The vehicle was stopped, the brake was applied to put the truck in reverse and the brake pedal went to the floor. The passenger side front brake line ruptured due to rust. All the brake lines were rusty and need to be replaced. I am very lucky that the vehicle was not on the highway when this happened. I pointed this problem out to the chevy dealer when the vehicle was relatively new and still under warranty (2 or 3 years old) and was told this is normal and should not be a concern. The brake lines were showing rust after a year or so.
2003 Chevrolet Silverado brakes complaints
Page 3 of 10: complaints 41 to 70 of 257, newest first, as owners wrote them.
While backing out of drive I lost braking action. The line servicing the rear brakes rusted/corroded allowing the brake fluid to escape and resulted in no brakes.
Tl* the contact owns a 2003 chevrolet silverado. The contact stated that while driving approximately 35 MPH, the brakes failed without warning. The contact mentioned that when the brake pedal was depressed it sank into the floorboard. The vehicle was not taken to the dealer for a diagnostic testing. The manufacturer was not notified of the failure. The approximate failure mileage was 63,000.
Vehicle was parked in driveway and when I engaged the brake pedal to put car in reverse there was no resistance. Pedal went to floor and the truck did not slow down when brake pedal pressure was repeatedly applied.
Driving to work this morning. I approached a stop sign, put my foot on the brake, the pedal hit the floor, the dash warnings came on, and the truck wouldn't stop and went right into the intersection. Fortunately there were no oncoming vehicles. There was no warning until total failure happened. I checked the fluid, it was low, but in the acceptable range. Then I looked underneath. The left rear undercarriage was covered and dripping with brake fluid, upon further inspection I found that the breaklines are corroded through. Scheduled with a mechanic later this pm for a complete inspection of the system.
Backing out of driveway, brake pedal went to floor with no resistance or slowing the vehicle. No warning lights until brakes failed. 3 brake lines replaced due to being rusted out @~$1700. 11 months later second failure exiting a highway at 65 MPH, again no warnings until brakes failed, ~$350 repair for additional brake line repairs. 10 months later, sudden traffic slow down at highway speeds, no warnings until after brake failure. ~$180 repair for yet another section of brake lines and very close accident. In all 3 cases this was complete brake failure with brake pedal going all the way to the floor with no resistance or ability to slow let alone stop the vehicle.
Performing routine maintenance on truck. Noticed steel brake lines are excessively rusted, given the care this truck has received. While now 11 years old, the rest of the truck is not showing any signs of corrosion or rust. But the brake lines alone are rusted to the point of near failure with substantial scaling, and will need to be replaced very soon to prevent an accident. Clearly this is a manufacturing defect/inferior materials, and it will be extremely costly for me, as dealers are quoting $1000 plus parts to replace all the steel brake lines. I am grateful to have noticed before an actual loss of brakes and an accident. I am original owner of this vehicle and purchased it new in 2003.
Brake failure without warning. Brake lines rusted thru, loss of brake fluid, pumping will not help, and no warning until pedal reaches the floor. Service center says all brake lines need to be replaced.
Going 49mph, then turned on left turn, slowed to about 20mph and started to turn left, when brake peddle went completely to the floor. Had vehicle towed to townsend bros . Chevrolet. Miles in 64,143.0 estimate charges only $48.93 verified loss of brake pressure due to rotted brake lines. Rec.replacing all brake lines from end to end. Cost to replace,$789.94..... Estimate total to be, ,$1,442.99 with extras I did want. Only willing to pay for fuel filter replacement for $60.00...
My 2003 chevrolet silverado has now had 3 brake line failures resulting in no ability to use the brakes. The last failure occurred on may 10, 2014 while driving in a suburban area. Luckily, it was late in the evening with no traffic and I was able to use my emergency brake to avoid an accident. I have previously filed a complaint (10567344) after my last failure in december 2013. Updated 11/24/2014
One of the hydraulic brake lines in front of the ABS module burst due to corrosion causing loss of all brake fluid. This was sudden with no warning, no lights to warn of brake fluid loss. .ea11001.
Brake lines fuel lines and trans lines all rusted out the truck is rust free body and frame the lines are faulty as this is a problem with these trucks.
Brake line rusted through. Avoided accident by driving on shoulder of the road. Vehicle towed. Repairs made $1,800+.
I had one front brake line fail found at time of repairs the other was starting to leak had to replace both lines.
Brake lines are completely rusted out and leaking. One was replaced last year. Frame has been rusty since truck was new. Vehicle has only 63000 miles. Most of them have been highway.
Tl* the contact owns a 2003 chevrolet silverado. The contact stated that while braking for an exit, the brake pedal abnormally traveled to the floorboard as the brakes failed to respond. The contact mentioned that the emergency brake was engaged and the vehicle was able to come to a stop. The vehicle was towed to a dealer where it was diagnosed that the failure was contributed to the brake lines, which were found to be corroded, and caused brake fluid to leak. The manufacturer was notified of the failure. The vehicle was not repaired. The approximate failure and current mileage was 84,000.
I have a 2003 chevy silverado and the brake system start going out last week. Took it to my gmc dealer , where I purchase the vehicle from. They stated that the brake line are completely rusted and the issue is so extensive that they cannot do work to it. I need to find an independent auto repair shop. I purchase a premium warranty from the dealership and they are the only one that has been performing maintenance on the truck for the last 1 1/2 years.
We were driving on us19 in new port richey, fl, when traffic slow down for a red light and I lost all brakes had to veer off the road almost got into a head on accident, the only way to stop was by using the emergency brakes, could not change the gears, everything just froze. We just moved from connecticut a year ago. Now the instrument gauge cluster panel is not working, RPM, speedometer is not reading at all, it just states on 0, this is the second time it happened in about 2 months.
I got off interstate hit my brakes to stop at light when I hit my brakes it made a noise and went to the floor I almost hit another car in the rear had to run a stop light because it wouldn't stop some one could have been hurt bad this has happened to me twice. I was told my brake line was rusted which I had it replaced about 2 months ago and my ABS lights come on and it dings.
On my way to work I was turning into gas station and my brakes failed I got stopped without hitting anything .brake line broke on front left side had towed to auto repair shop. They replaced brake line and was told all other lines coroded and need replaced too expensive ibrought truck home
The brake lines on this truck are so rusted so are the fuel lines I'm surprised even stops or that the fuel lines haven't burst yet I have ABS light on and service brake system because everything is so rusted and now have a short somewhere so anytime you hit a bump warning light flashes and it starts dinging and warning lights flashes service brake system... There is no reason for this to be rusted like it does this vehicle is washed at least once a week it is in immaculate shape.
On the listed date, I was driving my vehicle as described above. I attempted to apply the brakes in a curve when the pedal went straight to the floor and I ran my vehicle off the roadway causing minor damage to the vehicle. My greatest concern however, is the post accident research I conducted on the brake system of my vehicle. My research indicates that there have been thousands of owners who reported to gm that the same model of truck as mine had brake systems that prematurely reached failure. Specifically, they rusted prematurely causing my brake system to completely leave my vehicle in a dangerous operational position. Upon investigation of the lines, each of the 5 lines in the system was experiencing the same rust issues and needed to all be replaced. I feel it should be the responsibility of gm to replace my brake system via recall.
While backing my truck out of my home driveway, I stepped on the brake and it went immediately to the floor. The brake warning light on the dash illuminated, a warning chime sounded, and the message center flashed an alert to "service brakes soon". I had almost no response at from the brakes; fortunately the street was level so I was able to quickly coast to a stop. I immediately pulled the truck back into the driveway and parked it. When I got out to investigate, I immediately noticed a small pool approximately a foot in diameter of brake fluid on the driveway surface just behind the driver's side front tire, along with a trail that lead back to the street. Brake fluid was dripping from the lines at the frame where it makes the bend upward at the front edge of the cab. Closer inspection with a flashlight revealed that all the brake lines are excessively rusted and one or more of them appears to have burst where the lines go over the frame rail into the engine compartment. All lines will have to be replaced before this vehicle is safe to drive again. This vehicle was purchased used (60k miles) in florida in 2006, moved to washington state (seattle area) in 2008, and then moved again to northern virginia in late 2009. It has had minimal exposure to road salt, ice or snow conditions in the time that I have owned it.
While driving down rte. 188 in seymour, ct (steep decline) a deer crossed in front on me causing me to apply the brakes very firmly. As the truck slowed, the pedal pressure suddenly disappeared and the pedal went all the way to the floor. No lights or warnings illuminated in the instrument cluster. As I approached the stop sign in front of me, I was unable to bring the vehicle to a stop. Fortunately (as this is incredibly rare) there was no traffic in either direction, and I was able to continue through the intersection without event. It was only due to extremely good luck that there was no accident. The vehicle was undriveable from that point.
I was stopped on boat ramp and started to back up when brake pedal went all the way to the floor.we were very lucky to not launch boat and truck into river at the same time. We then had the truck towed to our local garage and the brake line was repaired. The mechanic told me that the brake line was rusted.this has happened twice now.the second time I was stopping at a red light and the pedal went straight to the floor . Chevy says you don't lose complete braking but I would like to see the ceo have it happen to him. This problem will make me sell this truck .I will not be driving this vehicle again ..I hope the nhtsb will make chevy either address this problem or fix it before someone either gets seriously hurt or killed.
2 problems. Anti-lock brakes pulsate intermittently. Engine 6.0l exhaust manifold bolts are broken. Causing emissions codes to set and exhaust gases into cab. I have found that this a common problem for 1999 to 2007 v8 engines. Gm said there is no recall or warranty for this problem.
Brake line rupture due to rust. I was backing up in my driveway to hook up a small trailer when I felt and heard a small pop and the break pedal went right to the floor. Service brake system appeared on dash panel.
Had stopped to put my granddaughter on the school bus. After the bus left went to put truck in gear pressed brake pedal and it went to the floor. Parked it till I got home and looked main rear line rusted through.
Front passanger side brake line rusted out and failed while in a tim hortons drive thru, thankfully not moving when brake pedle suddenly went to the floor. The driver side line was replaced 1.5 years ago due to rusting out.
While hard on the brakes to avoid a vehicle, my rear brake line burst, and I lost all brakes. Luckily I was able to use the emergency brake to come to a stop. Now I have a $400.00 bill to replace rusted brake lines, that should have never rusted in the first place.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2003 Chevrolet Silverado?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history