Tl* the contact owns a 1996 chrysler sebring. The contact stated that the vehicle accelerated without driver intent. She finally got it stopped by putting it in park, using the brakes had no effect. The manufacturer was contacted and they stated there was no recall on her vehicle. The failure and current mileages were approximately 200,000. The VIN was not available.
1996 Chrysler Sebring acceleration problems
19 complaints (6% of all complaints for this car). 3 crashes reported.
- owner complaints
- 19
- of this car's complaints
- 6%
- crashes
- 3
- recalls
- 1
Which part fails
- Cables5
- Accelerator pedal3
- Linkages2
At what mileage
Complaints by mileage at the time of the problem.
Chrysler Sebring acceleration problems in other years
Related recalls
Vehicle speed control
- What is wrong
- On certain passenger vehicles equipped with 2.5l v6 engines, the throttle control cable can fray causing the throttle to bind or stick.
- Risk
- This could potentially result in a loss of throttle control, increasing the risk of a crash.
- Remedy
- Dealers will replace the throttle cable assembly. Owner notification began august 5, 2002. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact daimlerchrysler at 1‑800‑853‑1403.
Recall number 02V186000 · Recall details
What 1996 Chrysler Sebring owners say
Most recent owner complaints, unedited.
The throttle cable failed which caused the vehicle to accelerate at a high speed.
Consumer stated the throttle sticks, the throttle cable was frayed and the throttle cable/body gasket was removed and replaced. The consumer requests reimbursement, and feels that he was given wrong information from the dealer.
Dealer taking to long to perform recall. Recall#02v186000 throttle control cable. Brockmen automotive 2730 laurens rd greensville, sc 29607 864‑281‑1500.
Consumers son and grand daughter were travelling aprrox. 60 MPH. The accelerator was released but the vehicle remained at 60 MPH. The brakes were applied and the vehicle only slowed to 55 miles per hour. Upon releasing the brake the car sped to 65 MPH with no mechanical acceleration. Brakes would not slow the vehicle down. When the floor accelerator was released the rpms reved and the speed stayed the same. Smoke began to emit from the tires. The speed was steadily rising. Vehicle was shifted into neutral and turned off.
Had received recall notice 02v186000 for throttle. Contacted dealership, and set up an appointment. Took vehicle in for repairs on throttle cable. Was informed by mechanic after arriving, that no parts were available. Parts for throttle cable were on back order. Delucka chrysler/plymouth, bedford, ohio 44146, 440‑232‑0880.
Cable connecting gas pedal to engine frayed and stuck at full throttle. Brakes did not work. Was traveling in rush hour traffic at full speed two times. The first time repeated stomping on the gas pedal and brake pedal and throwing the car into neutral unjammed it after a couple of minutes. The second time also in rush hour traffic these efforts did not help. I wove in and out of traffic until I got to an off ramp, and luckily was able to get through the traffic light at the intersection at the off ramp and onto a sidestreet where I put it into neutral and landed it like an airplane on a landing strip with the brakes smoking and the engine screaming and the car glided to a stop. Was told the cable had unwound like a frayed piece of rope and stuck inside the cable connecting the pedal to the engine.
Accelerator stuck at 60 MPH and it was due to a frayed cable. Chrysler dealer said that it happened to most of the sebring conv. The current cable is discontinued from chrysler and a new throttle body must be purchased for the new cable to be installed. Dealer said that a new aftermarket replacement cable would be unsafe due to its design and are forbidden to install anything but the new "safer" cable.
Consumer was driving 35-40 MPH and took foot off accelerator pedal to slow down, accelerator pedal was stuck, and vehicle kept moving. Consumer went through an intersection, and was hit by another vehicle. Consumer was not injured. Damage to vehicle was $ 5422.00. Chrysler investigator will look at vehicle.*ak chrysler sent consumer a letter stating that the throttle system was thoroughly inspected and all cables and levers were found free and moving without any restrictions, they also found no stored or active codes in the system.
Was driving 60mph when accelerator pedal became stuck. Speed increased uphill. Turned vehicle off. Checked throttle cable which was frazed. Inside housing wires were together. Clipped wires & pieces & able to continue. Took vehicle to dealership & mechanic replaced cables. Was informed throttle was changed. Mechanic would not give original parts after replacing parts. [xxx] *ak information redacted pursuant to the freedom of information act (foia), 5 u.s.c. 552(b)(6).
Questions about the 1996 Chrysler Sebring acceleration
Does the 1996 Chrysler Sebring have acceleration problems?
Owners have filed 19 complaints about the acceleration of the 1996 Chrysler Sebring, 6% of all its complaints.
At what mileage do 1996 Chrysler Sebring acceleration problems start?
Not enough complaints include the mileage to tell.
Was there a recall on the 1996 Chrysler Sebring acceleration?
Yes, 1 recall: 02V186000. Check your VIN to see if your car still needs the free repair.
What year does the Chrysler Sebring have the most acceleration problems?
The Chrysler Sebring model years with the most acceleration complaints are 2007 (40 complaints), 2008 (34 complaints) and 1998 (23 complaints).
Other 1996 Chrysler Sebring problems
Suspension 70Brakes 54Transmission 47Engine 41Body 39Electrical 37Airbags 31Visibility 27Seat belts 16Steering 13Wheels 7Fuel system 6Tires 5Lights 4Locks 3Seats 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 1996 Chrysler Sebring?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history