Tl* the contact owns a 1996 chrysler sebring. While driving approximately 45 MPH, the vehicle failed to respond when the brake pedal was depressed. The contact crashed the vehicle into a ditch. There were no injuries. The independent mechanic repaired the brake chamber, both rear brake lines, and the adjuster; however, the failure persisted. The manufacturer was not notified of the failure. The failure mileage was unavailable.
1996 Chrysler Sebring brakes problems
54 complaints (16% of all complaints for this car). 6 crashes reported.
- owner complaints
- 54
- of this car's complaints
- 16%
- crashes
- 6
- recalls
- 1
Which part fails
- Antilock/traction control/electronic limited slip16
- Foundation components12
- Foundation components: disc11
- Foundation components: disc: rotor7
- Power assist3
- Foundation components: disc: pads3
- Foundation components: master cylinder1
- Foundation components: hoses, lines/piping, and fittings1
At what mileage
Complaints by mileage at the time of the problem.
Chrysler Sebring brakes problems in other years
Specific symptoms reported on the 1996 Chrysler Sebring brakes
Phrases found in the owners' own descriptions, so one complaint can mention several symptoms.
Related recalls
Service brakes, hydraulic: power assist
- What is wrong
- The power brake booster vacuum hose was improperly installed on the intake manifold vacuum nipple.
- Risk
- A disconnected vacuum hose causes an increase in engine idle speed and loss of power assist during brake application increasing the risk of a vehicle accident.
- Remedy
- Dealers will fully install the intake manifold vacuum hose to the vacuum nipple on the intake manifold.
Recall number 96V123000 · Recall details
What 1996 Chrysler Sebring owners say
Most recent owner complaints, unedited.
On the engine I had the pulley on the timing belt come apart and just last month I had the head gasket start to leak from the back. Timing belt 28,000 head gasket 37,500. I have had to replace all 4 tires that where on the car. All by 29,000 miles--some earlier and then later. The brakes were replaces at the same time as the timing belt pulley. I knew they needed replacement and had an appointment to get them replaced when the timeing belt went out. It is a 1996 but I only have 37,500 miles.
When applying brakes on dry pavement at 40 MPH, vehicle vibrates, vehicle swerves and the brake pedal gets hard. Took to dealer and dealer stated there is a short in the left front solenoid circuit. Ts
Consumer stated while driving, the right front ball joint came completely out of its socket, causing the right front tire to turn side ways, consumer was informed by represenative from the corporate recall 800# that consumer was entitled to a refund, consumer is now requesting payment in full.
When brakes are applied front end will vibrate. Please provide additional information.
Cable connecting gas pedal to engine frayed and stuck at full throttle. Brakes did not work. Was traveling in rush hour traffic at full speed two times. The first time repeated stomping on the gas pedal and brake pedal and throwing the car into neutral unjammed it after a couple of minutes. The second time also in rush hour traffic these efforts did not help. I wove in and out of traffic until I got to an off ramp, and luckily was able to get through the traffic light at the intersection at the off ramp and onto a sidestreet where I put it into neutral and landed it like an airplane on a landing strip with the brakes smoking and the engine screaming and the car glided to a stop. Was told the cable had unwound like a frayed piece of rope and stuck inside the cable connecting the pedal to the engine.
I have had so many problems with this car. The car looks very nice on the outside but has many issues on the inside. This car has cost me a fortune since my warranty went out at 75,000 miles. I have replaced brakes, rotors, and drums almost every year. This is very costly (over $350 every time). My transmission failed on me twice, once under warranty and the other without a warranty. I spent over $1,000 for repairs to replace a gasket, o-ring, and transmission pump. My o2 sensor failed twice. When I try to adjust my mirrors with the button on the driver side, the mirrors won't respond at all. I constantly hear a knocking noise from the engine. The service advisors at the dealership continue to tell me that chrysler cars sounds like that. That's normal. All the tings I have shared with you are just some of the things I have experieced. In my opinion, this car will put you in a bad financial situation. It's not worth the trouble. I traded mine for a more reliable car (a german car).
Front disc rotors warp within 3,000 miles of repair causing poor braking control at 40+ MPH. Caused by bad brake design. Also ABS module failed at 90,000 miles , leaving no ABS implementation on vehicle.
Abs light illuminated, dealer has replaced the ABS modulator 2 times and it has only lasted for 2 years.
Consumer has had several problems with vehicle. Brakes do not work, they grind and the pads keep wearing and have to be replaced, dealer stated the problem was with the calipers. Water is leaking into the vehicle due to sunroof being cut too short during recall 99i004, consumer feels there might have been previous problems with water leaking due to a rusted fuse. Speedometer does not work. There is a transmission leak. Air conditioner does not work. Engine light is illuminated. Windows still don't work properly. Mirrors do not work properly after recall 97v015. Vehicle gets poor gas mileage, dealer stated the spark plugs were burnt and fouled, spark plug wires were breaking down and arcing in tubes causing a build up in the throttle body.
Questions about the 1996 Chrysler Sebring brakes
Does the 1996 Chrysler Sebring have brakes problems?
Owners have filed 54 complaints about the brakes of the 1996 Chrysler Sebring, 16% of all its complaints.
At what mileage do 1996 Chrysler Sebring brakes problems start?
Not enough complaints include the mileage to tell.
Was there a recall on the 1996 Chrysler Sebring brakes?
Yes, 1 recall: 96V123000. Check your VIN to see if your car still needs the free repair.
What year does the Chrysler Sebring have bad brakes?
The Chrysler Sebring model years with the most brakes complaints are 1996 (54 complaints), 1995 (35 complaints) and 1998 (35 complaints).
Other 1996 Chrysler Sebring problems
Suspension 70Transmission 47Engine 41Body 39Electrical 37Airbags 31Visibility 27Acceleration 19Seat belts 16Steering 13Wheels 7Fuel system 6Tires 5Lights 4Locks 3Seats 1
VIN decoder
See the problems and recalls for an exact car
Buying a used 1996 Chrysler Sebring?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history