1992 Chevrolet Beretta problems

Filed Apr 1, 2004 · Lights · 20,000 miles · NY

The lever used to engage the high and low beam broke three times without excessive force being applied. When the lever broke it disengaged the cruise control and the light remained on. *jb

Filed Aug 24, 2003 · Lights · 18,570 miles · WI · fire

While driving a column of smoke developed from the top of the steering column, directly in front of the driver. This occurred approximately one mile after noticing that the turn signal did not seem to operate properly during a turn. The smoke was also accompanied by the smell of an electrical fire. Immediately stopping the car and turning off the ignition stopped the smoke. The car was then driven approximately 5-10 miles to the dealer with no further smoke. The chevrolet dealer stated that the problem was caused by the turn signal switch shorting out. The switch was then replaced. The service advisor reported that there was no recall regarding this failure even though the turn signal failed in such as way that there could have been danger to occupants of the car. Obviously, the manufacturer did not use a fail-safe design when this car was built.

Filed Apr 30, 2001 · Brakes · CA

Brake system squeaks and jerks when starting to drive vehicle for the day. *ak front rotors were resurfaced and brakes were adjusted, but jerking and noise still continue.

Filed Mar 29, 2001 · Engine · WI

I have heard of problems with brettas and cavaliers with head gaskets and crack heads.

Filed Apr 7, 2000 · Brakes, Electrical · CA

Have seen numerous bulletins on same problems. Why won't gm fix these? No safety defect listed within summary.

Filed Mar 30, 2000 · Brakes · IN

Vehicle experiences extended stopping distances due to faulty ABS braking system, while consumer was backing out of driveway brakes gave out causing consumer to side swipe an electrical power box across the street. Nlm

Filed Feb 22, 2000 · Brakes · IN

While making a "complete" stop vehicle had a "clicking" noise, and the braking system malfunctioned, causing extended stopping distance which could result in a crash. Dealer could not determine the cause of the problem. Please provide further information.

Filed Nov 9, 1999 · Steering · NC

Steering column and turn signal became loose due to loose bolts within the steering column. Dealer indicated bolts needed to be replaced.

Filed Sep 15, 1999 · Engine · TX · fire · 2 injuries

Catalytic converter caught fire causing the console to be very hot and for the inside of the vehicle to become filled with smoke. Nlm

Filed Sep 14, 1999 · Brakes · AZ

Whenever ABS brakes are applied, the brake pedal would feel limp. The computer clicking light comes on. Would have greater stopping distance than usual. Had been to dealer once, but problem was not solved.