Tl* the contact owns a 2007 toyota 4runner. The contact stated while driving 25 MPH, the brake pedal was depressed and went to the floorboard. The contact stated that while making a right turn into his neighborhood, the brake pedal was depressed along with parking brake to stop the vehicle. The vehicle was inspected and the contact became aware of a leak coming from the bleeder valve and caliper. The vehicle was not taken to be diagnosed nor repaired. The manufacturer was not made aware of the failure. The failure mileage was 163,714.
2007 Toyota 4RUNNER brakes problems
29 complaints (19% of all complaints for this car). Typical mileage when it fails: 80,481. 1 crash reported.
- owner complaints
- 29
- of this car's complaints
- 19%
- typical mileage
- 80,481
- crashes
- 1
- recalls
- 0
Which part fails
- Pedals and linkages1
At what mileage
Complaints by mileage at the time of the problem.
Toyota 4RUNNER brakes problems in other years
Specific symptoms reported on the 2007 Toyota 4RUNNER brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
No recalls on record for this model year.
What 2007 Toyota 4RUNNER owners say
Most recent owner complaints, unedited.
The battery died unexpectedly (about 3 years old) and when we replaced it and tried to drive it, there was a loud continuous beep from the dash and no brakes. We replaced the ABS fuse, which blew again immediately. We had to have it towed to the shop and it was confirmed it was the brake module. This exact issue just happened with our 2013 camry and it was replaced under a manufacturer warranty. I drive my kids in this car. We could have died.
Tl* the contact owns a 2007 toyota 4runner. After starting the vehicle, a high pitched audible alarm sounded and the ABS, traction control, and emergency brake sensors remained illuminated. Also, when depressing the brake pedal to stop the vehicle, the brakes malfunctioned and the pedal traveled to the floorboard. The vehicle was towed to jim hudson toyota (970 columbiana dr, irmo,sc) , but the cause of the failure could not be determined. The manufacturer was not contacted. The failure mileage was 111,000.
The whole area of exposed steel has been so corroded with rust that I acnnot even remove bolts to service several of the key components in the engine compartment. The frame, cross members, suspension etc. Are also affected in this way.I'm no expert but it is progressively becoming more and more unsafe to drive especially if I lose brakes or some other necessary function. Please help, is this a bad batch of cheap steel?
Vehicle frame is extremely corroded to the point where replacing necessary items such as shocks/struts/steering components is not possible without irreparable damage. Factory welds at critical points of the frame structure are starting to fail and causing safety concerns. This vehicle is regularly garaged and only has 85,000 miles. This is unacceptable, there have been previous recalls and for other models that share this exact same frame and suspension.
When I am driving on a bumpy unlevel street and stepping on the brake paddle to slow down the brakes give out and then catch again, I find this to be very dangerous and might even cause an accident especially if there is another car to my front, this has happened to me quite a few times. The brake system has to be checked on a bumpy paved road, brakes will catch and release and catch and release. This happens every time I am on a bumpy paved road.
Complete and permanent damage of ABS and brake module ian's results in no brakes while running the car.
"I am requesting that dot the federal safety agency investigate the driver's contribution to unintended acceleration (ua) and toyota's accelerator/brake pedal designs that make it possible. I was driving my toyota 4 runner in the neighborhood street of my community. My speed was less than 30mph and it accelerated suddenly. I applied the brake and instead of slowing down the vehicle began to gain speed. I pressed harder on the brake and it accelerated. The harder I tried to stop the car, the faster it went. I took my foot off the brake for a moment and the vehicle stopped accelerating. My foot was on the brake. It accelerated and would not stop so I pulled the car from the street to the curb covered by grass. It slowed down to some extent and then I intentionally to a turn and hit the median curb & tree to stop the car. I have continued to investigate unintended acceleration and have collected partial information.... Please formally investigate."
Actuator/accumulator/mastercylinder squeak/squeal
The braking system vibrates and squeals when driving and braking... Told the ABS/master cylinder system needs to be replaced at the cost of $3082.25. Started noticing problems at about 128000 miles on vehicle. Doesn't seem right that there is a major malfunction/repair needed with such low mileage
Questions about the 2007 Toyota 4RUNNER brakes
Does the 2007 Toyota 4RUNNER have brakes problems?
Owners have filed 29 complaints about the brakes of the 2007 Toyota 4RUNNER, 19% of all its complaints.
At what mileage do 2007 Toyota 4RUNNER brakes problems start?
The typical (median) mileage in owner complaints is 80,481 miles.
Was there a recall on the 2007 Toyota 4RUNNER brakes?
There is no recall for this problem on this model year.
What year does the Toyota 4RUNNER have bad brakes?
The Toyota 4RUNNER model years with the most brakes complaints are 2004 (82 complaints), 2003 (74 complaints) and 2006 (34 complaints).
Other 2007 Toyota 4RUNNER problems
Body 40Acceleration 21Suspension 14Electrical 13Transmission 11Engine 10Visibility 10Steering 9Airbags 6Locks 4Tires 3Seats 2Wheels 2Driver assistance 1Fuel system 1Lights 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2007 Toyota 4RUNNER?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history