Brake lines rusted thru. I have had several 80s 90s and 2000 2001. 2002 chevys with rusted brake lines which could have been a fatal accident.
2000 Chevrolet Suburban 1500 brakes problems
47 complaints (70% of all complaints for this car). Typical mileage when it fails: 133,652. 4 crashes reported.
- owner complaints
- 47
- of this car's complaints
- 70%
- typical mileage
- 133,652
- crashes
- 4
- recalls
- 0
Which part fails
- Antilock/traction control/electronic limited slip: control unit/module3
- Antilock/traction control/electronic limited slip2
- Foundation components: hoses, lines/piping, and fittings1
- Driveline: hydraulic: hoses, lines/piping, and fittings1
At what mileage
Complaints by mileage at the time of the problem.
Chevrolet Suburban 1500 brakes problems in other years
Specific symptoms reported on the 2000 Chevrolet Suburban 1500 brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
No recalls on record for this model year.
What 2000 Chevrolet Suburban 1500 owners say
Most recent owner complaints, unedited.
Was driving around 45mh and was coming to stop sign but when I went to use brake the pedal went to the floor. I kept pumping which seemed to help just enough to turn into the drive way of a mall that happened to be closed. I am so thankful that it was late at night or I would have smashed into someone. Shop said main brake line rusted through, a common problem that chevy could care less about. Very sad chevy........
Tl* the contact owns a 2000 chevrolet suburban 1500. The contact stated that the emergency brake failed to operate without warning. The vehicle was taken to the dealer where the emergency brake was adjusted and the wiring was replaced; however, the failure recurred. In addition, after the repair and the brakes and emergency brake were applied, the vehicle rolled backwards. The manufacturer was not notified of the failure. The failure mileage was not available.
Passenger rear brake line ruptured with complete brake failure. Passenger front brake line ruptured while repairing the rear lines during the bleeding process. Gm's statement that their vehicles still have braking to 2 wheels during a line failure is incorrect. When the line ruptures there are no brakes at all. Thankfully the incident happened as I was leaving my driveway and not on highway the day before. I was able to downshift and use the emergency brake to stop the vehicle before any collisions .I've owned over a dozen cars in my life. I have never seen such extensive corrosion on brakes lines. It's unfathomable that gm would use inferior and non-corrosion resistant metal in one of the most important systems in any car. There will be multiple accidents due to this if there haven't been 100's already.
Rusted brake lines to rear driver wheel leaks fluid resulting in vehicle not able to stop. Collision nearly occurred as result of loss of braking.
Tl* the contact owns a 2000 chevrolet suburban 1500. While driving approximately 55 MPH, the contact depressed the brake pedal and the pedal extended to the floorboard without warning. The contact swerved in order to avoid crashing into another vehicle. The contact continued to depress the brake pedal and it returned to normal. The contact was able to drive the vehicle without incident. The vehicle was taken to the dealer where it was diagnosed that the master cylinder was faulty and needed to be replaced. The vehicle was repaired; however, the failure recurred while the contact was driving approximately 55 MPH. The contact crashed into another vehicle. A police report was filed. The contact sustained injuries that required medical attention. The vehicle was taken back to the dealer where it was diagnosed that the master cylinder was faulty and needed to be replaced. The vehicle was repaired; however, the failure recurred. The vehicle was taken to the dealer where it was diagnosed that the anti lock wheel speed sensor was faulty and needed to be replaced. The vehicle was repaired. The manufacturer was not made aware of the failure. The approximate failure mileage was 84,000.
I was driving my 2000 suburban at 60 MPH on the highway on september 29,2015 when I needed to brake for traffic. The brake started to stop but then went all the way to the floor. I had no brakes and had to go into the ditch in order to prevent a serious collision. There was a main brake line failure. I have contacted chevrolet about the failure but they have yet taken any responsibility for the poor design. This issue is very well documented all over the internet for rust failure on brakelines on this vehicle and yet chevrolet has yet to notify anyone of the possibility of complete brake failure and more importantly, done anything to correct the problem. This needs to be addressed before anyone is killed. I was driving with my 18 month old granddaughter at the time. If I had not acted quickly, the outcome could have been devastating.
Emergency brake went out around 30,000 est first time. I replaced the shoes not sure what year/ but now the left side no shoe left. The clips do not hold the shoes in place and end up wearing out the shoe and diskhat. Note: this is a very poor design. For years I never used the ebrake now I have converted the suburban over to a manual transmission and need the ebrake.
I applied the brakes and the pedal traveled all the way to the floor...I pumped them and was able to stop to avoid collision...I inspected the truck and saw brake fluid coming from under the vehicle above the fuel tank...I've seen numerous reports about this issue....the cheapest estimate was 600.00 dollars to fix...I will attempt to repair myself if it's not to difficult.
Total braking system failure (including emergency brake) on my 2000 chevy suburban. The day before the incident occurred, I noticed the brake pedal going lower than usual when pressing on it. I checked the fluid reservoir and notice that it was almost empty. I then added fluid to the full line on reservoir and that seemed to solve the problem. Next morning on my way to work, the brakes failed as I was approaching a busy intersection. The pedal went all the way to the floor as I was approaching the intersection at about 20 MPH. I pressed hard on the emergency brake on a last failed attempt to stop the vehicle. I shifted to lower gears, reverse, and park without success. There was no traffic ahead on the intersection or traffic on the left or to the right approaching as I made a right turn. The suburban slowed down on its own to a safe speed where I could turn into a driveway off the busy road. I'm not sure what to do with this vehicle. The mechanic tells me that it will cost over 1000 to fix it.
Questions about the 2000 Chevrolet Suburban 1500 brakes
Does the 2000 Chevrolet Suburban 1500 have brakes problems?
Owners have filed 47 complaints about the brakes of the 2000 Chevrolet Suburban 1500, 70% of all its complaints, more than any other problem.
At what mileage do 2000 Chevrolet Suburban 1500 brakes problems start?
The typical (median) mileage in owner complaints is 133,652 miles.
Was there a recall on the 2000 Chevrolet Suburban 1500 brakes?
There is no recall for this problem on this model year.
What year does the Chevrolet Suburban 1500 have bad brakes?
The Chevrolet Suburban 1500 model years with the most brakes complaints are 2002 (66 complaints), 2003 (65 complaints) and 1999 (50 complaints).
Other 2000 Chevrolet Suburban 1500 problems
Fuel system 4Tires 3Engine 2Seat belts 2Seats 2Airbags 1Electrical 1Steering 1Transmission 1Visibility 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 2000 Chevrolet Suburban 1500?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history