Abs brake problems; on normal road conditions, during normal braking, sometimes the blazer would stop and sometimes it would roll another 10 or 15 before stopping. About 1 year later, the ABS computer was replaced. In 1995 the brake pads were replaced with 40,000 miles. One week later the ABS warning light came on. Adjustments was made by dealer and the light went off.
1991 Chevrolet Blazer brakes complaints
Page 4 of 5: complaints 71 to 100 of 129, newest first, as owners wrote them.
Abs brake failure.
Abs brakes are subject to intermittent failure, causing extended stopping distance. On other occasions, brakes make grinding sound while making a turn and applying the brakes. The brakes were repaired, but the truck is still having the same problem on the brakes.
Brakes: when hit brakes made a chattering noise. Had new brakes and rotors put on. When the highway is wet has problems braking. But in dry weather, the brakes work fine. Dealer can't duplicate the problem.
While driving at approx 25-30 MPH going uphill trying to brake while going around a ben, brakes locked up, car did 360 turn, hit tree, wet conditions, this defect happened more than one time. Heard pounding noise in unit,vibrates,goes away after vehicle takes warm up 5 minutes. This defect can cause an acciedent.
Abs: while driving 25 to 30 MPH, rainy weather, applied brakes, pedal went to floor, truck slid into rear of another truck, intermittent problem, available for inspection.
When applied brakes pedal sometimes goes to floor without warnig, increases stopping distance, nearly caused crash; mechanic replaced front brakes & rotors, problem still exists.
When brakes are engaged suddenly ,the ABS resists causing the vehicle to slide. The dealer has not been notified.
Brakes: attempted to put on brakes at red light, could not push down on pedal, then suddenly grabbed on dry pavement. This same problem occurred after previous repairs. *ak brakw
Ea94-038, driving about 20mph or less, the vehicle's ABS system failed, causing the brake pedal to become very hard and the vehicle wouldn't stop, causing an accident. No prior warning.
Engine idled out of control, resulting in an accident.
While driving applied the brakes suddenly and vehicle was slowing down. But once vehicle was in the grass where it ended up, the brakes shut down and vehicle never stopped, causing vehicle to hit another vehicle.
The emergency brake cable lever broke on three different times.
Master cylinder failed due to particle contamination of brake fluid.
Abs brake system failed, causing tires to skid.
Owner has ABS brakes he states that his brakes do not operate properly and that pedal goes to the floor when brakes are used
Abs brakes locked up and brake pedal went to the floor; dealer also replaced master cylinder and rear wheel cylinder.
Owner has ABS brakes, he states that he has no brakes at all, he notes that he took his vehicle to garage for repairs and they reset the computer but owner is still having problems.
Ea94-038, ABS brake failure, when brakes were applied, pedal went all the way to the floor/extended stopping distance, resulting in an accident.
When applying the brakes on wet pavement the brake pedal will travel to the floor, causing extended stopping distance. Please send repair information.
Abs brakes locked up twice, once resulting in loss of control/collision.
While driving another vehicle in front slammed on brakes, blazer's driver also slammed on brakes (ABS) which failed to catch, vehicle slid & rearended other vehicle. Street dry. Dealer looked at brakes prior to accident, driver was informed nothing was wrong, has police report.
Ea94-038, applied brakes, pedal went to the floor and there were no brakes, causing the driver to break her arm , the master cylinder and brake shoes were replaced. Please describe .
In dry weather consumer applied the ABS brakes and vehicle didn't stop, consumer rearended car in front . Please describe .
When driving on wet and dry pavement the brake pedal went to the floor and the vehicle continued to move, causing the consumer to have a near accident ea94-038. *ak consumer states he did have an accident because of the faulty brakes. All seat belts were replaced due to would not latch, retract, or were hard to latch, there was a recall regarding the rear seatbelt repairs.
Failure on the ABS brakes, when driving at slow speed the brake pedal went to the floor, causing the consumer to have an accident.
Driving on interstate took an exit ramp at approximately 20mph. Light turned red so needed to stop, when applied the brakes ,pedal went completely to the floor and there were no brakes . The brakes failed and vehicle went into the back of a truck.
The ABS system went out and the ABS system does not work and will not stop the truck. The intrument panel went out without warning.
The ABS system malfunctions. The pedal goes to the floor and the vehicle will not stop.please describe.
Driver experienced total loss of braking, vehicle is equipped with ABS brakes.
VIN decoder
See the problems and recalls for an exact car
Buying a used 1991 Chevrolet Blazer?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history