To Whom It May Concern, I am writing to formally report a vehicle fire that occurred on [XXX] at approximately [XXX] in Alabama State University. The vehicle involved is a 2012 BMW 640i Coupe (black) with the license plate number [XXX]. The fire started while driving. Within a matter of minutes, the fire rapidly spread, and despite any initial efforts to contain it, the vehicle was completely engulfed and fully burned. Fortunately, my son and passenger were not injured or trapped in vehicle. The fire department was contacted, and they arrived at the scene at [XXX]. They extinguished the fire and conducted an initial investigation. I am awaiting their official report, which will be forwarded as soon as it is available. If any further information is required, please do not hesitate to reach out to me at [XXX] . Thank you for your attention to this matter. Sincerely, [XXX] [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
The worst 2012 BMW 640I problems
Ranked by number of owner complaints. Mileage and cost come from what owners wrote.
- Electrical1
Problems by type
Tap a problem to see which part fails, at what mileage and in which other years.
- Electrical1
Recalls 2
Fuel system, gasoline: delivery: fuel pump
- What is wrong
- BMW of North America, LLC (BMW) is recalling certain model year 2007-2011 BMW X5 3.0si, X5 4.8i, X5 M, X5 xDrive30i, X5 xDrive35i, X5 xDrive48i and X5 xDrive50i, 2008-2011 X6 x Drive35i, X6 xDrive50i and X6 M, 2010-2011 X6 ActiveHybrid, 535i xDrive Gran Turismo, 535i Gran Turismo, 550i xDrive Gran Turismo and 550i Gran Turismo, 2011-2012 528i, 535i, 535i xDrive, 550i and 550i xDrive and 2012 535i ActiveHybrid, 640i Convertible, 650i Convertible, 650i xDrive Convertible, 650i Coupe and 650i Coupe xDrive vehicles. The affected vehicles have in-tank fuel pumps that may have insufficiently crimped wire contacts.
- Risk
- The loose wires may cause the connector to melt, resulting in a fuel leak. Additionally, the fuel pump may stop working, possibly causing an engine stall and increase the risk of a crash.
- Remedy
- BMW will notify owners, and dealers will replace the fuel pump module, free of charge. The recall began February 2017. Owners may contact BMW customer service at 1‑800‑525‑7417.
Recall number 16V746000 · Recall details
Engine and engine cooling: engine
- What is wrong
- BMW of North America, LLC (BMW) is recalling certain model year 2010-2011 128i Coupe, 128i Convertible, 328i Sedan, 328i xDrive Sedan, 328i Coupe, 328i Convertible, 328i Sports Wagon and Z4 sDrive 30i, 2011-2012 135i Coupe, 135i Convertible, 335i Sedan, X5 xDrive 35i, and X6 xDrive 35i, 2011 335i xDrive Sedan, 335i Coupe, 335i Convertible, 528i Sedan, 535i Sedan, 535i xDrive Sedan, X3 xDrive 28i, and X3 xDrive 35i, 2010 X3 xDrive 30i, and X5 xDrive 30i, 2012 640i Coupe, and 640i Convertible and 2010-2012 535i Gran Turismo vehicles. In the affected vehicles, the bolts that secure the housing for the variable camshaft timing adjustment (VANOS) unit can loosen over time and may possibly break.
- Risk
- If the bolts loosen or break the engine may have reduced power or stall. An engine stall increases the risk of a crash.
- Remedy
- BMW will notify owners, and dealers will replace the four VANOS housing bolts for both VANOS units (intake and exhaust), free of charge. In addition, owners of approximately 170,172 model year 2010-2012 BMW vehicles equipped with inline 6 cylinder engines not covered by this recall, will receive an extended warranty to address this condition. The recall began on September 24, 2014. Owners may contact BMW at 1‑800‑525‑7417.
Recall number 14V176000 · Recall details
See all 2 recalls for the 2012 BMW 640I
Defect investigations
Desiccated Air Bag Inflator Rupture
From 2000 through 2017, Takata produced millions of air bag inflators using two types of phase-stabilized ammonium nitrate ("PSAN") propellant -- propellant 2004 and propellant 2004L. After prolonged exposure to high temperature cycles and humidity, inflators using propellant 2004 can degrade, causing the propellant to burn too quickly when ignited. The rapid burning can cause the inflator to rupture during deployment, potentially causing serious or even fatal injury to vehicle occupants. See 2016 Blomquist Report at all frontal inflators using propellant 2004 that do not contain a "desiccant" (a substance that traps and holds moisture) in US vehicles are under recall. These "non-desiccated" inflators either have been or are required to be replaced.In some cases, the remedy part for these recalled inflators was, or will be, an inflator using either propellant 2004 or 2004L that does contain a desiccant. None of these "desiccated" remedy parts (which were installed in older model year vehicles) are currently under recall for a degradation concern. Certain subsets of desiccated PSAN inflators using propellant 2004 for use as original equipment, however, have been recalled for a degradation concern. All Takata inflators produced with propellant 2004L contain desiccant, and none of these desiccated inflators using propellant 2004L are under recall for a degradation concern. There have been no reported field ruptures in any non-recalled desiccated PSAN inflators.It is understood that desiccants fully saturate at some threshold, at which point any additional moisture will not be captured. This means the degradation process observed in non-desiccated inflators using propellant 2004 may also occur in non-recalled desiccated inflators using propellant 2004, assuming additional moisture enters the inflator and high temperature cycling occurs. Based on available information, desiccant saturation can occur within the first five years in the worst environments, and the time required for full saturation is affected by multiple factors. While no present safety risk has been identified, further work is needed to evaluate the future risk of non-recalled desiccated inflators using propellant 2004.Three entities -- Takata (now known as TK Global), the Independent Testing Coalition, and Exponent -- have been studying the long-term behavior of Takata desiccated PSAN inflators using propellant 2004L (as well as 2004) in the presence of moisture and temperature cycling. The research efforts, which include development of predictive modeling techniques and field sample analysis, are ongoing. To date, none of the researchers have identified field evidence showing that propellant 2004L is undergoing a degradation process that leads to aggressive deployment and potential rupture. However, the time in service of such inflators remains short compared to that of the inflators using propellant 2004. Further study is needed to assess the long-term safety of desiccated inflators using propellant 2004L.The Office of Defects Investigation is opening this investigation to examine whether a safety defect related to propellant degradation exists in non-recalled desiccated PSAN frontal inflators manufactured by Takata. This investigation will require extensive information on Takata production processes and surveys of inflators in the field. Lists of recall actions that may have used desiccated PSAN inflators as remedy parts, as well as the makes and models originally manufactured with them, is available with the downloadable version of this document (see -- note this information is subject to change/revision as the investigation proceeds). This investigation does not supersede EA15-001, which remains open.
EA21002
Technical service bulletins for the 2012 BMW 640I 329
Bulletins tell dealers how to fix known problems. A warranty extension means the manufacturer pays for that repair for longer.
- Right Engine Hood Hinge Return
- The basic conditions for initializing the power windows are not met.
- The electrical system of BMW vehicles has been subject to an ongoing development process over the last few...
- The Dynamic Stability Control (DSC) warning light comes on while driving
- After programming the head unit (HU-H2), activating the FSC (German word Freischaltcode) Enabling Codes...
- With the court's FINAL approval, BMW of North America, LLC (BMW NA) has entered into a nationwide...
- According to the customer, the airbag warning light was on, but it may not be illuminated when the vehicle...
- Component-Specific Limited Warranty Extension
- The air conditioning cycles from cold to warm air while driving or while at a stand still
- Vehicle cannot be opened or closed using comfort access, engine start is not possible, and the vehicle may...
What 2012 BMW 640I owners say
Most recent owner complaints, unedited.
Compare the 2012 BMW 640I
Other model years
Questions about the 2012 BMW 640I
Is the 2012 BMW 640I reliable?
Owners have filed 1 complaint about the 2012 BMW 640I, fewer than a typical 640I model year.
What is the most common problem with the 2012 BMW 640I?
Electrical system, with 1 complaint.
How many recalls does the 2012 BMW 640I have?
2 recalls, covering fuel system, gasoline and engine and engine cooling.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2012 BMW 640I?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history