Driving at 1-35 MPH engine and electrical will shut off, all lights and engine shuts off. Put car in park, engine starts right away. In 2014 gm recall of 2005 cobalt and pontiac for same problem, it was said that six people died. I have the same problem. This almost happened to me. I am afraid to drive the car. Called gm and talked to a specialist named scott at 1‑866‑790‑5600 ext. 31087 . I was asked to take the car back to the dealership, so they will look at it for the 3rd time. This has been going on since may 08, 2013 -- almost 1 year. Please help me before something happens to me or my family. The car is at jack schmitt chevrolet, 127 regency park drive; o'fallon il 62269 (618) 628-2500 www.jackschmitt.com.
2005 Chevrolet Corvette engine complaints
Page 2 of 2: complaints 11 to 29 of 29, newest first, as owners wrote them.
On four separate occasions over the last two weeks the vehicle has failed to start after being turned off for a brief period of time (while refueling the vehicle, etc.). On 2 of those 4 occasions the vehicle has required towing to a dealership's repair facility. On the first occasion, the vehicle would turn over but failed to start. It then mysteriously started again after sitting at the gas pumps of the gas station for approximately 45 minutes while waiting for a tow truck. On the second occasion, the vehicle failed to start but was able to be restarted after pulling and reinserting the fuel pump relay located in the under hood ubec. On the third occasion, pulling and reinserting the fuel pump relay had no affect, the vehicle would not start and the vehicle required towing to the dealership. The dealership noted loose connections on the ubec and also replaced the fuel pump relay. One day later, the vehicle again failed to start and required towing to the dealership, where the vehicle is currently. Upon writing-up the service ticket, the dealer stated that the circuits within the ubec on this vintage corvette have been problematic and that the ubec would most likely require replacement. On visual inspection, the ubec appears to be located very close to the exhaust manifold on the vehicle which would make it very susceptible to intermittent failures of various ubec components caused by heat (headlights, fuel pump, etc.). Gm should issue a voluntary recall to include a heat shield or some improvement in component design of the ubec on this vehicle.
Tl* the contact owns a 2005 chevrolet corvette. The contact stated that the vehicle stalled without warning. The vehicle was restarted, but after driving two miles the service traction system and reduce power warning messages illuminated. The vehicle lost all power and stalled. The contact stated that the vehicle would restart after ten minutes. The failure recurred several times. The vehicle was not inspected. The VIN was not available. The failure mileage and current mileage was 10,500.
Upon taking my car in for an oil change it was discovered by the technician that the bolt holding the harmonic balancer in place had backed itself out. This allowed the harmonic balancer to do excessive damage to several engine components including the oil pan. According to technician fire could have ensued or car could've suffered a severe loss of traction from the substantial oil leak. General motors has issued a "technical service bulletin" outlining repair procedures to be performed at a local dealership at no cost to customers with cars in a specific VIN series. After looking up the tsb my car is not in said VIN series even though problem is exactly as described in tsb.
Squeaking noise from engine accessory drive belts, clunking/ knocking noise at lower front of engine. The crank shift blancer split apart moving back to the engine. Damage to the timing chain cover and oil pan causing oil to leak.
While turning in a corner on the highway, I lost power steering and I had smoke and debris flying out of the back of the car. Luckily there was nobody near me, and I managed to steer off the road safely. Looked in the engine and the accessory belt was shredded, which also destroyed the heat shield material on the inside of the hood. Got a friend to pick me up and we installed a new belt. Drove 0.5 miles and the belt flew completely off this time. Power steering completely died, and I could barely turn the wheel while being tailgated by cars. Cooling system failed, coolant flying all over the engine bay, under the car, and on the highway. I'm glad I wasn't killed. Checked all the pulleys and found that the crankshaft pulley bolt had backed out, which I later found out caused wobble on the belt and LED the engine/car to fail. Got a tow to the nearest gm dealer. There are many complaints about this on internet corvette forums, and gm is aware of the issue (tsb #05-06-01-001a). It seems like crashing and causing accidents would warrant a recall.
2005 corvette, 45,224 miles. Squeaking noise from engine accessory drive belts, clunking/ knocking noise at lower front of engine. Found crankshaft balancer retaining bolt backed out, crankshaft balancer moving forward. Had this bolt come out further, it would have damaged the steering rack, accessory belts coming off, loss of power steering, electrical, braking. This issue is known by gm/chevrolet, tsb 05-06-01-001d. Vehicle was flat bed towed to dealer, they denied that there was a problem with the bolt, it just needed new belts. After threatening the dealer & gm with a lawsuit if the pulley came off and resulted in property damage or bodily injury, they would replace the pulley with the upgraded one & a new bolt per the tsb, but at customer expense. Repairs completed 2/10/2010. This vehicle was within the VIN number range for the tsb, but the dealer was more concerned where the paper copy of gm tsb 05-06-01-001d came from- this is public information. Please- make this issue a formal recall before someone gets hurt. The federal safety agency database shows at least 6 similar incidents, many others have not been reported to the federal safety agency.
Tl* the contact owns a 2005 chevrolet corvette. The main pulley under the vehicle was unstable. The vehicle was taken to the dealer for inspection. The technician stated that because there were no associated recalls, he was responsible for the cost of the repair. The failure mileage was 37,000.
Purchase a 2005 corvette in 2008. Shortly after AC didn't work after working fine just moments. Drove car for a half a mile or so and heard a clunking sound. Pulled over and raised hood but didn't notice anything. Ac still not working but car is not a daily driver and winter was approaching so not too concern. 2009 this year decided to get AC checked for the summer.....the AC clutch was missing. Hindsite the clunking sound I heard a year ago was the AC clutch falling off! Unacceptable for any car.
After about 2.5 years the convertible top mechanism started getting noisy and then refused to close all the way. The dealer repaired it under warranty with a new electric motor and a pump repair kit. About a year later the exact same thing happened but the dealer refused to repair it under the original warranty saying that it was a different problem. This time he replaced all the hydraulic hoses on the left side and charged me about $900.00. I feel that the problem wasn't properly repaired the first time.
Potential loss of coolant, engine overheat, loss of visibility- inspecting under the hood during oil change, I found the coolant air bleed hose rubbing through on the bottom corner of the mass air flow sensor. I twisted hose away and placed a plastic conduit over the hose in this area. This is the small hose (8mm id)left of the throttle body leading forward to the coolant lines leading to the surge tank. Hose will be replaced soon.
My brother suggested I report that the engine in my car's front pulley comes loose and falls off causing loss of electrical production, A/C, and worst of all power steering--its a corvette-dont know if it happens a lot to others also but maybe you want to look into it-seems to be a dangerous situation.
Dt: the contact owns a 2005 chevy corvette. On november 27 2004 the vehicle would not let them get into the car and the alarm would not go off. Also, the computer in the car would tell them that there was no tire pressure and the tires were on the vehicle and the computer stated there was no psi. They had to climb into the hatch to open the door because the door would not open with the key. On april 5, 2005 the dealership replaced the battery and it did correct the problem until april 12,2005 at that time the vehicle was towed back to the dealership and they stated basically it was the battery and the electrical system same type of problem again this time. April 16, 2005 the vehicle had to be jumped started. On april 20, 2005 the vehicle was towed to the dealership because they could not get into the vehicle, the battery voltage was showing zero, and the psi on three tires were showing that they did not have tires on the vehicle. On may 23, 2005 with only 2700 miles on the vehicle while driving down the highway the serpentine belt broke, it over heated, the engine had blew and the vehicle had to be towed. Around july 3rd or 4th with less than 3000 miles, the vehicle would not shift correctly and it would automatically stop because it would come out of cruise control, the computer would give them strange error messages. When they arrived to the dealership that is when the hatch on the back had came open by it self and it had happened twice before this but they thought they had maybe accidentally opened it. On july 12, 2005 the vehicle was picked up from the dealership the passenger driver side window molding was messed up. The contact told them to keep the vehicle until it was fixed. They have noticed numerous complaints on the federal safety agency website with the same type of problems. Also, on the vehicle they have been unable to put a full fuel tank of gasoline in the vehicle since date of purchase. Service invoices are available if needed.
On june 22, 2005 while driving at highway speed my '05 covette lost its serpentine belt causing the car to lose pwer steering, engine oil and coolent. With the loss or steering the car became hard to steer and manuver. This problem has been know by chevrolet that a specific bolt was not placed correctly during manufacturing and causes the loss of the serpentine belt. This was a scary event to lose steering at 60mph with a passenger during the ending of rush hour traffic on hwy114 at 6pm. The repair is taking place now involving a new diamond washer and proper torquing of the bolt. Possible engine damage may have occured and the reliability of the vehicle is now in question. In some occurances the problem has happened again. I don't want it to be me and have an accident.
Driving new 2005 corvette (1486 total miles on car) in shopping district at 35mph. Heard "slapping" sound from under the hood. Pulled over and found that one of the underhood engine belts was shredding. Was aware of a manufacturers technical service bulletin (05-06-01-001a - feb 8, 2005), therefore thought immediately that the problem this tsb addresses was the problem. The occurrance was uneventfull, as I was driving very slowly, however if it had been at highway speeds this could have resulted in loss of control and broken fluid lines under the hood. Engine was disabled. Car was flat-bedded to local chevrolet dealer where it will be repaired.
Seven to eight thousand chevrolet corvettes built in late 2004 are in a batch being watched by gm because there have been dozens of instances of the crank shaft pulley belt backing out and allowing the pulley to loosen or fall off. When that happens the car looses power steering and the rest of the functions run off the belts. The belt and pulley can also cause other damage under the hood. Production nuber corvettes from over three thousand to over eleven thousand are in the group identified as problematic. Chevrolet has realease a technical service bulletin, tsb number (05-06-01-001a), but says it can not help buyers until after a failure. I own a corvette in that group, and I fear that I can't trust the car to perform safely. I belong to several corvette related internet forums, and I get reports of new failures every day. There are dozens of failures reported by members of just one forum. The failures have been occurring since november, 2004. Gm is obviously not going to fix this safety problem without the federal safety agency inquiry, and I'd like the federal safety agency to ask gm to get serious about protecting the lives of their purchasers. Spontaneous loss of steer assist and fluid loss is a safety issue - in my opinion. Will the federal safety agency look into this situation before someone dies, please?
Complaint received via e-mail. While driving home ,the crank bolt which holds the engine pulley, came untreated from the crankshaft. This disintegrated all three belts, and I lost the power steering. At 65 MPH, this is rather an un-nerving experience! Had this happened to a small woman, she might have lost control of the vehicle in the rush hour traffic. There have been at least 10 instances of the crank bolt coming out from the engine.
Complaint received via e-mail. My 3 day old corvette shredded its serpentine belt, overheated, and lost its steering. Car had 300 miles on it. From what I have been reading on 'corvette forum this was not an isolated incident but has been occurring in too many new corvettes. This problem could affect the operation of the vehicle as it not only affected the cooling system but more importantly the steering and braking. To make matters worse the repair of this problem was failing on many cars, and they were experiencing it for the second and third time. *ak.
(1) purchased car 10/23/2004. (2) on 10/24/2004, less than 24 hours after purchasing the car, the crank pulley "came loose" and the car threw its serpentine belt (learned after the incident) while driving on a crowded interstate. The first indication of a problem was when the driver information console (dic) displayed a malfunction with the vehicles charging system that needed service. Voltage displayed on dic dropped quickly in .1 volt increments until roughly 11 volts were displayed. Then, the car became increasingly unresponsive to driver input for steering and throttle. Brakes felt "mushy" but continued to respond to driver input. Although the dash displayed a frightening number of error messages and alarms, the occupants had no idea what was the matter with the vehicle. Trying to cross 5 lanes of packed freeway traffic to get to a safe break down area, in a car that appears to have lost its mind and is spraying antifreeze all over the highway, could have easily resulted in injury or death. We were very fortunate that we did not cause an accident. 3) vehicle was "repaired" at ourisman chevrolet in marlow heights, md. Crank pulley, bolt(s), serpentine belt, and underhood insulation (damaged by flying belt) were replaced. A friction washer was added behind the crank pulley on the advice of gm tech support. *car broke down again with the same problem on 13 november. Car is now at radley chevrolet in fredericksburg, va. Gm has ordered the motor replaced and the dealer is awaiting parts. This is not an isolated failure, there are other ls2 engines breaking down because of this crank pulley problem.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2005 Chevrolet Corvette?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history