My car has been broken for over a year now. It has been to the dealership for the main engine wiring harness part number 19115750 which is unique to the 2005 and 2006 corvette. The failure causes several different problem. It keeps the TCM from which is the traction control module which adjust speed and traction to the wheels which is design to help drivers keep their cars under control. Without this system the car will loose traction and can cause it to go off the road. The second issue with the harness is it can put the car limp mode which restricts the speed to under 40mph which if you are driving and trying to excel into traffic this system will come in without notice and put you into a situation where if you are trying to merge or just go when the light changes it will only go like 5 mph causes the cars behind you to run into the rear of your vehicle and when if fail and you are pulling into traffic it causes your car to be in a direct line of impact with oncoming vehicle. The engine harness also provides power to the transmission via the ECM which keeps it from providing enough power to run the transmission control computer. This will make your car not go into gear or make it go completely out so without a transmission your car won’t move at all. This happens without notice. Now GM doesn’t make a replacement harness anymore making your vehicle unusable. GM also wants between 7k and 10k to make a harness for the vehicle. This doesn’t include installation. This makes the owners like myself have to seek other means to repair the vehicle. Like having a custom harness made for vehicle. Since GM only made this harness for 2 years it has been impossible for me to get my vehicle repaired at any cost. Making owner to make decisions that are unfair to owners. Like sell the car for scrap Paid the expensive repair which is like half the value of the car. Trade the car and lose thousands of dollars if you can find a dealership willing to take it
2005 Chevrolet Corvette engine problems
29 complaints (5% of all complaints for this car). Typical mileage when it fails: 29,137.
- owner complaints
- 29
- of this car's complaints
- 5%
- typical mileage
- 29,137
- crashes
- 0
- recalls
- 0
Which part fails
- Engine: gasoline: belts and associated pulleys6
- Engine2
- Engine: gasoline1
- Cooling system: hoses/lines/piping/fittings1
- Cooling system1
At what mileage
Complaints by mileage at the time of the problem.
Chevrolet Corvette engine problems in other years
Specific symptoms reported on the 2005 Chevrolet Corvette engine
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Won't start 13Engine failure 12Loss of power 9Check engine light 8Stalling 8Overheating 5
Related recalls
No recalls on record for this model year.
What 2005 Chevrolet Corvette owners say
Most recent owner complaints, unedited.
I left my driveway and got two miles up the road and with no warning lights or anything dashboard went dark and suddenly car put itself into assesory mode and car just stopped while driving. I was probably going 15 mph and luckily no one was behind me. The dash said to "shift into park" so I did then I started by pushing start button and it started right up with no problem. I can't get anyone to service vehicle because they said it is not reading any code from check engine light ect. So all I can do is hope it doesn't do this again. Scary.
Tl* the contact owns a 2005 chevrolet corvette. While driving at any speed and depressing the accelerator pedal, the vehicle failed to accelerate over 5 MPH. In addition, the check engine warning indicator illuminated and the messages "loss of power" and "traction control system" were displayed. The vehicle was taken to an independent mechanic where it was determined that the throttle body needed to be replaced. The vehicle was not diagnosed or repaired. A dealer was not contacted. The manufacturer was notified. The failure mileage was 6,000.
Tl* the contact owns a 2005 chevrolet corvette. The contact stated that after parking the vehicle, the steering wheel seized and could not be turned in either direction and the engine could not be immediately restarted. After the vehicle was finally restarted, the message 'steering locked' had displayed. The vehicle was towed the local dealer grabiak chevrolet (8282 rt. 22 new alexandria, pa.) the cause of the failure was not yet determined. The manufacturer was not notified of the failure. The VIN was not available. The failure mileage was 52,000.
While driving 70+MPH on an interstate, "reduced power mode" and "service active handling" warnings illuminated on the dic aong with the check engine light. The vehicle then completely shut off making it extremely dangerous to get safely out of the paths of other vehicles. This has happened to the vehicle about 8 times now in varying circumstances, mostly while in motion. Error codes taken from handheld programmer include: p1516, p2101, p2135
Took the car in for a chatter noise at idle and when stationary. I'm told that the torque tube needs to be replaced, the car only has 27,000 miles and it seems that this is a very dangerous thing to have happen if it fails why you are driving it and it causes major damage to the rest of the drive train. It is a major part of the drive train and an obvious defect with the corvettes as noted in the forums. A recall is in order and chevorlet needs to step up to the plate and repair these to make this car safer before some one is seriously injured. The repair is very expensive at around 3,000. A repair that should never need to be done on a low mileage car.
Tl* the contact owns a 2005 chevrolet corvette. While driving various speeds, the vehicle stalled without warning. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was 100,000.
This incident happened 4 or more times. However, this last time, I was traveling at 75 miles per hour on the i95. The traction control system light came on and then the car engine died on me as has happened on a number of other occasions. I was in the left lane on the highway. Lucky for me there were no vehicles behind or to the right of me so I was able to coast to a dead stop on the safe side of the road shoulder (right). The car normally would start again after this system failure. This time it did not and I had to have it towed to the nearest garage which was a ford dealership. This could have been very serious had it not been for light traffic. I have had the vehicle service a number of times at gm dealerships for the engine light being on. The issue is still unresolved. I no longer have confidence in the vehicle as to its drivability and safety.
Accelerated quickly to 35 MPH and when I reached the end of the block I attempted to slow and make a right hand turn. At that time I got a warning to check the charging system and noticed I had no power steering. Managed to muscle the wheel to complete the turn (had it been my wife there is no way she would have been able to turn the wheel) and continue slowly down the street to my driveway where I again muscled the car into the driveway. Discovered that the motor was running but the serpentine belt was not moving. Thus no alternator, power steering etc. I had my independent mechanic check it out, discovered that the bolt that holds the harmonic balancer pulley on the crank shaft stripped and the crank shaft was turning and not moving the pulley. He called the dealership to inquire about the parts and they said they have plenty in stock. He thought this was surprising and that it was not a special order part. The service manager told him that they have had a number of similar incidents. Both my mechanic and I think this should qualify for some type of recall if it is happening with frequency. Obviously some kind of design flaw and/or material flaw, plus they didn't key the pulley so if the bolt strips you would not loose the power steering, etc. If this had happened at high speed or during the action of turning I believe a serious accident and/or injury could have occurred. Cost of the parts and repair were $2300.00.
My 2005 c6 was stuck in park, faulty solenoid it will not engage dog ear to allow you shift out of park, leaves you stranded, dealer wants $800 to replace entire shifter since the solenoid is riveted to. There are many c6 owners dealing with same issue. [xxx] information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6).
Questions about the 2005 Chevrolet Corvette engine
Does the 2005 Chevrolet Corvette have engine problems?
Owners have filed 29 complaints about the engine of the 2005 Chevrolet Corvette, 5% of all its complaints.
At what mileage do 2005 Chevrolet Corvette engine problems start?
The typical (median) mileage in owner complaints is 29,137 miles.
Was there a recall on the 2005 Chevrolet Corvette engine?
There is no recall for this problem on this model year.
What year does the Chevrolet Corvette have bad engine?
The Chevrolet Corvette model years with the most engine complaints are 2005 (29 complaints), 2006 (28 complaints) and 2007 (28 complaints).
Other 2005 Chevrolet Corvette problems
Driver assistance 104Electrical 101Lights 87Steering 76Transmission 70Brakes 62Body 53Airbags 44Fuel system 24Acceleration 11Suspension 7Visibility 7Locks 3Seats 3Tires 2Wheels 2Seat belts 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2005 Chevrolet Corvette?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history