Tl* the contact owns a 2007 workhorse w18. The contact stated that the vehicle veered left and right while driving approximately 50 MPH. The failure occurred without warning. The vehicle was not taken to an independent mechanic or dealer to be diagnosed or repaired. The manufacturer was notified of the failure. The contact referenced the federal safety agency campaign number: 08v442000 (steering). The manufacturer informed the contact that they had no obligation to complete the recall repair because it was expired. The failure mileage was 8,500.
The worst 2007 Workhorse W18 problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
- Steering2
- Electrical1
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
- Steering2
- Electrical1
Recalls 1
Steering: gear box: shaft pitman
- What is wrong
- Workhorse is recalling 5,606 my 2006-2008 w42 commercial chassis and w18 recreational vehicle chassis. The castle nut that retains the steering drag link to the pitman arm may have been improperly torqued during assembly. The improper torque may have damaged the castle nut and compromised the integrity of the connection.
- Risk
- If the drag link were to separate from the pitman arm, the driver would not have directional control of the vehicle possibly causing a crash.
- Remedy
- Dealers will replace and properly tighten the castle nut that retains the steering drag link to the pitman arm. The recall began on september 19, 2008. Owners may contact workhorse at 1‑877‑946‑7731 or at http://www.navistar.com.
Recall number 08V442000 · Recall details
Technical service bulletins for the 2007 Workhorse W18 1
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
What 2007 Workhorse W18 owners say
Most recent owner complaints, unedited.
While vehicle is being driven, entire dash cluster zeros and alarms go off. All instruments then come back on except alarm stays on . Can only silence alarm by unlatching seat belt and re-latching it. This is dangerous ; action must be done while vehicle is rolling generally at speed limit. Cannot have hands on steering wheel and disconnect seat belt and reconnect it. Reported problem to manufacturer months ago they say they are working on it. Also on same vehicle, constant steering is required. Steering is loose while rolling down road. Manufacturer recommended certain tire pressures and alignment check when vehicle is loaded. I have done this and problem is the same. I have checked forums by other owners and many are experiencing the same problems. I think a recall is in order.
Compare the 2007 Workhorse W18
Other model years
20062007
Questions about the 2007 Workhorse W18
Is the 2007 Workhorse W18 reliable?
Owners have filed 2 complaints about the 2007 Workhorse W18, close to a typical W18 model year.
What is the most common problem with the 2007 Workhorse W18?
Steering, with 2 complaints. Next is electrical (1).
How many recalls does the 2007 Workhorse W18 have?
1 recall, covering steering.
Was there a recall on the 2007 Workhorse W18 steering?
Yes, 1 recall: 08V442000. Check your VIN to see if your car still needs the free repair.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2007 Workhorse W18?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history