Check a VIN

Chrysler Concorde pulling problems

14 of the 2,214 owner complaints about the Chrysler Concorde describe pulls to one side, most of them for the 1996 model year.

owner complaints
14
worst model year
1996
Is there a fix? No recall or service bulletin covers this area of the car yet.

By model year

  • 1999
    1
  • 1998
    1
  • 1997
    2
  • 1996
    6
  • 1994
    3
  • 1993
    1

What owners say

Filed Aug 3, 2005 · Body, Suspension · MS

The consumer noticed that car seemed to be pulling to the left/right. The consumer heard something pop and rattle and then parts started falling from the vehicle on to the highway. The consumer purchased more parts and they failed. The consumer took the vehicle to mechanic who determined the transmission fluid line was leaking . Another mechanic stated that the front end was coming part and was loose. The frame was loose and nothing was holding it together. After replacing all the parts, the consumer received a recall notice. Took it to dealer and they told her that they fixed the problem. But, didn't tell her what the problem was, but now problem is worse. Car was jumping like it didn't shift into gear. Transmission feels like it's slipping. Contact called the federal safety agency last week and talked to a lady and was told to replace the power steering fluid line. Bought piece of line and was told to buy a vacuum pipe.

Filed Sep 8, 2004 · Brakes · FL

Brakes pulsated when applied, and vehicle pulled to the right. Consumer drove vehicle to the dealer for inspection, and mechanic determined that ABS braking system needed to be replaced.

Filed Nov 15, 2003 · Steering · 46,000 miles · NC

I have a 1996 chrysler concorde lxi. My brother in law has one the same year and model also. We both have the same problem. The steering gear bushings wear out and allows the steering to wander. I have come very close to having an accident as well as my brother in law while going around a corner and expecting the car to follow the direction of steering but instead the car wanted to go straight until the steering gear had traveled as far as it could go then the steering reacted. This problem also causes excessive vibration in the front end leading a mechanic to believe the rotors are warped when in fact it is the steering gear bushings. These bushings are not available through chrysler. Instead they want you to purchase a whole new steering gear for over $1000. It appears to me that this problem is very common to the 1996 chrysler concorde lxi and chrysler should either make the part available to remedy the problem or replace the part at there own expense. This is one of those problems where someone may drive off the road and get hurt or killed and no one will ever know why other than to expect that it was the drivers fault.

Filed Aug 9, 2003 · Brakes, Engine · 144,000 miles · MI

Steering is very bad. Pulls to the left. Rack and pinion bushings bad, as well as a tie rod. Usually makes a popping noise when turning. Engine cooling system has malfunctioned. Continues to overheat. Replaced water pump twice as well as thermostat. Abs light continues to come on. Brakes are very bad. I've replaced them numerous times.

Filed Jul 25, 2003 · Steering · 60,000 miles · PA

Vehicle is very difficult to steer, it will continuously pull to the left/right. Dealership indicated that rack and pinion steering was coming apart at the mount.

Filed Feb 5, 2001 · Suspension · IL

Major pull to right. 2nd alignment problem in 10k miles. Dealer reports worn tie rod end. Other complaints to same problem and tsb's. Dealer refuses to replace at n/c. 2nd tire needs to be replaces.

Filed Oct 10, 2000 · Steering · MI

Car started pulling to the left and ABS warning light comes on periodically, upon further inspection I found that both tie rod ends are wore and very sloppy. Chrysler garage said that these are not recall items and that I will have to pay for repairs.

Filed Sep 14, 2000 · Steering · LA

Because vehicle would wander all over the road while drivng at any speed, it was taken to dealership. At the dealership, both tie rod ends were replaced. One of tie rod bushing was gone, and the other bushing was worn out. *ak the owner of the vehicle states that it is unusual for the tie rod to wear prematurely and thinks it is a defect in the front end that caused it.

Filed Jan 19, 2000 · Suspension · AR

When traveling at highway speed around or about 50-60 MPH vehicle pulled to the left, causing poor steering control. Consume has contacted the dealer, dealer noticed tsb for the same type of problem. Dealer corrected the problem by installing a small bolt to support the large bolt struts. Consumer still having problems. Please provide any further details.

Filed Dec 16, 1999 · Suspension · OH

Problem: vehicle wanders and requires constant corrective steering input from the driver. No matter what the road condition( wet/dry/flat/crowned), the car will " drift" and or pull to the side with out any apparent pattern, consequently, intense concentration is required to drive this vehicle. Also, the effort to steer right/ left is variable, again with out a pattern. The car is not equipped with speed-sensitive steering. According to the dealer's service records, the previous owner had the same difficulty. The tires have been rotated on a regular basis; the front brake assemblies have been replaced, and I have precisely adjusted the tire psi all to no avail. I had a 1996 eagle vision that had similar problems, though I did not report it. Please investigate.

Related recalls

No recalls on record for this model year.

Questions about the Chrysler Concorde pulling

Which Chrysler Concorde years have pulls to one side problems?

The model years with the most reports are 1996 (6 complaints), 1994 (3 complaints) and 1997 (2 complaints).

VIN decoder

See the problems and recalls for an exact car

Buying a used Chrysler Concorde?

Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.

Check its history