operator (kayla) could not elaborate on the term "complete". No mention of any specific action was reported. Today, during the inspection of said area, my mechanic indicated that no proof existed of either corrective action, either undercoating or mechanical repair or replacement. This is a safety concern, and at some point it is possible that loss of control will follow if the lower control arm breaks. I will pursue the subaru dealer for repairs but have no idea if they will assume responsibility.
Tl* the contact owns a 2003 subaru forester. While driving approximately 35 MPH, the accelerator pedal was depressed and a grinding noise emitted outside the vehicle. The vehicle was taken to an independent mechanic, who informed that the front passenger side subframe completely rusted. In 2012, the vehicle was repaired under the federal safety agency campaign number: 11v464000 (suspension) and a rustproof solution was applied to the front lower control arms. The manufacturer was notified of the failure. The vehicle was not repaired for the most recent failure. The approximate failure mileage was 120,000.
2003 - subaru - forester - body hardware, fender, structural components & rails, lower frame left is completely rotted through. There was a recall on the support strut beside it but none on this. This is a major crash protection component as it connects the bumper to the frame. I talked to the dealer about it and they said there is no recall so it is my problem. Clearly the steel that was used was subject to excessive corrosion in salty/humid road conditions and should have been included as part of the original recall on the strut. The other side (right) is in good condition, indicating defective materials in this part.
The two front sub frames have to be replaced due to rust and thin metal.
My son was driving from new jersey. Suddenly the front hood opened and crashed into the windshield. He was able to move over three lanes to stop the car. The windshield was cracked. This was a hood replacement done last spring after a deer ran across the vehicle. The latch has not been a problem until this trip. On the way to new jersey, my son noticed that the hood partially opened. He stopped the car and made sure that the hood was tightly shut. The same repair shop is installing another hood and replacing the windshield. There is no collision insurance on the vehicle (subaru forester 2003). My two grandsons were passengers in the back seat. My son's fiancee was a passenger in the front seat. The only crash was the breaking of the windshield from the hood.
Upon changing the oil in my 2003 subaru forester I noticed that my sub frame is totally rotted out. I don't know how my car has even stayed together its so bad. I looked the problem up online and I found that it is a major issue with subaru cars. I called subaru to see if they could help to get it fixed and they said its a cosmetic issue and they will not help me. But they did say they will offer me $500 towards the purchase of a new subaru. I asked if they will apply the $500 to fixing my current subaru and he told me no. I am a single mother that depends on my car 100% and I can't afford the repair in the first place, but subaru will give me $500 toward the purchase of a new car.
Questions about the 2003 Subaru Forester body
Does the 2003 Subaru Forester have body problems?
Owners have filed 19 complaints about the body of the 2003 Subaru Forester, 10% of all its complaints.
At what mileage do 2003 Subaru Forester body problems start?
The typical (median) mileage in owner complaints is 132,819 miles.
Was there a recall on the 2003 Subaru Forester body?
There is no recall for this problem on this model year.
What year does the Subaru Forester have the most body problems?
The Subaru Forester model years with the most body complaints are 2014 (27 complaints), 2019 (25 complaints) and 2015 (20 complaints).
Other 2003 Subaru Forester problems
Fuel system 57Engine 31Airbags 25Suspension 22Acceleration 15Brakes 10Transmission 9Visibility 8Electrical 4Locks 4Steering 4Seat belts 3Seats 3Tires 3Wheels 2
VIN decoder
See the problems and recalls for an exact car
Buying a used 2003 Subaru Forester?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history