1996 Chrysler Concorde brakes problems

Filed Aug 3, 2006 · Brakes · 40,000 miles · NC

Dt*: the contact stated while the vehicle slowed to a stop, the brakes began to vibrate and the pedal depressed to the floor. At 5 MPH the ABS engaged and stopped the vehicle. The problem was intermittent and occurred 40 times in the last two years. The manufacturer was contacted and referred the contact to a service dealer. An independent service mechanic inspected the vehicle and also determined, the brakes needed to be serviced by an authorized dealer. The ABS engage at a low speed for no apparent reason. Updated 08/23/04.

Filed Jan 11, 2005 · Brakes · FL

While driving stepped on the brake and heard a popping noise. There was smoke, the brake line had broken, a fire almost started however, the consumer had turned the vehicle off in time.

Filed Aug 9, 2003 · Brakes, Engine · 144,000 miles · MI

Steering is very bad. Pulls to the left. Rack and pinion bushings bad, as well as a tie rod. Usually makes a popping noise when turning. Engine cooling system has malfunctioned. Continues to overheat. Replaced water pump twice as well as thermostat. Abs light continues to come on. Brakes are very bad. I've replaced them numerous times.

Filed Jul 3, 2002 · Brakes, Steering · PA

Consumer states the right front strut was replaced, the right rear strut was leaking, also there was a clunking noise coming from the steering, the dealer replaced the front sway bar.

Filed Oct 31, 2000 · Brakes · OH

Abs failed while the gear shift was moved from reverse to drive.

Filed Oct 20, 2000 · Brakes · OH

When depressing brake pedal pedal went to the floorboard without any indication. Failure occured in parking lot.

Filed Jun 26, 2000 · Brakes, Fuel system · LA

Air conditioner evaporator and o-rings replaced.

Filed Apr 12, 2000 · Brakes · CD

The brake pedal travels to the floor when the engine starts up, the ABS system responds only after the brake pedal is on the floor, the master cylinder was replaced but this condition still exist. Nlm

Filed Jan 25, 2000 · Brakes · MI

Continuing lack of braking "power" I.e. Pedal is on the floor and there is not enough braking force generated to cuase the anti-lock brakes to actuate ,even on wet pavement, causing longer stopping distances and some real tense moments. Deale has tried replacing several components with no result and I'm getting worried that evntually ther will be an accident caused by lack of braking ability in what should have been a no-problem, routine stop. There have been other complaints from other chrysler owners showning same behavior- these appear in chrysler lhs's and new yorkers which are essentially the same vehicles under the skin.

Filed Nov 22, 1999 · Acceleration, Brakes · PA

Ever since the car has had 7,000 miles on it the engine stalls when I am at ared light it will rev. Up shuder then stall it starts rightup again I have had it in the shop many times they can't find anything or they cleaned throtle body assembely,fixed a vacuum hose , adjusted the codes I call the car company even hade a co-piolt in there just guesting also the power steering pump was replaced the car was only 1year old and some times when the stalling problem happens the brake pedal go all the way down to the floor.