The braking on the car works when it wants. You apply the brakes and you have a full brake pedal then the next thing you know the pedal goes to the floor almost all the way, as if you were applying manual brakes. It doesn't matter how fast you go . I have been backing out of my garage and the brakes fail, and I can be going down the highway and they fail. I have had my car at the dealership numerous times for brake work and I get the same responce each time(we can't find anything wrong), now finally on the fifth time the put the car on some kind of computer and they told me that my ABS modulator was bad. I have been told by the dealership that this is a ongoing problem with berretta & corsica. Please contact me with any further information regarding my problem........... Thank you !!!!
1992 Chevrolet Beretta brakes complaints
Page 2 of 2: complaints 11 to 28 of 28, newest first, as owners wrote them.
Whenever ABS brakes are applied, they would fail to work. Took to dealer & had brake pads & rotors repaired or replaced. Problem with module & new brakes sytem reappeared. This has happened at least 7 times. At each time the ABS light keeps coming on. Dealer could not find problem with ABS light.
The ABS braking system malfunctioned, causing the pedal to go to the floor, and no braking ability under no certain conditions. Has been to dealer several times. Dealer cannot determine problem.
Recall work on the ABS system failed to work.
While switch is turned on, the anti-lock brakes won't work until the ABS light comes on.
Driving on a mountain on the way down went to hit brakes ,pedal went to floor without any warning, vehicle did not stop. Had to use hand brakes to gain control. Dealer bled the whole braking system, cannot find problem. This defect can result in an accident.
Excessive wear on front brake pads and rotors. Abs wheel sensor and harness failure.
Left rear brake locked up/right rear brake isn't functioning at all, putting all stopping power on front brakes, causing premature wear of brake pads and rotors.
Equipped w/ABS; intermittently, when slowing and applying brakes, they make a clicking noise due to wheel speed sensor failure. *ak dealer can not find problem.
When applying the ABS brakes, the vehicle's front brakes failed. Please describe.
Anti-lock brakes fail to stop vehicle on icy roads. (first vehicle on 601349)
Loss of brake caused consumer to have an accident. Tt
The car has total brake failed,ABS brakes did not work at 5 MPH. Tt consumer was leaving parking garage, he started engine pulled out of parking lot, and started up ramp about a 45% angle, consumer put his foot on the brake and the brake pedal went to the floor, consumer did this two more time but nothing happened, consumer crashed into a guard rail to avoid hitting a vehicle in front of him, and vehicle came to a stop, and also air bag did not deploy because there was no head on collision, after the accident engine was still running and consumer's foot was on the brake, a week prior consumer's wife complained that brakes seemed soft went to mechanic but said brakes were fine just a little wear on the brakes.
When brake applied, vehicle lunge forward, dealer said possible due to ABS system not catching. Tt
Brake pedal goes all the way to the floor, excessive effort to stop. Tt
Abs brakes; warning light comes on resulting in brakes locking up. Please describe details. Tt
Abs light did not come on, although ABS brake system failed, due to left front ABS speed sensor. Tt
Abs, brake failure, ABS light comes on/off, experienced pedal fading. Tt tt
VIN decoder
See the problems and recalls for an exact car
Buying a used 1992 Chevrolet Beretta?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history