2013 Chrysler 200 electrical problems

Filed Jun 4, 2026 · Electrical, Fuel system · KY

The horn will honk sporadically and will not start at times then wipers will malfunction. Had tipm looked at was told it is normal for this to go out, bad design.

Filed Mar 26, 2026 · Airbags, Electrical · 120,000 miles · MI

The contact owns a 2013 Chrysler 200. The contact stated that while driving at an undisclosed speed, the passenger’s side air bag unexpectedly deployed without the vehicle being in a crash. There was no warning light illuminated. Due to the failure, the passenger’s seat became inoperable and could not be adjusted or properly positioned. The dealer was contacted, but the vehicle was not diagnosed or repaired. The contact was informed that the vehicle would not be repaired due to a previous repair completed under the federal safety agency Campaign Number: 13V282000 (Electrical System, Air Bags). The manufacturer was made aware of the failure. The approximate failure mileage was 120,000.

Filed Aug 5, 2025 · Electrical, Engine · FL

I started having the oil pressure warning light come on same day after an oil change. It was a 3-hour drive, and the light will come on while my foot is on the break. Oil level was in the safe marker. Then I started feeling rumbling like I was driving a stick shift car. One major incident I was waiting for my turn at a light and when it turned green, the car was stalling but went. All of sudden it stopped and cut off and wouldn't crank back up. When it did the light was red and cars were going around me. It was running hot but started back up for me to drive home. But it I stopped it shuts off. The inside lights do a weird thing like comes on randomly while driving and it's scary at night. Also, if using the left turn signal the lights comes on. But when the car is off the radio and other controls go bright then dim. When put on a code reader many codes come up P0506, P0137, P0171, P0131, P0302

Filed May 22, 2025 · Electrical, Fuel system · TN

Headrest popped out Radio goes blank or completely then comes back on Throttle body light comes on and stalks car after being replaced 2 times Gas cap light comes on after being replaced 4 times

Filed May 12, 2025 · Electrical, Engine · NC

While driving the car is in process.. the engine will suddenly stop (stall). I loose all power to the car and is unable to stop the car or control the speed or any other functions of the car. The only way to stop the car immediately is to manually use the emergency breaks. My 3.6 liter engine is having the same engine defect as the 2.4 2000 Chrysler 200 engine N52... causing it to malfunction. Also sometimes when trying to start the car while turning the key in the ignition the engine begin to flood on its on and get completely stuck in that position..and become unable to process to start and run. For about a year and a half I have been back and forth to the auto mechanic paying so much money trying to figure out what is going on with my car. Unable to fix of com up with a solution. My car has been more undrivable,in the shop and and unsafe then it has been driven. The last time I was driving my car with my [XXX] [XXX] child in the car the engine power failed and I was unable to stop .. we where coming on a 4 way traffic light going at full speed.. my light had turned red. Nothing I would do would stop or slow the car down. I'm so happy my child knows to pull the emergency breaks... He saved our life. This has happened multiple times B4 this last time but never to this extent. It seems the longer this issue is going the worst it's becoming. I began doing research on Chrysler 200 to see if anyone one else may have been having this issue to hopefully find a solution. because this is my only car and I have put everything I have into this to get this car and to fix this car.. when I looked in to recalls I found that the 2.4 liter engine for the 2000 Chrysler 200 was having the same engine defect as my 2013 Chrysler 200 3.6 liter engine.. . So I would like to make a vehicle complaint about my car's engine defect causing the engine to malfunction which is a safety issue. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Filed Jan 29, 2025 · Electrical, Seat belts · MI

Multiple issues, passenger window is a very common issue, looked on YouTube and found many videos for it was able to jump with direct power to the pigtail using wires and a battery and was able to roll it up but no explanation for why it ends up having this issue, heater core also a consistent issue, it is obvious with passenger side goes cold and 95% of the fix is a new heater core. Headrests popping, had the safety recall done 02chz28 (Recall S61) and never was mentioned or brought up by local dealer, both seatbelts are not functioning properly, passenger side is the worst, locks up and both are running along the plastic causing it to become deformed and wearing on the edges of the belts. Vehicle has obvious replacements on the front but no accident history. Hood is a different vin number and grill is not original from factory. I found the original photo of the car's first sale post. Odd malfunction is washer fluid can run out with no indicator being triggered for low fluid.

Filed Oct 3, 2024 · Electrical, Engine · AR

Car shuts down suddenly while driving causing the wheel to lock up and breaks unable to be pressed.

Filed May 11, 2024 · Electrical · NY

Got my 2013 Chrysler 200 limited in March 2022 , car would stall and lose power about a couple times a week , took to garage they said it was the psm either had to be replaced or reset , but soon after that my heat stopped working on passanger side blew cold and driver side blew earm , now back on to the stalling , my fiance noticed when checking things under hood that the battery was grounded on top but he said from where it's grounded they should have never painted it , but cleared paint off area and corrosion off the battery terminals and areas and My car has not stalled out again

Filed Apr 18, 2024 · Airbags, Electrical · GA

The Active Headrest Restraint (AHR) failed. It deployed without cause and was inspected by the dealer. The issue was a small piece of plastic used in the manufacturing process. My wife was driving the car and out of nowhere a loud noise and she was struck in the back of the head. Luckily, she was driving at a slower speed and no other cars were around, she nearly went completely into the other lane. Had other cars been on the road, there would have been an accident. We took the car to the dealership when it happened with the passenger headrest a couple of years ago and the guy told us he ordered the parts to fix it, but it would take six months. We went back and he no longer works there an never ordered any parts. Since only my wife drives this car, we just let it go about the passenger headrest and moved on. I believe this is in regards to recalls S61 & T56. Both headrests are deployed and cannot be reset. To make matters worse, now the airbag warning light is illuminated at all times. An issue with airbags can be very serious and very dangerous if not addressed. After speaking on the phone with FCA customer care, I was told this was fixed in 2014 (2-3 years before the recall was issued) & that it was out of warranty. I do not believe it was fixed, maybe someone inspected the car, but it was not repaired. The dealer wants to charge me $1,000 to replace the headrests and that is something I cannot do. The recall site states "Safety recalls include any problem encountered with an FCA US LLC product related to the safe operation of the vehicle or the safety of the occupants. FCA US LLC will correct the problem, at no charge, even if the vehicle is out of warranty and you are not the original owner." this clearly does not matter to Chrysler. I have no other choice but to drive the vehicle with the airbag warnings on. I am hoping you can help. This is my last resort. It has not been inspected by the manufacturer and there were no warning lights prior to this.

Filed Mar 4, 2024 · Airbags, Electrical · 172,000 miles · MI

The contact owns a 2013 Chrysler 200. The contact stated that while driving at an undisclosed speed, the vehicle inadvertently lost motive power. The contact was able to pull to the shoulder of the roadway, where the vehicle was able to be restarted. Several unknown warning lights were illuminated. The vehicle was not taken to the dealer or an independent mechanic. The vehicle was not repaired. After investigating the failure, the contact related the failure to the federal safety agency Campaign Number: 13V282000 (Electrical System, Air Bags), but the VIN was not included. The manufacturer was not notified of the failure. The failure mileage was 172,000.