My 2003 Sequoia was in the garage for a check on the brakes. I also asked them to check the frame for any rust issues, because I had previously been concerned about it earlier. They reported to me that the car should be off the road because the rust in the frame was so severe. They said they would not put it up on the lift anymore because it could break in half. The stabilizer was barely connected at one end. There were holes completely through the frame at several places. I know from my research that Toyota issued safety recalls for 2003 Sequoia and Tundra vehicles. This an issue that Toyota should repair.
2003 Toyota Sequoia suspension problems
40 complaints (7% of all complaints for this car). Typical mileage when it fails: 107,433. 2 crashes reported.
- owner complaints
- 40
- of this car's complaints
- 7%
- typical mileage
- 107,433
- crashes
- 2
- recalls
- 1
Which part fails
- Front: control arm: lower ball joint7
- Front2
- Rear1
- Front: stabilizer bar1
- Front: control arm: upper ball joint1
At what mileage
Complaints by mileage at the time of the problem.
Toyota Sequoia suspension problems in other years
Specific symptoms reported on the 2003 Toyota Sequoia suspension
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Suspension: front: control arm: lower ball joint
- What is wrong
- On certain sport utility vehicles, due to a manufacturing issue in the front suspension lower ball joint, there is a possibility that the surface of the ball of the joint may have been scratched. The ball joint may eventually experience excessive wear and looseness, resulting in increased steering effort.
- Risk
- The lower ball joint may separate from the knuckle causing loss of steering control and a crash could occur.
- Remedy
- Dealers will replace the front suspension lower ball joints free of charge. The recall began on july 5, 2005. Owners may contact toyota at 1‑800‑331‑4331.
Recall number 05V225000 · Recall details
What 2003 Toyota Sequoia owners say
Most recent owner complaints, unedited.
Front end in rolled shacking. Tires wearing extremely fast and uneven image. Unable to drive
Abnormal rust all over underside of vehicle including frame, structural components, brake lines, steering components … etc. FRAME and steering/suspension components rusting out. Rear differential rusting out. Cab mounts rusting out. Spare tire hardware rusting out. Transmission cooler lines about to burst from corrosion. Rear tow assembly rusting out. Entire underside is rotting out. Known issue which has plagued hundreds of owners, but Toyota has not recalled this model year. Extremely dangerous; one brake line has already gone out resulting in a loss of braking. Toyota applied an undercoating circa 2013 but they just sprayed over an already rusted frame and other components without proper preparation which actually accelerated the corrosion and rot. Deceptive and unethical business practices. Vehicle cost over $50,000 new in 2003 and only has just over 120,000 miles on it. This should NOT be happening. Please help. Please investigate.
Hello, I am writing to you to have an investigation started on 2003 Toyota Sequoia, I own one and there has been concerns with the Frame of the vehicle rotting out, there was Warranty Enhancement Program sent out in United States to cover frames of 2001 to 2004 Toyota Sequoias which replaced severely rusted out frames at the dealership. I use this vehicle for my family and I do not want to endanger the lives of them and the people around the community where the frame may break due to rust and cause a severe accident. Please take a look at the details below and get back to me. Subject: Limited Service Campaign (LSC) CSD Certain 2001 through 2004 Model Year Sequoia Vehicles Frame Inspection I am located in Canada would like NHSTA to investigate and see if this program can be administered to vehicles in Canada since I have severe rotting of the frame and I have had to have it welded many times to not compromise the safety of the vehicle
Unknown
The latch hook/truck door release has a defect. It has been replaced 3 times after purchase of my vehicle , by the following Toyota dealerships (Tejas Toyota in Humble Texas (2x); Maund Toyota in Austin, Tx (1x). Each dealership service said it was/is manufacture defect with the latch hook and it stops “un latching when the vehicle the button is pressed to unlock and the handle can not open the hatchback” This time I was traveling out of state with my pet in the kennel and when we stopped for restroom break the latch would not open to retrieve the pet to let out the kennel. We were traveling with a vehicle full of items, which the entire inside of the vehicle had to be emptied I ordered to let all the seats down and try to maneuver to try to get my dog out of kennel I. Such a small confined space that was hard to open because it was in the side. It took over and hour to cut the cage at the top to retrieve my pet. The sad part is there was no warning because we were traveling a 13 hour trip, stopping every couple hours for breaks and stretches, and the couple hours before we open the hatchback just fine. This is more than a safety concern for the animal. This is also the ares for retrieving the spare tire underneath the vehicle when the spare has to be released. I have replaced the part 3 times and I am charged $600 cost for parts and labor, when Toyota is aware of the defect. I just had the part replaced 19 months ago and Toyota only gives a 12 warranty on the part. This is ludicrous when the manufacture is aware of the ongoing problem. I have purchased 4 prior Toyota’s and never had had this type of problem. My second safety issue is the case gage drops below the empty gage and stays there even though there is gas in the vehicle. The dealership said there was a recall years ago but I never received any notice. Please advise.
Tl* the contact owns a 2003 toyota sequoia. The contact stated that while having a tire replaced on the vehicle, the technician noticed that the driver's and passenger's side underneath the vehicle was extremely corroded. The technician deemed the vehicle unsafe to drive. The vehicle was not repaired. No dealer was contacted. The manufacturer was notified of the failure and informed the contact that the VIN was not under recall. The failure mileage was approximately 235,000.*dt
When driving about 45 or 60 MPH the steering wheel shakes real bad an vibrates feels like I got a flat tire or feels like I'm gonna have a tire come off when I bought it also consumes a lot of gas ust to get real good gas mileage but now not so good juust to fill up twice a week but now sometimes 3 to 5 timeswhich is weird didn't know I had a recall warranty I have had to replace a lot of things especially in the emissions part for car bought new fuel line solenoids , purge solenoid, now it says I need a new valve vent solenoid. There is a vacuum leak other than that runs good doesn't over heat or break unless I needed to but uses a lot of ga shakes real bad I don't wanna drivemorethan 70 MPH all the tires are at 41 psi
Took vehicle to local toyota dealership due to steering issue - when I would hit a bump I would loose control of the steering. Inspection showed the vehicle under body and frame has completely rusted, there are sever holes and the trailing arm has separated from the frame. I am not the original owner, but toyota had a recall on the frame during the prior ownership and the vehicle was serviced multiple times at a toyota dealership during the recall and the problem was not addressed. Toyota refuses to offer any assistance at this time.
The frame on the car is rusting away with only 40k miles on it. It was garage kept.
Questions about the 2003 Toyota Sequoia suspension
Does the 2003 Toyota Sequoia have suspension problems?
Owners have filed 40 complaints about the suspension of the 2003 Toyota Sequoia, 7% of all its complaints.
At what mileage do 2003 Toyota Sequoia suspension problems start?
The typical (median) mileage in owner complaints is 107,433 miles.
Was there a recall on the 2003 Toyota Sequoia suspension?
Yes, 1 recall: 05V225000. Check your VIN to see if your car still needs the free repair.
What year does the Toyota Sequoia have bad suspension?
The Toyota Sequoia model years with the most suspension complaints are 2002 (50 complaints), 2001 (48 complaints) and 2004 (47 complaints).
Other 2003 Toyota Sequoia problems
Driver assistance 194Brakes 155Body 98Acceleration 91Electrical 66Airbags 41Engine 30Steering 23Locks 13Transmission 13Visibility 11Fuel system 9Tires 9Lights 5Wheels 5Seat belts 2Seats 2
VIN decoder
See the problems and recalls for an exact car
Buying a used 2003 Toyota Sequoia?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history