After tightening the harness, the straps slip and loosen completely on their own without pressing the release button. This happens due to normal movement while driving, leaving my child completely unrestrained and unprotected. I have already followed the manufacturer guidelines to thoroughly clean the adjuster mechanism and the strap area with warm water to rule out any debris or buildup. While it seems to hold for a brief period, the mechanical failure returns after a couple of days.
The worst 2018 BMW 320I problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
- Electrical7
- Engine5
- Fuel system5
- Airbags4
- Brakes3
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
- Electrical7
- Engine5
- Fuel system5
- Airbags4
- Brakes3
- Transmission3
- Acceleration2
- Driver assistance1
- Seats1
- Steering1
Recalls
No recalls on record for this model year.
Defect investigations
Desiccated Air Bag Inflator Rupture
From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.
EA21002
Technical service bulletins for the 2018 BMW 320I 94
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- The basic conditions for initializing the power windows are not met.
- The electrical system of BMW vehicles has been subject to an ongoing development process over the last few...
- Diesel fuel injectors: ltd wty extension to 10 years/120,000 miles
- Pressure control valve (pcv) extended ltd wty 15 years/150,000 miles
- Check Control message (CCM) indicates: (ID 213): Stop, exercising due care
- After programming the head unit (HU-H2), activating the FSC (German word Freischaltcode) Enabling Codes...
- Exterior rear lights do not work.
- The 3G network in the US has been shut down
- For the eligible vehicles, BMW of North America, LLC (BMW NA) is extending the limited warranty for the...
- After an automatic engine start (MSA start), the transmission intermittently goes into the Park "P" or...
2018 BMW 320I fuel economy
Official EPA estimates in miles per gallon (MPGe for electric). Ranges cover trims that share the same engine.
| Engine | Drive | City | Highway | Combined |
|---|---|---|---|---|
| 2.0L 4‑cyl | RWD | 23-24 | 35 | 27-28 |
What 2018 BMW 320I owners say
Most recent owner complaints, unedited.
The contact owns a 2018 BMW 320I. The contact stated that while the vehicle was parked, the vehicle unexpectedly started rolling forward. The brake pedal was depressed; however, the brakes failed to immediately respond. The contact stated that the vehicle eventually came to a stop. The contact referenced an unknown recall for the failure, but the VIN was not under recall. The vehicle was driven to an independent mechanic but was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 72,000.
On 09/16/25, I was exiting the Florida turnpike onto Sawgrass Highway via the exit ramp on exit 71. As I decelerated from 60 MPH to 35 MPH to match the speed of the exit ramp, I was in the left most lane in the two-lane exit ramp. My car spun out and I lost control of the vehicle, which caused the vehicle to spin through the two lanes of the ramp several times and ended up drifting onto the edge of the retention pond on the left of the exit ramp. I probably had spun around over three times and my car hung off the edge of the retention pond with the only thing preventing my car from falling into the pond being the rocks to prevent erosion on the side of the pond. The airbags on the drivers side and the curtain airbags both had deployed upon the car coming to a stop. The seatbelts were also locked upon trying to exit the car. The car was fully serviced prior to the incident and in good standing with BMW. The brakes were recently replaced a month ago and regular milestone inspections were conducted on the car. The road conditions on the day in question were great with no water or puddles on the road.
The contact owns a 2018 BMW 320I. The contact stated that while driving 55 MPH, the vehicle failed to accelerate as intended while depressing the accelerator pedal. The message Engine coolant system, coolant pump outside of speed tolerance" and code 20A701 was displayed. The contact stated that the vehicle failed to accelerate, and the contact drove 8 MPH back to the residence. A fuel-burning odor was on the interior and exterior of the vehicle. The vehicle was not taken to the dealer or an independent mechanic. The contact stated that on a separate occasion, while her husband was driving, the failure reoccurred. The contact's husband arrived at the residence and became aware that the water pump had failed and was no longer functioning as intended. Upon further investigation, the contact related the failure to the federal safety agency Campaign Number: 21V907000 (FUEL SYSTEM, DIESEL). However, the VIN was not included. The vehicle was not repaired and was parked at the residence. The manufacturer was made aware of the failure and referred the contact to the NHSTA Hotline for assistance. The failure mileage was approximately 84,000.
• What component or system failed or malfunctioned, and is it available for inspection upon request? The plastic fuel tank failed and developed a leak. Yes, the tank is available for inspection upon request. • How was your safety or the safety of others put at risk? A leaking fuel tank poses a serious fire and explosion hazard, especially when the vehicle is operating or parked near heat sources. Gasoline fumes were noticeable, creating an increased risk of ignition and exposure to toxic vapors. • Has the problem been reproduced or confirmed by a dealer or independent service center? Yes. The problem was confirmed by an independent mechanic, who verified the leak in the fuel tank. • Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? The vehicle has not yet been inspected by BMW or other officials. Only an independent mechanic has inspected it so far. • Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? Yes. A check engine light appeared shortly before the failure. In addition, a strong smell of gasoline was noticed, followed by visible leaking fuel. There is an open recall on the BMW F30 BMW 320i, production date 2013 to 2018, production dates July 02, 2012 to March 23, 2018 for the “plastic fuel tank.” I own a 2018 BMW 320i, manufactured April 2018 which is not included in the recall for the “plastic fuel tank.” However, I noticed a gasoline smell and the fuel tank is leaking. Upon further research, inspection and after notifying a mechanic, the fuel tank for my vehicle is the exact same one as the plastic fuel tank indicated in the BMW recall. My production date is a week later than the recall production date, but the fuel tank is the same exact fuel tank that has been recalled. The vehicle has developed a serious safety defect in the plastic fuel tank, which is leaking gasoline and emitting fumes.
Was simply driving my vehicle to work. It started overheating parked it right away before it got worse as the car alerted had it towed to a shop. The shop informed me that the motor was blown in the pistons went through the motor something with the oil the mechanic and I were looking further into this and it looks like my make and model in year had some recalls about the motor overheating in the past so I would really like this looked into as this might be a recall I’m not sure what else this could be or why this would happen with such low miles
My passenger airbag sensor malfunctioned and the repair is over two thousand dollars. The car is only 6 years old and I believe airbags should last longer than 6 years. BMW has extended warranties for airbags on some models (mine not included) for 15 years without mileage limitation. If a collision occurs, my passenger would be in extreme danger.
Gas tank began leaking from top of blind flange, similar to other extended warranties (SIB 01 03 22 and SIB 01 07 22). BMW is refusing to cover my specific model year (I have sent letters requesting reimbursement and called multiple times). It created an explosion hazard in my garage. Had mechanic repair, I do not have part. Cost $2,000 for new tank that will probably develop same issue. There were no warning lamps.
My 2018 bmw 320 stalls and cuts off when I come to a stop. Very dangerous. It has cut off in the middle of the road. I have checked online to see if this is a common issue. Other bmw owners have reported this same issue. There has been a recall on other bmw models with this same issue from 2014-2018 for fuel system and fuel pump that may cause this issue. Letters were sent out I. January of 2022. My 2018 bmw 320si has not been included in this recall for some odd reason. When car shuts off a warning message appears on screen. One message states “transmission not in park.” Or “drivetrain malfunction”. This began to happen on November 2022. I have taken my vehicle to two dealers. One was an independent repair shop and the other was a bmw service center. Both reported issues with fuel pump that would cause this problem.
The electrical call system malfunctions. I’ve done extensive research and actually confirmed with Garret today at A&L BMW that there is a problem in the manufacturing of the shark fin. The gasket that BMW uses does not hole up and the sealant does not keep water from leaking into the fin. Every time it rains/snows or the vehicle is wet the system malfunctions. Currently it only has the ability to affect me if I were in a wreck and won’t notify emergency services. This has the ability to shut down all electrical functions in my car and has been a common issue in BMW dating back as far as 2015. I called them in April to have it looked at, but I didn’t understand the problem and it had ceased. But since the weather has now began to be more frequently wet, this problem has become more persistent. Now they won’t cover because the final warranty expired in December of 2023. This should be recalled because it is a manufacturing issue.
Compare the 2018 BMW 320I
Other model years
Questions about the 2018 BMW 320I
Is the 2018 BMW 320I reliable?
Owners have filed 21 complaints about the 2018 BMW 320I, 2.3 times a typical 320I model year.
What is the most common problem with the 2018 BMW 320I?
Electrical system, with 7 complaints. Next is engine (5).
How many recalls does the 2018 BMW 320I have?
No recalls on record.
What gas mileage does the 2018 BMW 320I get?
Official estimates for the 2018 BMW 320I range from 27 to 28 mpg combined. The most efficient version (2.0L 4-cyl, RWD) gets 23-24 city and 35 highway.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2018 BMW 320I?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history