2000 Chrysler 300M wheels problems

Filed Jan 14, 2016 · Tires, Wheels · 128,000 miles · PA

Tl* the contact owns a 2000 chrysler 300m equipped with uniroyal, tire line: tiger paw, tire size: 225/55r1797j, and dot number: y900fpuu. The contact stated that while driving 25 MPH, the seal between the rim and the tire separated causing loss of air to the tire. It was unknown the location of the tire that failed. The vehicle was taken to a dealer where an unknown repair was performed but the failure recurred. The manufacturer was made aware of the failure. The failure tire and vehicle mileage were 128,000.

Filed Jul 31, 2015 · Steering, Suspension · 14,000 miles · WA

While turning a corner my steering wheel turned one direction while my tires stayed straight. Also while driving down the highway at 45 miles an hour. My car went into the opposite lane almost head on into another vehicle when my wheels decided to turn back when I turned the steering wheel almost to the end of steering ratio. This car is going to end up killing someone. Then there will be a major law suit. I replaced the rack & pinion. Worked for about a month and now it is starting to do it again. Also replaced the tie rod ends. The bolts back out or become loose on the rack & pinion. Have had to tighten them on many occasions.

Filed Oct 23, 2010 · Wheels · 80,000 miles · MI

The wheels on the 2000 chrysler 300m are chrome plated, which leads to slow leaks inside the wheel well. I have had to replace the tires twice due to abnormal wear and tear directly related the chrome issue. Also, the I must re-inflate the tires twice a week to ensure that the car is road-worthy. This has LED to multiple dangerous driving conditions and is a complete nuisance. I have had the wheels ground both times I replaced the tires to try and resolve the issue, but it persists and does not matter what type of tires I put on the car. There was no incident, and the problem seems to be a known issue among automotive people.

Filed Mar 3, 2010 · Wheels · 50,000 miles · NC

Chromed wheels on 2000 chrysler 300m corrode such that safe tire pressures can not be maintained. Even new performance tires (as suggested by chrysler) do no hold pressure.

Filed Oct 1, 2009 · Tires, Wheels · 90,000 miles · MA

This is the second time one of my tires came off the rim while driving. I have to check the air pressure every other day, as it is always low. This is a safety hazard that chrysler refuses to address. I have 17" chrome rims.

Filed Nov 13, 2008 · Wheels · OH

There is serious corroding and pitting on the rims. The rims leak 15 to 25 psi depending on the weather. Potentially fatal if not noticed before driving on freeway. Took to dealership and was told it was a very common with the type of rim used on chrysler models. This problem has persisted since I bought the vehicle in 2002.

Filed Oct 1, 2007 · Wheels · 87,200 miles · MI

I have a 2000 chrysler 300 m that has chrome/aluminum wheels. About 8 months ago I noticed that I was losing substantial pressure in my tires on a regular basis. Thinking this was a problem with the tires, I took the car back to the store where I purchased the tires. Upon inspection, the service technician pointed out that my rims were corroding from the inside and that this affected the bead on the tire and caused it to lose pressure. He indicated that this was a "big problem" for chrysler cars and that the rims were "junk". I experience additional loss of pressure about every 5 weeks or so and have taken the car back to the tire dealer three times. Each time they point to the corrosion and their frustration with chrysler not dealing the problem. After the last incident I contacted a local chrysler dealer and spoke to one of their service technicians. When I explained the situation he said that it was a known problem and that other chrysler vehicles had the same issue, including the pt cruiser. He said that there was no recall and that chrysler was not allowing them to do anything about it other than grind down the corrosion and remount the tire, at the owners' expense. This is unacceptable. Having tires lose pressure because of a defect in the design and performance of the wheel is a clear safety hazard. I hope the federal safety agency will look into this and require chrysler to stand behind its product. Thank you.

Filed Nov 18, 2005 · Tires, Wheels · 24,900 miles · OH

2000 chysler 300m. Myself and two neighbors have had this same problem numberous times this year. We are finding that the wheels are rusting/peeling and causing the seal on the tires to break, thus, causing constant flat tires. We've all had the wheels cleaned and re-sealed numerous times but feel this is a real safety hazard let alone a concern of owners finding flat tires all the time. Our dealer indicated no recalls have been made and that there were some problems with the manufacturer of the wheels. That's it....we'd love to have these wheels replaced at no cost to us since they are expensive. Any information would be greatly appreciated as to what we as owners (3) can do about this.

Filed Oct 14, 2005 · Tires, Wheels · 30,000 miles · MI

Dt: the tire rims will not hold air because the chrome plating pealed off the stainless rims. The consumer contacted the dealer, they said the consumer would have to replace them by himself. This started on august 24, 2004. Originally, the consumer thought a nail was in the tire. Took vehicle to the dealer and the service manager said it was a common complaint. Every other day had to fill up to 15 to 20 lbs of air.*ak

Filed Jan 18, 2005 · Wheels · DC

2000 chrysler 300m tire equipment has been replaced twice.***no answer required***. *mr the vehicle two front tires, especially the right tire) went flat every 4-5 days. The tires were replaced twice but that did not stop the problem. It was then suggested that the wheels may be the problem.