2007 Yamaha FJR1300 electrical problems

Filed Aug 31, 2016 · Electrical · 36,455 miles · IL

Failure on repair of the federal safety agency recall number: 11v338000 recall date: june 28,2011 manufacturer recall number: 990061 failure description: on monday 8/22/2016 , I started experiencing electrical issues. I was stranded and could not start bike. Having read on 'fjrforum.com ' about "ground wire junction connection" or 'ground buss connectors' issues and the symptoms associated with them, I suspected that I have a 'ground buss connectors' issue. My bike had the recall done in 2011. Symptoms: intermittent a) ignition in on position, not attempting to start bike. 1) brake activated (either hand or foot) -> brake lights work normally and no abnormal activity 2) raise/lower windscreen -> results in very slow or no movement and the bright light indicator illuminates. 3) hit horn -> no horn sounds but both turn signals light and the bright light indicator illuminates. 3) turn on either turn signal -> the turn signal will flash and the bright light indicator illuminates b) ignition in on position and attempt to start bike: 1) intermittently will start, but if not nothing except to illuminate the bright light indicator. 3) if it does start, lights may go out! Random turn signal behavior! Investigation: I inspected all "ground joints"(aka spiders) . I completed my inspection on friday, aug. 26. Primary finding is that the connector that manufacturer recall number 990061 was suppose to fix has a pin that is intermittently shorting resulting in scorch/burn marks on the female connector. I can only speculate that when the recall was performed that it was either not done correctly or that the connector already had damage that was either undetected or ignored. At any rate, it's a failure of a safety recall ! I have attached photos of the recall failure. I want yamaha to inspect and if need be replace wiring harness per manuf. Recall no. 9900062

Filed Jun 15, 2015 · Electrical, Engine · 45,000 miles · CA

High beam indicator came on, turn signals failed to operate, bike would not restart after stopping. This was all caused by ground spider 6 burning and failing.

Filed Apr 11, 2012 · Electrical, Lights · 25,590 miles · TX

Bike has had the factory recall that connects a more direct path of battery ground to the s 4 buss. However, this only helped with load on the components of the s4 connector. My lights went out because the down stream from the s4 connector, the s6 (had burned contacts) which the feed the s7 connector for the lh head light and the s8 connector for the rh headlight. The combination of current from both lights thru one pin at the s6 connector cause the connector to build up heat damage and kill the ground path for both headlights at the same time.

Filed Jul 20, 2011 · Electrical, Lights · 32,328 miles · WA

I was riding home from work in the dark on my 2007 yamaha fjr1300 motorcycle on a unlit, curvy, rural road when both my headlights suddenly died. Although I was able to avoid crashing, this is a huge safety concern. I am a 30 year experienced auto/motorcycle mechanic and certified as an aircraft mechanic, so I troubleshot and found the headlight failure was caused by an overheated/burned grounding connector located in the wiring harness above the left headlight shell (burnt connector and/or photo available on request). Because the connector was no longer useable, I cut the connector off and soldered all the wires together to restore the ground path for the headlights. As of today, with 52,000 miles on the motorcycle, there have been no additional failures of the headlights. I hasten to add that this failure is unrelated to the federal safety agency campaign # 11v‑338, which addresses a failure of a grounding connector under the fuel tank on the motorcycle. As a very active member in the online yamaha fjr1300 owners community at www.fjrforum.com, I am very in tune with all matters related to this motorcycle and would be more than happy to assist in an investigation of this serious safety defect.

Filed May 11, 2011 · Electrical · 12,000 miles · WA

Electrical failure due to an inadequate ground wire system.

Filed Apr 7, 2011 · Electrical · CA

2007 fjr1300ae grounding harness fired at connector s4. A common occurrence on these motorcycles. Once this happens the bike goes dead and is unrideable as the entire grounding system is shot. Very dangerous to have happen at speed. I had to install an aftermarket grounding harness to alleviate the amount of voltage running through the original system. I also needed to clean up the existing ground spiders and rewire a few connections.

Filed Feb 21, 2011 · Electrical · 34,000 miles · CA

The engine quit, and everything went dead except for the instrument panel, where every light came on, and the fuel level lcd started flashing. Turning the ignition off and taking the key out did nothing. Everything stayed lit up. Then a few minutes later, everything turned off, and I was able to re-insert the key, and start her right up. This happened in traffic during a normal commute, on two occasions within 24 hours. It was easily reproducible by inserting the key turning the bike on, and repeating a few times until it re-occurred. At the shop, they discovered the main wiring harness had been improperly grounded, causing a short that resulted in system-wide disabling of the electrical system.

Filed Dec 29, 2010 · Electrical · 27,000 miles · MO

2007 yamaha fjr-1300. Engine would intermittently die and would not re-start. Along with this, all lighting I.e. Headlights and taillights would go out. Upon investigating the issue, I found faulty electrical grounding "spiders". I am in the process of installing an aftermarket grounding loom as a fix to this problem this is a potentially deadly issue as the bike dies and all the lights are out.

Filed Nov 14, 2010 · Electrical · 54,000 miles · CA

I have a 2007 yamaha fjr 1300 motorcycle that has ground spider failure. I first experienced a problem in june while on a ride from san diego to oregon. The circuit with my running lights and turn signals went out. The fuse burned and it would not accept a new fuse without burning it out. It started working correctly again on its own and we finished our trip. I rode a few times after that then parked it during the summer heat to do maintenance. The bike was down for a few months while I was busy at work and I just finished maintenance this week after two months. On my test ride I noticed the running lights and turn signals were off. I checked the fuse for that circuit and it was blown. I then decided to check the ground spiders since there have been many reported failures on the fjrforum.com discussion board. I found a burned ground spider and wires.

Filed Oct 25, 2010 · Electrical · 18,933 miles · FL

2007 yamaha motor cycle model # fjr1300a. Engine cut off while driving and will not restart. Faulty ground wiring harness spyder connections.