1997 Chevrolet Suburban: ABS light or ABS activating

Filed Mar 9, 2006 · Fuel system · 98,000 miles · IL · fire

1997 chevy suburban in-tank fuel sending unit fire: bought vehicle used with 88000 miles. Events leading up to the failure / burn up of the unit included intermittent fuel pump and fuel gauge failure, had pump replaced by patrick gmc, problem persisted, had dealer wolf chevrolet check fuel pressure throughout system (ok). Also noticed an intermittent burning smell. I then purchased from the dealer a replacement sending unit and another fuel pump, as soon as I took the sender out of the tank it was obviously charred and the modular connector burnt to a crisp, wires completely exposed with the insulation gone partially disintegrated the ABS plug. This thing got really hot repeatedly. The lower explosive limit was luckily never reached within the tank or there could have been a spontaneous explosion, especially if the tank lost its seal and allowed outside air inside, (such as when the tank is empty and is pulling vacuum), for instance unscrewing the gas cap in ideal conditions next to a gas pump with a 44 gallon tank void sucking in as much oxygen in as the filler tube will allow, and hitting that glowing red hot sending unit. Old part is in my possession and is the original factory sender. Incident date is approx. When I performed the repair and discovered the burned up sender.

Filed Feb 24, 2006 · Brakes · 153,000 miles · OH

Dt*: the contact stated the vehicle was having ABS problems. While applying the brake pedal to stop at slower speeds the ABS activated causing greater stopping distances. There is a the federal safety agency recall, # 05v379000, regarding the ABS. The vehicle has the same problems as indicated in the recall; however it is not included in the recall due to the year of the vehicle. Repairs have been made and the manufacturer has been alerted.

Filed Jan 29, 2006 · Brakes · 58,000 miles · VA

In july/august 2005 I began experiencing activation of the ABS at very low speeds of 5-10 MPH in 1997 chevrolet suburban. I took the car to repair shop and found out that the front brake units, calipers, etc., were corroded and needed to be replaced. I did this. Also ,found out that the ABS units were not reading the speed correctly and this was causing the ABS bumping at low speeds. Advised they should be replaced at cost of $1200! In january 2006 I read about the suburban recall for malfunctioning ABS and unusual corrosion of brakes. Unfortunately, the recall started for 1999 models. I believe my 1997 vehicle has the same problem. I contacted the local chevrolet dealer where I bought the vehicle, but was told it was not covered by the recall and they recommended the ABS units be cleaned and that they will function properly. The other repair shop (who did the brake repairs) recommended against cleaning"and said in their experience this doesn't work. Suburban has only 61,000 miles, so it has not been over used. I put about 6,000 miles a year on it, mostly for pulling a horse trailer and for this I am very concerned about safe braking. I believe that this 1997 suburban has the same problem as the 199s. I've spent about $500 on the brake repairs so far and the ABS will cost me another $1200. For a vehicle that gets so little use by me, this is a lot of money. I would like the 1997 to be included in the recall. I am upset by the expense of repairing these apparent manufacturing flaws.

Filed Oct 19, 2005 · Brakes · PA

Dt: the contact owns a 1997 chevrolet suburban. She received recall 05v379000 notice for a 2001 chevrolet silverado regarding the ABS system. The contact stated that the 1997 chevrolet suburban is experienced the same ABS brake problem as indicated in the recall. When the brakes were applied it seemed as if the ABS system was kicking in, and there was extended stopping distance. It did not matter what the road conditions were this would happen even on dry roads. The service dealer did stated that the sensor in the vehicle needed to be replaced. The manufacturer has not been contacted.

Filed Oct 19, 2005 · Brakes · 75,044 miles · IN

Dt: the contact was driving at a low speed and applied brake pressure and the ABS pulsated. There was extended stopping distance as indicated in a current recall on the anti lock brakes. The vehicle was taken to a dealer who replaced both wheel speed sensors on the front brakes. That corrected the problem ,however, in august of this year the problem recurred two years later. The vehicle was returned to a dealer. The dealer did replace one of the wheel speed sensors, but the other one was cleaned and kept on the brakes. Since this repair there have been no further problems. The contact contacted gm, and filed a complaint. This vehicle was not included in the recall due to the VIN and the model. *ak updated 11/29/05.

Filed Sep 27, 2005 · Brakes · 100 miles · WI

Abs brakes problems on my 1997 chevy tahoe 4dr 4-wheel drive. The brakes have been terrible since I obtained this vehicle when it was brand new. They would grunt & groan, skip and act erratic. On ice and snow, I would actually go faster when I would apply the brakes and slide much faster than a car with regular brakes. On dry roads at slow speeds in town driving, the brakes didn't seem to take hold all the time. There would be a delay action when applying the brakes. I almost rear-ended other vehicles three times, through no fault of my own. I hate ABS brakes and would like to buy one without it. Abs brakes systems are very dangerous, especially on this 1997 chev tahoe 4-wheel drive. I checked with mechanics and they all say that's just ABS brakes, and I have to put up with it. This is wrong as they are a very real danger. I have to be extremely careful allowing substantial distance between vehicles and then its not safe. I think I have a lemon and know there are lots of other complaints about it around here. How about a little help with recalls and a new vehicle?

Filed Aug 31, 2005 · Brakes · 105,000 miles · OH · crash · 1 injury

Dt: the consumer states 1997 chevrolet suburban has brake problems. This resulted in a crash, and there were only minor injuries. The brakes just started having problems for a couple of weeks. Before the consumer could get a chance to have the brakes checked, had an accident. The brakes were checked and fixed after the accident, and the mechanic at the dealership told the consumer that this was very common with corrosion build up. The consumer had to pay $1300.00 to fix the braking system. Prior to the accident the brakes were losing power, and it was difficult to stop. This was an intermittent problem. The consumer contacted gm about the problem with an e-mail, with no response. The consumer lives in a salt-belt state. The mechanic stated that there was a corrosion build up on the ABS sensor. A police report and an insurance report were taken. The speed was around 20 MPH.*ak updated 1/4/2006 -

Filed May 13, 2005 · Brakes · 45,000 miles · MA

When I apply the brakes to my 1997 chevy suburban, the ABS kicks on and pulsates extending the stopping distance tremendously. There has been a recall on this for recent year suburbans, but not as far back as the 1997 model.

Filed Dec 21, 2002 · Brakes, Electrical · DC

Abs failure, electrical failure and front and rear brake failure. This correspondence is not available via .I believe the letter may have been misplaced while in transition from dimms to artemis via tran tech employees. The power windows and air condition failed. There was a violent gear change between 2 wheel drive and 4 wheel drive. The battery leaked and also the cables were corroded, there was a loud noise from the steering column, the consumer experienced complete steering failure while making a left turn.

Filed Sep 2, 2002 · Brakes · OH

Faulty ABS system with sensor caused loss of braking capability at slow speeds resulting in extended stopping distance. Nlm

Filed Sep 10, 2001 · Suspension, Transmission · MI

The transmission shifted very hard and make a loud "clunking" noise when shifting into forward gears after about the first 100 miles. It was taken in twice while still under warranty and I was told there was nothing wrong with it. The third time I took it in it was getting extremely bad, it was now out of warranty, and I was told I needed a new transmission. The front end has been aligned twice within 15,000 miles and still pulls hard to the right. The ABS system has failed periodically over a six month period of time - it was reported three times. The third time they finally discovered that the sensor module on the front hub was defective.

Filed Dec 18, 2000 · Brakes · WI

Abs engages at slow speed in normal driving conditions and occasionally following braking when cornering. Decrease in braking distance also noticed as it feels as if slipping occurs in brakes. Grinding noise also attendant to this situation. Dealer service replaced sensor and hub assembly. Brakes had been replaced previously at 70,000 miles, which I consider too early on this vehicle.