The speedometer and the entire dashboard goes haywire when driving. It’s impossible to know what speed I’m going, no inspection yet. The cruise control light is on and won’t go off. I’m not sure if it’s on or not which is unfastened and could cause other issues. The check engine light goes on and off as well as the brake and ABS lights. There is no telling what could be wrong with those lights. It gets hard to brake when the brake light and the ABS light is on. Also the transmission gets stuck and I can’t reverse the car or put it in park unless I turn the car off with my foot on the brake and shift in to Park turn the car back on and now I’m able to reverse. That’s dangerous when trying to park on a busy road or parking lot.
Subaru Impreza abs comes on
95 of the 2,654 owner complaints about the Subaru Impreza describe aBS light or ABS activating, most of them for the 2002 model year.
- owner complaints
- 95
- worst model year
- 2002
- typical repair cost reported
- $2,400
- typical mileage
- 19,000
Is there a fix? There are 3 recalls for this area of the car. See below
By model year
Often reported together
Brake failure 11Check engine light 8Adaptive cruise 7Jerking 4CVT failure 3Transmission failure 2Shudder 2Loss of power 2
Trouble codes mentioned
P2764 3U1235 1P0700 1P0021 1P000D 1P000C 1P000A 1C1422 1
What owners say
2019 Subaru Impreza has experienced intermittent and now persistent failures involving the factory EyeSight driver assistance system. Prior to complete failure, the EyeSight system would randomly disable and re-enable while driving. Adaptive cruise control and related safety features became unreliable and would intermittently stop functioning. The issue worsened over time and eventually resulted in repeated “EyeSight Off” warnings and multiple system fault messages. Vehicle diagnostic scans showed repeated U1235 “Lost communication with EyeSight” faults across multiple modules, including ABS, steering, transmission, and instrument cluster systems. Additional communication and airbag indicator-related faults were also present. The windshield was recently replaced due to a crack located near the EyeSight camera area. Subaru service personnel stated that EyeSight systems are extremely sensitive to windshield specifications and calibration requirements, and that aftermarket windshields may prevent proper operation or calibration of the system. Subaru also indicated that EyeSight calibration equipment is highly specialized and expensive, and that repair costs may not be practical relative to the vehicle value. Despite attempts to reset the vehicle systems and inspect the issue, the EyeSight system continues to malfunction and remains disabled. Because EyeSight controls important driver assistance and collision-avoidance features including adaptive cruise control, forward collision warning, lane departure warning, and automatic emergency braking, this issue creates significant safety concerns. The intermittent nature of the failure, repeated communication faults, and inability to reliably restore system operation raise concerns regarding the long-term reliability and serviceability of Subaru EyeSight systems.
Reference complaint no.11684658 confirmed. From email from Tech representative "VDC HYDRAULIC UNIT REPLACEMENT. IT IS AN INTERNAL FAILURE OF THE ABS CONTROL UNIT. THERE ARE SENSORS INSIDE THAT MEASURE BRAKE LINE PRESSURE. THE LEFT FRONT SENSOR IS STUCK AT NEGATIVE 59 BAR. SHOULD BE ZERO AT REST. NOTHING TO DO WITH EYESIGHT THAT LIGHT WILL COME ON WHENEVER THERE IS A WARNING LIGHT ON." The modulator is a safety critical component which undergoes extensive life time testing, one out of 4 pressure sensors should not fail during vehicle life time.
The contact owns a 2012 Subaru Impreza. The contact stated that while driving approximately 30-40 MPH, the vehicle lost power steering functionality and was driven with manual steering. The failure occurred while driving at various speeds. The contact stated that approximately four days after the first failure, the steering wheel failed to move. Additionally, the vehicle was losing oil and one quart of oil had to be added every month. The contact stated that the power steering, ABS, TPMS, transmission automatic transmission fluid (ATF), and 4-WD failure warning lights were illuminated. The passenger occupant sensor chimed for the passenger to secure the seat belt consistently even though the occupant was seated with the seat belt buckled securely. The contact who is a certified mechanic had replaced the rack and pinion. The contact noticed that the threads on the tie rods were close in proximately risking the chance of damaging the tie rods. The ABS module had been replaced. The contact believed that the engine needed to be replaced but the engine was not replaced. The manufacturer was made aware of the failure and opened a case. The manufacturer confirmed there was no recall for the failure. The manufacturer referred the contact to the federal safety agency Hotline to report the failure. The failure mileage was 164,964.
I have been having continuous problems with engine light coming on w the wheel skid light also. I went to Auto Zone and the codes P000D, C1422,P00700 and others. I took vehicle to Subaru to inspect for repair September 11, 2021 The oil temp, traction control light, ABS, and hill control light went off, but the engine light came back on. I left it alone didn't bother with it, figured nothing could be done. I then went to another auto shop on November 28, 2022 because it did bother me about the engine light, someone mention it was dangerous driving w the light on because something could actually be wrong. Also, this shop was to be cheaper. The codes repaired were P000A, P000C, drove off lot engine light came back on. I know it was time for my E- check so I thought I'd give it another try back at Subaru. On July 14, 2023 for repair of engine light. The tests showed repairs for P00A, P00D. They told me they were repairing the vehicle. I left Subaru and about 5 minutes of leaving the engine light came back on. I called them and stated the light was back on, they told me to come in and they could look at it, but I don't have another $ 729.00 to keep giving these auto shops. I had and E-check on July 22, 2023 and didn't pass because of codes P0021 and P000C.
Three warning lights (ABS; Incline start assist; Traction control system) illuminate, while the AT Oil Temp warning light flashes. This happens sporadically and not every time the car is driven. The Subaru dealership mentioned it was some type of module that was tripping the codes. I'm reporting this issue, because I didn't see a recall for it.
Check engine/break/ABS/traction control/ cruise control and AT OIL TEMP lights are all on. Now my back break lights are not working! Car jerks at times. Read on a few forms that this was an issue for Subaru Imprezas 2012 and up. There was also a recall on this issue on April 2019. Please have this recalled again.
Malfunction with my dashboard lights. ABS/ AT OIL TEMP/TRACKTION CONTROL/ HILL LIGHT and CRUISE CONTROL GAGE. Are all on car seems to run somewhat alright until car jerks then all of the mentioned issues comes on.
The contact owns a 2013 Subaru Impreza. The contact stated while driving approximately 20-25 MPH, the brake pedal was depressed but hesitated to respond causing a 3-feet stopping distance delay. The contact also stated that the brake pedal was vibrating and would rest on the floorboard when depressed. The vehicle was taken to the dealer who diagnosed that the front brake rotors, brake pads, and calipers needed to be replaced. The contact stated that the vehicle was repaired however, the failure persisted. The vehicle was taken to an independent mechanic who diagnosed that no issues were found. The contact stated that the failure had been reoccurring while driving. The ABS warning light and the traction control warning light were illuminated. The manufacturer was not notified of the failure. The vehicle was not repaired. The approximate failure mileage was 138,000.
Was driving on I-70 in Colorado going 60-65 mph uphill when all indicator lights came on and AT (Automatic Transition) Oil Temp light began flashing. Check Engine, Hill Assist, ABS, and Traction Control lights all came on steady on. Had to pull over and had significant power loss during driving. Googled what AT Oil Temp light meant and called a tow truck to take to my mechanic. Mechanic initially indicated it could be valve body problem which in his words is a "known issue with Subaru CVT engines." Code pulled was p2764. They ended up pulling the pan and draining fluid and found excessive metal built up on magnet in pan. This pan and headgasket were repaired less than 6k miles ago (October 2020) and at that time they said everything was in good shape so something drastic happened to CVT in less than a year. Mechanic unable to say what caused the excessive buildup in that time. Safety compromised as left on side of very busy highway waiting for tow - we were also concerned with whether or not car would overheat/catch on fire due to AT oil being over 200 degrees. Problem confirmed by our mechanic and indicated that we need a full transmission replacement. No other warnings prior to this event. Maintenance is current and in 2018 performed recall service indicated by Subaru for valve spring issue.
Related recalls
Service brakes, hydraulic
- What is wrong
- Subaru of America, Inc. (Subaru) is recalling certain model year 2008-2011 Impreza, 2008-2014 WRX and STI, and 2009-2013 Forester vehicles, currently, or formerly, registered in Connecticut, Delaware, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia, Wisconsin and the District of Columbia that were remedied under recall 14V‑311 prior to December 23, 2014. The brake lines may experience brake line corrosion due to salt water splashing on the brake lines through a gap in the fuel tank protector.
- Risk
- Brake fluid may leak due to the brake line corrosion and may result in longer distances being required to slow or stop the vehicle, increasing the risk of a crash.
- Remedy
- Subaru will notify owners, and dealers will apply an anti-corrosion wax to the four-way joint connector area of the brake line system, free of charge. The recall began on January 27, 2015. Owners may contact Subaru customer service at 1‑800‑782‑2783. Subaru's number for this recall is WQQ-52. Notes: This recall is specific to affected Forester, Impreza, WRX, and STI customers who had their car remedied under the federal safety agency recall no. 14V‑311 prior to December 23, 2014. Subaru has determined that this remedy was inadequate due to incomplete repair instructions provided to dealers. Affected Forester, Impreza, WRX, and STI vehicles that were not repaired under the federal safety agency recall no. 14V‑311 prior to December 23, 2014 will continue to be processed under the federal safety agency recall no. 14V‑311. Affected vehicles not currently, or formerly, registered in the salt belt states identified in this recall are eligible for repair, at no cost to the customer, upon request.
Recall number 14V830000 · Recall details
Service brakes, hydraulic: foundation components: hoses, lines/piping, and fittings
- What is wrong
- Subaru of America, Inc. (Subaru) is recalling certain model year 2005-2009 Outback and Legacy, 2008-2011 Impreza and 2008-2014 Impreza WRX/STI, and 2009-2013 Forester vehicles, currently, or formerly, registered in Connecticut, Delaware, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia, Wisconsin and the District of Columbia. Salt water could splash on the brake lines through a gap in the fuel tank protector, resulting in excessive corrosion of the brake lines. Note that affected vehicles not currently, or formerly registered, in the salt belt states identified above are eligible for repair, at no cost to the customer, upon request.
- Risk
- Brake line corrosion may result in brake fluid leakage. Fluid leakage may result in longer distances being required to slow or stop the vehicle, increasing the risk of a crash.
- Remedy
- Subaru will notify owners, and dealers will test the brake system by depressing the brake pedal and inspecting for brake fluid leaks. If no brake fluid seepage is observed, the affected areas will be rustproofed with anti-corrosion wax. If brake fluid seepage is observed, the brake lines will be replaced followed by rustproofing with anti-corrosion wax. These services will be performed free of charge. The recall began July 2014 and second notifications will run through November 2014. Owners may contact Subaru at 1‑800‑782‑2783. Subaru's recall campaign number is WQK-47. Note: This recall supersedes recall 13V‑110 which applied to certain 2005-2009 Legacy/Outback vehicles. Vehicles that were remedied under the previous campaign still need additional areas rust-proofed.
Recall number 14V311000 · Recall details
Service brakes, hydraulic: pedals and linkages
- What is wrong
- Subaru is recalling certain model year 2012 impreza sedans and wagons (except wrx/sti models), manufactured from april 21, 2011, through november 15, 2011, and legacy and outback vehicles manufactured from october 17, 2011, through november 23, 2011. These vehicles may be equipped with a brake master cylinder that could malfunction and cause an increase in the amount of brake pedal travel distance required to slow or stop the vehicle.
- Risk
- The driver might misjudge the amount of brake pedal travel required to achieve the desired stopping distance. This could occur unexpectedly and without prior warning, increasing the risk of a crash.
- Remedy
- Subaru will notify owners, and dealers will inspect the brake master cylinder and if necessary, replace it, free of charge. The safety recall is expected to begin during december 2011. Owners may contact subaru at 1‑800‑782‑2783.
Recall number 11V562000 · Recall details
Questions about the Subaru Impreza abs
Why does the abs come on in the Subaru Impreza?
Owners who report it most often also describe brake failure, check engine light and adaptive cruise control problems, and the codes they mention most are P2764, U1235 and P0700.
Which Subaru Impreza years have aBS light or ABS activating problems?
The model years with the most reports are 2002 (44 complaints), 2003 (11 complaints) and 2013 (9 complaints).
How much does it cost to fix ABS light or ABS activating on the Subaru Impreza?
Owners who mentioned a price put the repair at about $2,400 (median of 5 complaints that include a dollar amount). Costs vary with mileage, warranty and where the work is done.
VIN decoder
See the problems and recalls for an exact car
Buying a used Subaru Impreza?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history