When backing up my 2009 toyota venza, we experience rapid, unintended acceleration when applying just a gentle depression of accelerator.
2009 Toyota Venza transmission complaints
Page 2 of 2: complaints 11 to 19 of 19, newest first, as owners wrote them.
I was in the process of merging onto the ohio turnpike and depressed the gas pedal to accelerate and pass a slow-moving semi in front of me. The car accelerated and once past the semi I released pressure on the gas pedal only to have the car continue to accelerate. Despite pressing the brake the vehicle did not slow. As I prepared to shift into neutral gear I reached down and pulled the floor mat to the diagonal corner opposite the gas pedal. With that action the pedal appeared to become responsive to pressure and the car decelerated. A rear seat passenger observed a warning light appear on the instrument panel indicating a master system warning. The light disappeared as soon as the vehicle began to slow. No other actions occurred following the incident.
I was driving at 35-40 MPH, pulling up to an intersection. I gradually hit brakes to reduce speed, and the car surged forward twice. Both feet slamming on the brake pedal were required to stop the vehicle. It has happened only once, but caused great alarm and poses a potential serious safety problem. This was under light braking initially, with no pressure on the accelerator when the car surged forward. It is unknown whether the accelerator or computer was at issue. Floor mats were not involved.
My toyota venza 2009 automatic transmission - when the transmission is in "drive" the car rolls back even on relatively mild slopes. It happens about 40% of the time.
Tl*the contact owns a 2009 toyota venza. The contact was driving in reverse approximately 5 MPH out of the driveway in rainy weather conditions and slight pressure was applied to the brake pedal when the vehicle unexpectedly accelerated. The idle speed was slow; yet, the driver was able to stop the vehicle. The failure occurred whenever the gear was in the reverse position. The vehicle has not been repaired for the malfunction. Updated 03/09/10. *lj the consumer states sometimes when backing up, the idle speed is not sufficient to make the vehicle move in reverse. Updated 06/04/10
Driving in residential area, 20-25 MPH, made turn, and when accelerator was pressed to accelerate, the car would not go forward. It was as if the car had slipped into neutral, but it was still in drive. I put the car in neutral and then back in drive and it still would not go. The car, however, would go in reverse. Several attempts made shifting from other gears to drive (including the sequential shift) without success. Finally drove the car in reverse for a short distance, then put it in drive and the gear engaged and it went forward. Contacted dealer and had the car towed to shop. Dealer could not duplicate the error and said nothing could be done until an error code was found or the problem was duplicated. Contacted toyota corporate and they referred us back to the dealer. The problem has not recurred, but if it happened once it will probably happen again. Next time, I could be in freeway traffic. I feel this is a safety hazard.
I accelerated to make a lane change,vehicle took off to increasing acceleration I attempted to brake car would not respond. Luckily no traffic was ahead of me. Finally car managed to stop. I didn't think it would. I had to practically stand on brake pedal. I was assuming some how the cruise control was inadvertently pressed but no it was not.
Tl* the contact owns a 2009 toyota venza. When attempting to shift gears or during brake activation the traction control activates. Usually after 30 seconds the traction control mode is deactivated. The vehicle was taken to the dealer twice for inspection. The technician concluded that because they could not duplicate the failure, they could not provide a remedy. He then added that although the failure was common for his model type, they have not developed a remedy. The failure mileage was 100. The current mileage was 1300.
2009 toyota venza (manufactured -oct./08), 6 cylinder. Was in park,about to go in reverse to back out of level driveway, foot on brake, car would not engage in reverse! Foot brake pedal felt tense and inflexible. Ie. Would not move even with applied foot pressure. Flashing traction control light came on. Turned off car then restarted and repeated effort to back out. Same thing! Again repeat steps, repeated same response. Tried turning off traction control and turning back on several times. No idea what did it, but finally was able to back out.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2009 Toyota Venza?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history