Pressed brake ABS kicked in and would not stop. Clear day, dry clean road, and no skidding. 3times in shop still a problem.
2000 Dodge Durango brakes complaints
Page 4 of 4: complaints 71 to 83 of 83, newest first, as owners wrote them.
Total brake failure at 30 MPH due to failure of master cylinder, which caused rear and front brakes to be inoperative. *ak internal leak at master cylinder.
When trying to stop, the brakes seem to grab and then the car slides and then the brakes would grab again. This has happened about 5 times and resulted in concern re: the safety of the brakes. Sometimes there is a clicking sound after this happens. Therefore the car was taken to the dodge dealer to have the breaks checked and no problem was identified. But on 4/7/01, when the brakes were applied, a loud roaring sound occured and the car continued to slide as if there were no brakes, which caused a collision into the rear of a vehical at a stoplight. The noise continued after the collision for about 30 seconds, followed by a strong burning electrical smell. The car was driven to a parking lot and has been driven home and does have braking action now.
Brake pedal became hard, resulting in extended stopping distance, and causing a collision. Dealer inspected vehicle.
While traveling at 75 MPH and when depressing brake pedal lightly vehicle went into a skid, extended stopping distance. Please provide further information.
The vehicle constantly drifts to the left and right while driving, the dealer performed a front wheel alignment but the consumer stated that the problem persisted, the dealer stated that the vehicle is operating as designed. Nlm
Brake rotors were warped and were resurfaced/ replaced. Transfer case went out due to making noise from metal chips. Vehicle was being repaired.
When depressing brakes pedal consumer heard grinding noise. Also, pulled to right. Dealer has been notified. Please provide further information.
I carried my vehicle to sears automotive shop to have my brakes checked because my brake pedal was spongy. The mechanics checked my truck and said my brakes were fine, but I had a bad master cylinder. They didn't touch anything, but they told me to take it to the dealer because it's under warranty. Carl gregory checked the brakes and came to the same conclusion, the master cylinder was bad. They ordered the part and it was in the next day. They put the new master cylinder on and my brakes are still spongy. My brake pedal continues to go almost to the floor before they start braking. I am still trying to get the problem fixed.
Brakes intermittently failed, resulting in one crash. Brakes would not grab, and did not stop vehicle. Dealer and independent investigator could not determine cause.
Consumer was in traffic and tried to slam on brakes because another driver in front had stopped, and consumer's vehicle would not stop, consumer stood on brakes, and vehicle still didn't stop.*ak depressing brakes to floor caused the engine to rev up to a higher idle RPM.
Due to defective brake retainer spring which came off and caused brakes to be loose/ fall and cracked the rim, and had no braking ability which may have caused a crash. Common problem. Dealer was aware of problem. Please provide further information.
Rear brake calipers seem to catch and pop constantly at low speeds without applying pressure to brake pedal.
VIN decoder
See the problems and recalls for an exact car
Buying a used 2000 Dodge Durango?
Check the exact car before you pay: accidents, salvage or flood titles, odometer readings and previous owners.
Check its history